Vector VEC012AP User Manual

Cut here

✄

TWO YEAR LIMITED WARRANTY PROGRAM

This limited warranty program is the only one that applies to this product, and it sets forth all the
responsibilities of Vector Manufacturing, Ltd., regarding this product. There is no other warranty, other
than those described herein.

This Vector Manufacturing, Ltd. product is warranted, to the original purchaser only, to be free of defects
in materials and workmanship for two years from the date of purchase without additional charge. The
warranty does not extend to subsequent purchasers or users. Vector Manufacturing, Ltd. will not be
responsible for any amount of damage in excess of the retail purchase price of the product under any
circumstances. Incidental and consequential damages are specifically excluded from coverage under
this warranty.

This product is not intended for commercial use. This warranty does not apply to accessories or damage to
units from misuse or incorrect installation. Misuse includes wiring or connecting to improper polarity
power sources.

RETURN/REPAIR POLICY: Defective products, other than accessories, may be returned postage prepaid
to Vector Manufacturing. Any defective product, other than accessories, that is returned to Vector
Manufacturing within 30 days of the date of purchase will be replaced free of charge. If such a product is
returned more than 30 days but less than two years from the purchase date, Vector Manufacturing will
repair the unit or, at its option, replace it free of charge.

If the unit is repaired, new or reconditioned replacement parts may be used, at Vector Manufacturing’s
option. A unit may be replaced with a new or reconditioned unit of the same or comparable design.
The repaired or replaced unit will then be warranted under the terms of the remainder of the warranty
period. The customer is responsible for the shipping charges on all returned items after 30 days. During
the warranty period, Vector Manufacturing, Ltd. will be responsible for the return shipping charges.

LIMITATIONS: This warranty does not cover accessories, bulbs, fuses and batteries, defects resulting
from normal wear and tear (including chips, scratches, abrasions, discoloration or fading due to usage
or exposure to sunlight), accidents, damage during shipping to our service facility, alterations, unau­thorized use or repair, neglect, misuse, abuse, failure to follow instructions for care and maintenance,
fire, flood and Acts of God.

If your problem is not covered by this warranty, call our Technical Support Department at [phone]
or toll free at 866-584-5504 for general repair information and charges if applicable. You may also
contact us through our website at www.vectormfg.com.

STATE LAW RIGHTS: This warranty gives you specific legal rights. Some states do not allow limitations
on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential
damages, so the exclusions or limitations stated herein may not apply. This warranty gives the purchaser
specific legal rights; other rights, which vary from state to state, may apply.

TO REQUEST WARRANTY SERVICE FOR THIS PRODUCT: Contact Vector Manufacturing Technical
Support by telephone, fax or mail. We suggest that you keep the original packaging in case you need
to ship the unit. When returning a product, include your name, address, phone number, dated sales
receipt (or copy) and a description of the reason for return and product serial number. After repairing
or replacing the unit, we will make every effort to return it to you within four weeks.

WARRANTY ACTIVATION: Please complete Warranty Activation Card and mail to Vector Manufacturing.
Enter “VEC012PC” as Model and Jump-starter /12V DC power supply as “Product Type”. All Vector
Manufacturing, Ltd. products must be registered within 10 days of purchase to activate this warranty.
Mail the completed registration form, along with a copy of the original sales receipt to:

ATTN.: CUSTOMER SERVICE / VECTOR MANUFACTURING, Ltd.

4140 SW 28th Way, Ft. Lauderdale, FL 33312

PH: 954-584-4446 • TOLL FREE: 866-584-5504 • Fax: [phone].

You may also contact us at our web site www.vectormfg.com.

WARRANTY MUST BE PURCHASED WITHIN 10 DAYS OF PRODUCT PURCHASE DATE.

WARRANTY IS NON-TRANSFERABLE AND NON-REFUNDABLE.

VEC012AP•ManuaL 12/02.qxp 12/20/02 5:07 PM Page i

Cut here

✄

VEC012AP

OWNER’S MANUAL &

WARRANTY INFORMATION

THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY, OPERATION, MAINTENANCE
AND STORAGE OF THIS PRODUCT. BEFORE USING, READ AND UNDERSTAND ALL CAUTIONS,
WARNINGS, INSTRUCTIONS AND PRODUCT LABELS, PLUS YOUR VEHICLE’S BATTERY MANUFACTURER
GUIDELINES. FAILURE TO DO SO COULD RESULT IN INJURY AND/OR PROPERTY DAMAGE.

4140 SW 28TH WAY, FT. LAUDERDALE, FL 33312

TEL: [phone] • FAX: [phone] • TOLL-FREE 866-584-5504

www.vectormfg.com

JUMP-START SYSTEM

12 VOLT DC POWER SUPPLY

VEC012AP•ManuaL 12/02.qxp 12/20/02 5:07 PM Page ii

1

CONTENTS

1. INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-5

2. USING VECTOR JUMPER AS A JUMP-START SYSTEM . . . . . . . . . 6

2.1 Easy, Step-by-Step Jump-starting Instructions . . . . . . . . . . . . . 7

3. CHARGING/RECHARGING . . . . . . . . . . . . . . . . . . . . . . . . . . 8-9

3.1 110/120 Volt AC Charging . . . . . . . . . . . . . . . . . . . . . . . 9

3.2 12 Volt DC Charging . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

3.3 Estimated Battery Life . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

4. OPERATING AS A PORTABLE POWER SUPPLY . . . . . . . . . . . . . . 9

5. EMERGENCY/WORKLIGHT . . . . . . . . . . . . . . . . . . . . . . . . . . 10

6. REPLACEMENT PARTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

6.1 Battery Replacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

6.2 Battery Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

7. SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10

8. WARRANTY

VEC012AP•ManuaL 12/02.qxp 12/20/02 5:07 PM Page 1

2

Safety information

WARNING:

(Warning statements identify conditions or practices that may result in personal
injury or loss of life)

1) When working with lead acid batteries, always make sure immediate assitance
is available in case of accident or emergency.

2) Always use protective eyewear when using this product: contact with battery acid
may cause blindness and/or severe burns, be aware of first aid procedures in
case of accidental contact with battery acid.

3) There is a risk of explosive gases being released when lead acid batteries are
being charged or discharged. Failure to follow instructions may cause property
damage, explosive hazard, and/or personal injury.

4) When connecting the battery clamps to a discharged battery, and an alarm
sounds - the polarity is reversed.

5) When charging unit from a 110/120 Volt AC electrical outlet in any wet or damp
area, make sure that the outlet used is protected by a ground fault interrupt
(GFI) Switch.

6) When charging the unit near water, do not allow the electrical cords and outlets
to get wet or come near water–electrical shock could result.

7) Jump-start procedures should only be performed in a safe, dry, well-ventilated area.

8) Always store battery clamps in built-in holsters when not in use. Never touch
battery clamps together, this can cause dangerous sparks, power arcing and/
or explosion.

9) When using this unit in proximity to the vehicle’s battery and engine, stand the
unit on a flat, stable surface, and be sure to keep all clamps, cords, clothing
and body parts away from moving vehicle components.

10) Do not wear vinyl clothing when jump-starting a vehicle, friction can cause

dangerous static-electricity sparks. Remove all jewelry or metal objects that
could cause short circuits or react with battery acid.

11) Always disconnect the negative (Black) jumper cable first: followed by the

positive (Red) jumper cable, except for positive ground systems.

12) Never allow red and black clamps to touch each other or another common

metal conductor–this could cause damage to the unit and/or create sparking/
explosion hazard. Always store battery clamps in built-in holsters when not in use.

13) Do not expose battery to fire or intense heat as it may explode. Before disposing

of the battery, protect exposed terminals with heavy-duty electrical tape to prevent
shorting (shorting can result in injury or fire).

14) Do not smoke or use inflammable items (matches, cigarette lighters, etc.) while

working on a vehicle’s battery system.

15) Keep unit out of reach of children (whether stored, or in use)!

FIRST AID

SKIN: If battery acid comes in contact with skin, rinse immediately with water, then
wash thoroughly with soap and water. If redness, pain, or irritation occurs, seek
immediate medical attention.
EYES: If battery acid comes in contact with eyes, flush eyes immediately, for a
minimum of 15 minutes and seek immediate medical attention.

VEC012AP•ManuaL 12/02.qxp 12/20/02 5:07 PM Page 2