www.vax.com.au
Steam Mop
Get Cleaning...
What’s your Vax’s model number?
What’s your serial number? (Located on the base of the machine)
Note these down in case you need them in future. Please keep instructions for further use.
VMSM1500
V M S
– – – – –
H90-GA-B User Guide.qxd:User guide 30/10/09 14:15 Page 1
User Guide
Vax Service line AU: 1300 361 505
NZ: 0800 800 900
M
1 5 0 0
---
Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
2
Machine Overview
1 Ergonomic Hand Grip
2 Quick-Release Upper Cord Wrap
3 Telescopic Handle
4 Telescopic Handle Lock
5 Locking Metal Pin
6 Lower Cord Wrap
7 Pin Set Hole
8 Lower Body
9 Water Tank Cap (roped)
14
13
12
10
8
7
5
4
3
2
1
11
16
17
18
19*
20*
9
6
15
10 Steam Pump Switch
11 Water Tank Viewing Window
12 Green/Red Indicator Light
13 Water Tank
14 Mop Head
15 Power Cord
16 2 Microfiber Cleaning Pads
Accessories
17 Funnel
18 Water Fill Cup
19 Carpet Glider
20 Dusting Pad
---
www.vax.com.au
3
FOR HOUSEHOLD USE ONLY.
Whenusing the steam mop, basic safety precautions
should alwaysbe observed, including the following:
11 . Do not steam clean harmful or toxic material
(chlorine, bleach, ammonia, drain cleaner etc.).
12. Keep cleaning area well lit.
13. Store the steam mop in a cool, dry area.
14. Turn off the on/off switch before unplugging the
steam mop.
15.WSymbol IEC 60417-5597 (2002-10)
is used on the unit to indicate the following:
ARNING: Always switch off and unplug the
steam cleaner from the electrical outlet before
assembling, opening or emptying the water container, or
beforecon
ne
cting/disconnecting the attachments.
CAUTION: The steam cleaner is a very powerful
unit. Before plugging the cord into the electrical
outlet, make sure the switch is in the ‘off’ position. Hold the
steam cleaner firmly when starting and in use.
IMPORTANT: We recommend the use of a
This steam cleaner is intended for household use
only and NOT for commercial or industrial use.
PLEASE KEEP INSTRUCTIONS FOR FURTHER USE.
!
!
!
1 . Turn off the steam mop controls before
disconnecting or connecting from the mains supply.
2. Always unplugthe steam mop before connecting
or disconnecting the vacuum hose and accessories.
3. Childrenshould be supervised to ensure that they
do not play with the appliance.
4. This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instr
uction concerning use of the appliance by a
person responsible for their safety.
5. Use only as described in this manual. Use only Vax
recommended attachments.
6. Do not use the steam mop if it has been
dropped, damaged, left outdoors or dropped into
water. Do not use the steam mop with a damaged
cord or plug. If the supply cord is damaged, it
7. Do not pull or carry by cord. Do not use the cord
as a handle, close a door on the cord or pull cord
around sharp edges or corners. Do not run the
steam mop over the cord. Keep the cord away
from heated surf
aces.
8. Do not handle the plug or steam mop with wet
hands. Do not use outdoors or on wet surfaces.
9. Do not put any objects into openings. Do not use
with any openings blocked and do not restrict air-
flow. Keep all openings free of dust, lint, hair or
anything that might reduce airflow.
10. Keep hair, loose clothing, fingers and all parts of
the body away from openings and moving parts.
must be replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
!
WARNING: Danger of Scalding
Residual Current Device with a Residual Current
rating of 30mA or less.
General Safety Information
---
Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
4
Operation
Before using for the first time
1. Carefully unpack the Steam Mop.
2. Remove all parts from the carton and familiarize yourself with all of
the components listed. Make sure all components and accessories are
present before discarding packing materials.
3. Following the instructions outlined in the Microfiber Cleaning Pads
Care & Cleaning section of this Instruction Manual (page 7), wash the
microfiber cleaning pads. During the manufacturing process the fabric
has a tendency to become flat as it picks up contaminants from the air
and machinery. Trim any loose pad threads with sharp scissors.
4. Attach the cleaning pad by fitting the mop head into the cleaning pad.
Tighten the cleaning pad by pressing the circular lock in one hand,
while pulling the black drawstring with the other. When a tight fit is
achieved, release the lock to secure in place.
1. The Steam Mop comes in 2 pieces: telescopic upper handle and
the lower body.
2. To assemble the Steam Mop for first time use, locate and line up the
locking metal pin on the bottom of the telescopic handle with the pin
set hole on the top of the lower body.
3. Depress the metal pin to insert the telescopic handle into the lower
body. Push firmly until the locking pin pops up through the hole and
locks into place.
NOTE: The fit will be tight.
Assembly
---
www.vax.com.au
5
Operation
How to use
NOTE: In hard water areas, or to prevent calcium and mineral deposits
from accumulating on the heating element and mop head, you may use
distilled or demineralized water in place of tap water.
1. Always make sure the Steam Mop is unplugged.
2. Make sure the microfiber cleaning pad is properly attached to the
mop head. And install following the procedure described in the
(Before Using for the First Time) section of this Instruction Manual.
WARNING: NEVER USE THE STEAM MOP WITHOUT THE
MICROFIBER CLEANING PAD PROPERLY ATTACHED.
1. For best results, thoroughly sweep or vacuum floor(s) prior to cleaning with the Steam Mop.
2. Twist the quick-release upper cord wrap to either side and unwrap the power cord completely.
3. Lengthen the telescoping handle by pushing the lock forward and then pulling the handle out to
extend to the desired length.
4. Plug the unit into a 240V AC electric outlet. The indicator light will illuminate green.
5. Press the steam pump switch to the ON (I) position. After 30 seconds, an audible hissing noise
can be heard as the unit heats and steam production begins. Steam will wet microfiber
cleaning pad.
6. Tilt the ergonomic handle to a 45-degree angle and clean the floor area slowly. For best
results: The cleaning pad should be changed when it gets too wet or if it is noticeably dirty.
How to use on floors
Water Tank Cap
(roped)
IMPORTANT: Never use the Steam Mop without the microfiber cleaning
pad properly attached to the mop head.
IMPORTANT: Check the water tank viewing window to ensure there is
adequate water in the water tank.
3. Turn the water tank cap counter-clockwise to open. Lift roped cap up and off the tank.
4. Using the water fill cup and funnel, pour one full cup into the water tank.
CAUTION: Check the water tank viewing window to make sure water level does not exceed
the MAX fill line. DO NOT OVERFILL.
5. Replace the water tank cap. Turn clockwise to tighten until snug.
---
Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
6
Operation
How to use on floors (Cont)
How to use on carpets?
7. Pay attention to the water tank’s viewing window to monitor remaining water/steam. As the
water tank empties, a special water sensor will cause the unit to work intermittently and
eventually stop running in order to protect the pump inside the unit. A vibrating sound may be
heard, and the green/red indicator light will turn red. The pump will turn OFF.
WARNING:
Never leave the Steam Mop in one spot on any surface for an extended
-
period of time with a damp or wet microfiber cleaning pad attached as
this may damage the floor surface.
8. Press the steam pump switch to the OFF (O) position. Unplug the Steam Mop.
9. Refill the water tank using the water fill cup and funnel as previously described. (How To Use)
The indicator light will change to green. Continue steam cleaning.
10.When cleaning with the Steam Mop is completed, press the steam pump switch to OFF (O).
Unplug the unit from the electrical outlet.
11.Carefully remove the microfiber cleaning pad from the Steam Mop head.
CAUTION:
Cleaning pad and mop head may be hot.
IMPORTANT:
Do not store unit with a damp or wet microfiber cleaning pad attached.
Your Steam Mop is designed to clean carpets or rugs that will withstand high heat. Be sure
to check the Use and Care Instructions from the carpet manufacturer before steam cleaning.
WARNING:
The carpet glider accessory is for use on carpeting and rugs only. Use of the
-
carpet glider on other floor will cause streaking and possible scratching of
the floor’s surface.
IMPORTANT:
Never use the Steam Mop without the microfiber cleaning pad properly
attached to the mop head.
IMPORTANT:
Check the water tank viewing window to be sure there is adequate
water in the water tank.
For best results, thoroughly vacuum the carpets or rugs prior to steam cleaning.
1. Place the mop head (with microfiber cleaning pad in place) on top of the carpet glider.
2. Do not attempt to use the Steam Mop on carpet/rug surfaces without the carpet glider in place!
CAUTION:
Never use the carpet glider on surfaces that are prone to scratching.
CAUTION:
The Steam Mop emits steam and creates moisture.
If the Steam Mop operates too long in one place, water marks can result.
3. Steam clean carpets or rugs using the detailed instructions outlined in the (How To Use
On Carpets) section.
---
www.vax.com.au
7
Maintenance (Keep your Vax as good as new)
This appliance requires little maintenance. It contains no user serviceable parts. Do not try
to repair it yourself. Any servicing that requires disassembly other than cleaning must be
performed by a qualified appliance repair technician.
To ensure long life and continued cleaning ability, proper care of your microfiber cleaning pad is
required. Read and follow cleaning instructions.
1. Microfiber cleaning pads can be machine washed in warm water with a mild detergent after
CAUTION:
Never use bleach or fabric softener.
IMPORTANT:
Only use liquid detergent or soap.
2. Air dry pads for 24 hours.
NOTE: Cleaning pads may be machine tumble dried on low heat.
3. To avoid passing or picking up lint from the cleaning pads, wash the microfiber cleaning
pads separately or place them in a garment bag.
IMPORTANT:
Wash microfiber cleaning pads regularly. As with any fabric, dirt particles
can cause the fibers to break down. Therefore regular cleaning will help
preserve the cleaning efficiency of the microfiber cleaning pads.
4. As the microfiber cleaning pad is used, sometimes a thread will loosen or pull out. This is
normal. Never pull loose threads as this can cause the weave to come undone. Simply trim any
loose threads with a pair of sharp scissors.
5. Dusting Pad can be cared for and cleaned in same manner as microfiber pads.
1. Always unplug and allow the Steam Mop to cool completely before cleaning or moving.
2. Press the round black lock and pull it downwards to loosen the microfiber cleaning pad’s
drawstring.
3. CAUTION:
Carefully remove the cleaning pad from the mop head, as mop pad
and lower assembly may be hot.
4. Any water remaining in the water tank should be emptied before storing the Steam Mop.
5. Wipe all exterior surfaces of Steam Mop with a damp or dry, soft cloth.
1. Never store the Steam Mop while it is still plugged in. Remove the plug from the electrical outlet.
2. Empty water from the water tank before storing.
3. Twist the quick-release upper cord wrap to face upwards. Wrap cord for storage.
4. Store upright in a protected, dry area. Keep water fill cup and funnel handy for future use.
General maintenance
Microfiber cleaning pads care & cleaning
Storage
Care & cleaning
each use or when dirty.
---
Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
8
FAQs
!
WARNING: to reduce the risk of personal injury, unplug the steam mop
before performing maintenance/troubleshooting checks.
Don’t take your machine
back to the shop, simply
contact us
AU: 1300 361 505
NZ: 0800 800 900
www.vax.com.au
PROBLEM
POSSIBLE REASON POSSIBLE SOLUTION
Reduced steam or
no steam
1. Water tank is empty 1. Fill water tank
2. AU: 1300 361 505 / NZ: 0800 800 900
2. Steam pump not on 2. Turn on
Steam Mop worked
intermittently and
then stopped
1. Not enough water in the tank 1. Fill water tank
The indicator light
is red
1. Water tank is empty 1. Fill water tank
Cleaning pad is very
wet and no longer
picking up dirt from
the floor or carpet
1. Cleaning pad is saturated 1. Change pad
Steam mop left
white spot on floor
1. Steam mop left in one spot too long
2. Hard Water
1. Never leave the steam mop on the floor with a damp
or wet cleaning pad still attached when not in use.
2. Use distilled water.
---
www.vax.com.au
9
Service & Help
Vax Customer Careline AU: 1300 361 505 / NZ: 0800 800 900
Monday-Friday 8.30am to 5.30pm
Any queries or concerns about using the Vax, call the Vax Careline. Calls are charged at the
Standard national rate.
Please make a note of the serial number and model number of the carpet cleaner before calling.
For the nearest Service Agent, please call the Vax Customer Careline or visit www.
vax.com.au
Technical Specification
Voltage: 220-240V ~50Hz
Wattage: 1500w
Water
Capacity:
250ml
Variable
Steam:
25g/min
Weight: 2.06kg
1 YEAR LIMITED WARRANTY
Vax
N197
Cord length:
5.2m
Heating time:
30 seconds
Other Information
---
Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
10
Notes
---
www.vax.com.au
11
Notes
---
Distributed by Techtronic Industries Pty. Ltd.
Level 1, 666 Doncaster Rd, Doncaster, Australia 3108.
www.vax.com.au. Service Line: AU: 1300 361 505 / NZ: 0800 800 900
U91-MA Mach Air Series User Guide.qxd:User guide 9/7/09 09:54 Page 12
Loading...