User Guide
vax.co.uk
GB
Vax Careline 0844 412 8455
Bagless Cylinder
VEC-101 / 102
Get Cleaning...
What’s your Vax’s model number?
What’s your serial number? (Located on the base of the machine)
Note these down in case you need them in future. Please keep instructions for further use.
V E C
–
1 0
– –
– – – – –
VEC-101 & 102 User Guide.qxd:User guide 12/11/09 16:48 Page 1
---
Machine Overview
4
2
1
6
3
1 Dirt container
2 Central HEPA filter
3 Carry handle
4 Hose inlet
5 Cord rewind
6 Dirt container release button
7 Blockage indicator
8 Floor tool parking
9 On/off switch
10 Dirt container empty catch
Unit
Accessories
10
2
Vax Helpline
0844 412 8455
Filters
2
1
PLEASE NOTE: some parts may
vary according to model. Please
check inside flap of box for more
details.
11 Combination floor head
12 Telescopic extension tube
13 Hose
14 Dusting brush
15 Crevice tool
16 Tool storage handle clip
17 TurboTool
(some models only)
18 Fibre post-motor filter
13
14
5
7
8
9
15
16
17
11
12
2 18
VEC-101 & 102 User Guide.qxd:User guide 12/11/09 16:48 Page 2
General Safety Information
vax.co.uk
3
FOR HOUSEHOLD USE ONLY.
Whenusing the vacuum cleaner, basic safety precautions
should always be observed, including the following:
1. Only use the vacuum cleaner indoors on dry
s
urfaces.
2. Turn off the vacuum cleaner controls before
d
isconnecting or connecting from the mains supply.
3. Always unplug the vacuum cleaner before
connecting or disconnecting the vacuum hose and
accessories.
4. Childrenshould be supervised to ensure that they
do not playwith the appliance.
5. This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a
person responsible for their safety.
6. Use only as described in this manual. Use only Vax
recommended attachments.
7. Do not use the vacuum cleaner if it has been
dropped, damaged, left outdoors or dropped into
water. Do not use the vacuum cleaner with a
damaged cord or plug. If the supply cord is
damaged return the vacuum cleaner to a Vax
Authorised Service Agent or contact the Vax Careline
on 0844 412 8455 for assistance.
8. Do not pull or carry by cord. Do not use the cord as a
handle, close a door on the cord or pull cord around
sharp edges or corners. Do not run the vacuum
cleaner over the cord. Keep the cord away from
heated surfaces.
9. Do not handle the plug or vacuum cleaner with wet
hands. Do not use outdoors or on wet surfaces.
10. Do not put any objects into openings. Do not use
with any openings blocked and do not restrict air-
flow. Keep all openings free of dust, lint, hair or
anything that might reduce airflow.
11. Keep hair, loose clothing, fingers and all parts of
the body away from openings and moving parts.
12. Do not pick up hot coals, cigarette butts, matches
or any hot, smoking or burning objects.
13. Do not pick up flammable or combustible
materials (lighter fluid, petrol, kerosene etc.) or use
in the presence of explosive liquids or vapours.
14. Do not vacuum up harmful or toxic material
(
chlorine, bleach, ammonia, drain cleaner etc.).
15. Do not vacuum up hard or sharp objects such as
g
lass, nails, screws, coins, etc.
16. Do not use without ALL of the filters in place.
1
7. Take extra care when vacuuming on stairs.
18. Keep vacuuming area well lit.
19. Store the vacuum cleaner in a cool, dry area.
20. Turn off the on/off switch before unplugging the
vacuum cleaner
21. Use only CE-approved 13 amp extension cords.
Non-approved cords may overheat. Care should
be taken to arrange the cord so that the cord
cannot be tripped over.
WARNING: Always switch off and unplug the
vacuum cleaner from the electrical outlet before
assembling, opening or emptying the dirt container, or before
connecting/disconnecting the attachments.
CAUTION: The vacuum cleaner is a very powerful
unit. Before plugging the cord into the electrical
outlet, make sure the switch is in the ‘off’ position.
IMPORTANT: If the inlet, hose or telescopic tube
is blocked, switch off the vacuum cleaner and
remove the blockage(s) before re-starting the vacuum
cleaner. See Maintenance: Clearing blockages.
IMPORTANT: Washing filters improves vacuum
performance. Vax recommends that they should
be checked and cleaned periodically (depending on the level
of use). Make sure all filters are completely dry before
inserting back into the vacuum cleaner.
IMPORTANT: The motor is equipped with a thermal
cut-out. If for any reason the unit should overheat,
the thermostat will automatically turn the unit off. Should this
occur, unplug the vacuum cleaner from the electrical outlet
and turn off the switch. Remove dirt container and empty.
Clean filters. Allow the unit to cool for approximately one (1)
hour. To re-start, plug into an electrical outlet and switch back
on.
This vacuum cleaner is intended for household use
only and NOT for commercial or industrial use.
PLEASE KEEP INSTRUCTIONS FOR FURTHER USE.
!!!!!
VEC-101 & 102 User Guide.qxd:User guide 12/11/09 16:48 Page 3
---
Operation
Assembling your vacuum cleaner
Operating the appliance
NOTE: Fully extend the
power cord before each
use. A yellow mark on
the cord indicates the
recommended cord
length. Do not exceed
the cord length beyond
the yellow mark.
Packing away and storage
4
Vax Helpline
0844 412 8455
NOTE: For convenience
there is a parking slot located
at the back of the vacuum
cleaner where the floor tool
can be attached for storage
and carrying.
Keep your Vax like new
IMPORTANT: The condition of the filters affects the
performance of your machine. Please check and wash
filters periodically (depending on the level of use). For
full cleaning instructions, see page 5.
!
IMPORTANT: Do not use the vacuum cleaner without
all of the filters in place.
!
NOTE: The TurboTool, crevice tool and dusting brush can all be attached to the telescopic
tube or caddy on the hose handle.
Hard floors
Carpets
VEC-101 & 102 User Guide.qxd:User guide 12/11/09 16:48 Page 4
Maintenance (Keep your Vax as good as new)
Emptying and cleaning the dirt container
Cleaning the post-motor filter
vax.co.uk
5
Cleaning the Central HEPA filter
24hr
t
a
p
24hr
t
a
p
!
IMPORTANT: Water temperature should be at a maximum of 40° C when washing filters
!
IMPORTANT: Water temperature should be at a maximum of 40° C when washing filters
VEC-101 & 102 User Guide.qxd:User guide 12/11/09 16:48 Page 5
---
6
Vax Careline
0844 412 8455
Clearing blockages
Warning: To reduce the risk of electric shock, the power cord must be disconnected from
the mains supply before performing maintenance/troubleshooting checks. Turn the vacuum
cleaner off and unplug from the electrical socket
!
Hose blockages
The flexible hose should be disconnected
from the vacuum cleaner. Carefully remove
any blockages found and reconnect the
hose securely.
Accessory blockages
Remove accessory from the hose/handle tube.
Carefully remove the blockage and return to the
cleaner.
Clearing debris from the TurboTool
(
some models only)
NOTE: Switch the cleaner off and disconnect the power plug from the electrical outlet before
performing this check.
Using a pair of scissors, cut through any threads or hairs caught around the TurboTool brushbar.
remove
locking ring
Maintenance (Keep your Vax as good as new)
replace
locking ring
VEC-101 & 102 User Guide.qxd:User guide 12/11/09 16:48 Page 6
vax.co.uk
7
This page has been left intentionally blank
VEC-101 & 102 User Guide.qxd:User guide 12/11/09 16:48 Page 7
---
FAQs
8
Vax Helpline
0844 412 8455
!
WARNING: to reduce the risk of personal injury, unplug the vacuum cleaner
before performing maintenance/troubleshooting checks.
Is there an accessory missing?
• Check the ‘Parts Overview’ page in this
guide to make sure the part is definitely
included in your unit.
• If it is missing, we’re here to help. Simply call
us on 0844 412 8455
Why won’t the vacuum cleaner pick up?
• The dirt container may be incorrectly
installed; remove the dirt container from the
unit by pressing the dirt container release
button [6] and then re-attaching it to the unit,
ensuring it is locked firmly back into place.
• The filter may be clogged; refer to
‘Maintenance: Cleaning the filters’ on page 5.
• The dirt container may be blocked; refer to
‘Maintenance: Emptying and cleaning the dirt
container’ on page 5.
Why is dust escaping from the vacuum?
• The filter may be clogged; refer to
‘Maintenance: Cleaning the filters’ on page 5.
• The dirt container may be blocked; refer to
‘Maintenance: Emptying and cleaning the dirt
container’ on page 5.
• The dirt container may be incorrectly
installed; remove the dirt container from the
unit by pressing the dirt container release
button [6] and then re-attaching it to the unit,
ensuring it is locked firmly back into place.
What do I do if the unit/an accessory
becomes damaged or broken?
• We’re here to help. Simply call 0844 412
8455 or visit vax.co.uk
Why won’t the accessories pick up
properly?
Hose blockages: remove the flexible hose
from the unit. Carefully remove any blockages
found and reconnect hose securely.
Accessory blockages: remove accessory
from handle/tube. Carefully remove blockage
and re-attach to the vacuum cleaner.
• The accessory may be faulty. Simply call us
on 0844 412 8455 for assistance.
Why will the vacuum cleaner not run?
• It may not be plugged into the electrical
outlet correctly; ensure that the plug is
pushed in securely.
• The electrical outlet may not be working
properly; check the fuse or breaker, or consult
an electrician.
• The motor thermostat may have tripped;
switch off and unplug the vacuum cleaner,
and leave for one hour before switching the
cleaner back on.
VEC-101 & 102 User Guide.qxd:User guide 12/11/09 16:48 Page 8
Other Information
UK Service & Help
Vax Customer Careline 0844 412 8455
Monday-Friday 8.30am to 6.30pm
Saturday-Sunday 9.00am to 5.00pm
Any queries or concerns about using the Vax, call the Vax Careline.
Please make a note of the serial number and model number of the carpet cleaner before calling.
Technical Specification
Voltage: 220-240V ~50Hz
Wattage: 2000 W
Capacity: 2.6L
Filters: Central HEPA filter (washable)
Fibre post-motor filter (washable)
Cord length: 5 m (approx)
Weight: 5.2kg
Subject to technical change without notice.
EEC Statement of Compliance
Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the
VEC-101 / 102 Essentials Series is manufactured in compliance with the following Directives:
Safety: 2006/95/EC Low Voltage Directive
EMC: 2004/108/EC Electromagnetic Compatibility Directive
Waste electrical products should not be disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or retailer for recycling advice.
vax.co.uk
9
VEC-101 & 102 User Guide.qxd:User guide 12/11/09 16:48 Page 9
---
Vax Ltd., Kingswood Road, Hampton Lovett, Droitwich, Worcestershire, WR9 OQH, UK
email: info@vax.co.uk - website: vax.co.uk
VEC-101 & 102 User Guide.qxd:User guide 12/11/09 16:48 Page 10
Loading...