MODIFIED AUGUST 2008 P/N 74075
Vaxcare:
AUST: 1300 36 4040
NZ: 0800 800 900
www.vax.com.au
Instruction Manual
Please read carefully before using the cleaner.
Always fully extend the mains cable before use.
vaxnz@vax.co.nz
Important Safety Instructions
When using this electrical appliance, basic
precautions should always be observed,
including the following:
READ ALL INSTRUCTIONS BEFORE USING
THIS APPLIANCE
IMPORTANT: The manufacturer will not
accept responsibility for damage caused
when the appliance is not used according to
the instructions, or for uses other than those
for which it was intended.
To reduce the risk of fire, electric shock or
injury:
•
Before use, always fully extend the
power cord but not beyond the yellow
mark.
•
WARNING: INJURY COULD OCCUR
IF USED OUTDOORS OR ON WET
SURFACES.
• Do not leave appliance unattended when
plugged in. Unplug from outlet when not in
use and before servicing.
• This appliance is not intended for use
by young or infirm persons unless they
have been adequately supervised by a
responsible person to ensure that they can
use the appliance safely.
Young children should be supervised
to ensure that they do not play with the
appliance.
• Use only as described in this manual.
Use only manufacturer’s recommended
attachments.
• Do not use with damaged cord or plug. If
appliance is not working as it should, has
been dropped, damaged, left outdoors,
or dropped into water, return it to your
Authorised Vax Service Agent for service.
• Do not pull or carry by cord, use cord as
a handle, close a door on the cord, or pull
cord around sharp edges or corners. Do
not run appliance over cord. Keep cord
away from heated surfaces.
• Do not unplug by pulling on cord. To unplug,
grasp the plug, not the cord.
•
To prevent a whipping action when
rewinding the power cord, allow cord
to run through palm of hand. Rewind 111/2 metres at a time.
• Do not handle plug or appliance with wet
hands.
• Do not put any object into openings. Do not
use with any opening blocked; keep free of
dust, lint, hair and anything that may reduce
air flow.
• Keep hair, loose clothing, fingers and all
parts of body away from openings and
moving parts.
• Do not pick up anything that is burning or
smoking, such as cigarettes, matches or
hot ashes.
• Turn off all controls before unplugging.
• Use extra care when cleaning on stairs.
• Do not use to pick up flammable or
combustible liquids such as gasoline or use
in areas where they may be present.
• Do not attempt to service the unit while
appliance is plugged in.
• Do not use vacuum to pick up water or any
liquids or fluids.
Motor Thermostat
IMPORTANT: This unit is equipped with
a motor protective thermostat. If for some
reason the vacuum cleaner should overheat,
the thermostat will automatically turn the unit
off. Should this occur unplug the vacuum
cleaner from the electrical outlet and turn the
unit off. Replace dust bag. Clean the filters.
Allow the cleaner to cool for approximately
one (1) hour. To re-start, plug into an electrical
outlet and switch back on.
Technical Specification
Voltage: 220-240V/50Hz
Wattage: 2200 watts
Filters: Motor protection filter
Air outlet filter
Cord Length: 7.0 metres
Weight: (machine) 8.0kg
Part No: 74000
Subject to technical change without notice.
2 7
Looking After Your Vax
IMPORTANT: The Vax VS-022 is a very
powerful vacuum cleaner. It will collect
an extraordinary amount of dust and dirt,
especially during the first few applications of
use, which will quickly fill a paper dust bag or
block the pores of a cloth dust bag. Excessive
dust and dirt will also contaminate the motor
protection and air outlet filters.
Any of these conditions usually result in a
noticeable drop-off in suction, or a possible
motor shut down due to thermostat
activation.
On such occasions, it will be necessary to
replace the paper dust bag or wash and
thoroughly dry a cloth dust bag before
reusing, and renew all filters to regain peak
suction and performance.
VAXCARE Service & Help:
AUSTRALIA 1300 36 4040
NEW ZEALAND 0800 800 900
If you have any queries or concerns about
using your Vax, call VAXCARE.
Please make a note of the serial number
and model number of the appliance before
calling.
(Aust only: Mon-Fri. 10.00am to 6.00pm. EST)
Calls are charged at the local rate.
An answerphone is available outside of these
hours.
There are over 300 approved Vax Service
Agents in Australia and New Zealand. For
the nearest Service Agent, please refer to
your Vax warranty or call VAXCARE or visit
www.vax.com.au
REPLACEMENT DUST BAGS & FILTER PACKS
Available from your Vax stockist or Vax direct. Phone VAXCARE or visit www.vaxcare.com.au
To ensure the performance and design function of any
VAX appliance is maintained, the use of Genuine VAX
Consumable dust bags and filters are essential.
Genuine VAX Consumables are tested, approved and
fully backed by VAX.
Should a VAX appliance suffer damage due to the use
of generic/non genuine bags, filters, parts etc., the
VAX warranty may become void.
IMPORTANT
Always look
for the VAX logos...
5 Paper Bags
Plus Motor Protection Filter
P/N 90740
1 Re-usable Bag Plus
Motor Protection Filter
P/N 90745
Motor and HEPA Filter Pack
P/N 90755
6 3
Assembling Your Vax
Fig.1 The telescopic extension tubes can be
lengthened by pressing the button &
pulling the tubes apart.
Attach the required cleaning tool to the
extension tube.
Fig.2 To attach the flexible hose to the
vacuum cleaner, push the connecting
end of the flexible hose into the
attachment point on the vacuum
cleaner.
Connect the extension tube to the
flexible suction hose.
Your VS-022 has been
equipped with an easy
access storage system.
To assemble, follow
instructions:
Fig.3 The tool storage
system fixing
bracket is already
in place on the
extension tube.
Insert the holding
tubes as shown
until the tubes
click into place.
Fig.4 Place the dusting brush (A) upholstery
brush (B) and crevice tool (C) on the
tubes as shown.
Carpet and Hard Floor
Cleaning Tool
Fig.5 Hard floor position (tiles, vinyl, parquet
floors, etc.) - The cleaning tool brush
must be in the lower position. Press on
the rocker switch to lower it.
Fig.6 Carpet or rug position - The cleaning
tool brush should be raised. Press the
rocker switch to retract the brush.
HEPA Filter
Fig.16 The HEPA filter is also housed in the
dust bag compartment above and
behind the motor protection filter as
shown in fig.16. Remove dirty filter
assembly from machine and dispose
of filter medium. Replace with new
filter medium. Return filter assembly to
your VS-022.
We recommend replacing the air outlet filters
every 4-6 months; after the bag has been
emptied 5 times; when appearance is soiled;
or a loss of suction is experienced (whichever
is sooner).
ATTENTION: Do not use the vacuum cleaner
without all filters installed.
Dust Bag Indicator
Fig.17 When the indicator tur ns red or
when the suction power reduces
substantially, you should empty or
replace the dust bag.
Fig.18 When the bag is not full the indicator
will show blue.
ATTENTION: If after emptying the dust bag,
the indicator stays red, this could be for
several reasons:
• Suction passages may be blocked check flexible hose and extension tubes,
suction inlet, floor brushes and nozzles for
obstruction.
• Check motor protection filter
• Check to see if air outlet filter is dirty
Check carefully for the cause and correct
so that the vacuum cleaner can function
normally.
Do not operate the vacuum cleaner with
the indicator on red, as this could cause
irreparable motor damage.
17
18
1
2
4
5
6
3
How to Use Your Vax
Fully extend the mains cable but not
beyond the yellow mark and plug it into
a standard domestic outlet.
Set the power control button to min.
position.
Fig.7 Press the foot pedal to start the vacuum
cleaner. Slide the power control button
to the desired setting. To stop it press
the foot pedal again.
Cord Rewind
Fig.8 Press the foot pedal to recoil the power
lead. To rewind the power cord,
press the cord rewind button and
with one hand guide the power
cord through palm. Rewind 1-11/2
metres of cord at a time. This will
prevent the cord from whipping,
which could cause damage or
injury.
Fig.9 The hose grip has an air regulator
which allows further control of suction
power. To reduce suction power, slide
regulator to open position.
Fig.10 If you wish to pause briefly during
vacuuming i.e. to move a piece of
furniture or a rug, use the special
parking position on your vacuum
cleaner as shown. Slide the hook
attached to the large cleaning tool into
the slot on the rear of the appliance.
4 5
Fig.11 & 12 You can move or store your
appliance in a vertical position
by sliding the hook on extension
tube into the clip on the
underside of the appliance. This
practical system allows you to
carry the vacuum cleaner around
in one hand and to store it in the
minimum of space.
Caring For Your Vax
Your appliance is equipped with a dust bag.
If you notice that the vacuum cleaner seems
to be less efficient that usual, check the dust
indicator by selecting the maximum power
and lifting the cleaner tool off the floor. If it
turns red, empty or change the dust bag.
To Empty the Dust Bag
Fig.13 Turn off the appliance and unplug it.
Lift up the catch to raise the cover
and gain access to the dust bag
compartment. Remove the bag by
pulling free of the holder.
Fig.14a The clip on the bag can then be
removed as shown.
Fig.14 Shake the dust bag over a bin so
that the dirt can be removed. Once
empty, replace clip and re-assemble
in cleaner.
If a disposable bag is used, simply remove
and replace with a new bag.
Changing the Filters
Motor Protection Filter
Fig.15 This filter protects the motor from
dust and is located in the dust bag
compartment.
To replace filter, remove the filter grill,
remove the motor protection filter and
reinstall with a new motor protection
filter along with the existing filter grill.
We recommend changing this filter
after 5 bag changes or when the filter
appears soiled.
7
8
9
10
11
12
13
14
14a
15
Loading...