Vax VS-19TS, VS-18TS, VS 183, VS 193 Easy Manual

2

3

c

e

a

f

g

i

1

2

3

Putting your cleaner together

Place the base of the cleaner so it
is facing away from you.
Position the body so that the lower
hose is on your right hand side.
Push the body down into place.

To secure the body in place insert
one of the screws supplied into the
back of the cleaner, through the
hole located above the on/off pedal.

Pull back the flap on the clear
window. Match the slots on the
hose to the tabs on the hose inlet.
Push down firmly on the cuff and
turn anti-clockwise to lock in place.

Phillips screwdriver required

Parts checklist

a Handle
b Canister release latch
c See through dust canister
d Lower hose
e Clear window
f Bumper bar
g Hepa filter
h Canister lid
i Main hose
j Cord clip

r

p

o

n

j

k Extension wand
l Carrying handle/ Cord wrap
m On/Off pedal
n Handle release pedal
o Cord wrap with quick release
p Power cord
q Crevice tool
r 2-in-1 Tool - Dust brush/ Upholstery tool
s Hose bracket

tTurbotool

b

d

h

k

l

m

s

q

t

r VS-19TS Swift manual op.qxd 7/15/04 7:59 PM Page 1

4

5

4

5 6

Putting your vacuum cleaner together

Align the holes in the tool holder,
with the holes on top of the body.

Use two of the screws supplied to
secure the tool holder in place.
Do not over tighten.

With the hose clip on the handle
facing you place it onto the top of
the body of the cleaner.

7

8 9

Putting your vacuum cleaner together

Push down firmly and line up the
screw hole on the rear of the handle.

Use one of the screws supplied to
secure the handle on the body.

Insert the small end of the main
hose into the tool holder on the
right hand side.

r VS-19TS Swift manual op.qxd 7/15/04 7:59 PM Page 2

6

7

10

11

12

Putting your vacuum cleaner together

Using the handle attach the main
hose into the left hand side of the
cleaner. Press down firmly to
secure in place. The main hose can
then be secured in the top and side
of the tool holder.

Push the canister lid firmly on top of
the dust canister and place it onto
the cleaner. The canister lid will
snap into place in the body of the
cleaner.

Attach the tools to the tool holder.
The 2 in 1 tool fits over a post at
the back of the vacuum cleaner.
The crevice tool fits into a round
slot on the rear right hand side of
the tool holder. The extension wand
hose on the left hand side.

1

2 3

Operating the vacuum cleaner

Plug the cord into an electrical
outlet and turn on by pressing the
on/off pedal, located on the back
left of the cleaner.

To unlock the handle from the
upright position press the handle
release pedal down.

Move the handle to the desired
position (A) for storage and position
(B) for normal operation.
To clean under furniture, press
the release pedal again and use
position (C).

Cleaning carpets or hard flooring

A

B

C

r VS-19TS Swift manual op.qxd 7/15/04 8:00 PM Page 3