Vax VO-4000 Easy Manual
Easy Guide
UK SERVICE & HELP - VAX CARE 0870 6061248
Monday to Friday 9.00am to 5.00pm. An answer phone is available out of these hours. If you have queries or concerns about using your VAX, call the HELPLINE. Calls are charged at
the UK national rate. Please make a note of the serial number and model number of your VAX before calling. There are over 400 approved VAX Service Agents in the UK. For your
nearest Service Agent, please call VAX Care.
VO-4000
Please read carefully before using your VO-4000
Parts check list
A - Carry handle
B - On/Off button
C - Motor housing unit
D - Cord winding recess
E - Release latches
F - Hose connector
G - Dust/dirty water container
H - 360orotating castors
I - Flexible hose
J - Combination floor tool
K - Crevice tool
L - Dusting brush
M - Wet floor tool
N - Extension tubes
O - Accessory storage lid
P - Paper dustbag
Q - Re-useable bagless filter
A
E
N
G
J
Q
K
F
H
B
O
C
D
I
M
L
P
1
2
How to assemble
Fig. 1 Assemble the two piece extension tubes and the combination floor tool by pushing them together
as shown.
Fig. 2 To attach the flexible hose to the vacuum cleaner, push the connecting end of the flexible hose into the
attachment point on the vacuum cleaner.
3
4
How to use attachments
Adjusting the combination floor tool for carpets & hard floors
Fig. 3 Hard floor position (tiles, parquet floors etc) – the combination floor tool must be in the lower position. Press on
the rocker switch to lower it (fig.3).
Fig. 4 Carpet or rug position – the combination floor tool must be in the raised position. Press on the rocker switch
to lift the brush up (fig.4).
5
6
Preparing to use
Fig. 5 Remove the top of the vacuum by releasing the side latches.
Fig. 6 With both latches released, lift the top section away as shown.
Loading...