Get Cleaning...
What’s your Vax model number? (Located on the flap of the packaging)
What’s your serial number? (Located on the base of the machine)
Note these down in case you need them in future. Please keep instructions for further use.
– – – – –
e.g. VCAB1500
Bagless Cylinder
Vax Careline: AU: 1300 361 505
User Guide
C89-MA Series User Guide (7) V1.0.qxd:User guide 28/1/11 15:34 Page 1
VA X
NZ: 0800 800 900
www.vax.com.au
Vax Air Series
VCAB1500 / VCAT1500
---
Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
---
Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
3
Machine Overview
810 9
2 3 754
6
1
Unit
1 Hose connector
2 Dirt container
3 Cyclone separator and shroud
4 Carry handle
5 Dirt container release button
6 Cord rewind button (hidden)
7 Floor head parking slot
8 On/off button
9 Post-motor filter cover
10 Primary separator
11 HEPA H12 post-motor filter/
HEPA H12 antibacterial post-motor filter
(VCAT1500 model only)
12 Pre-motor filter
13 Turbobrush (VCAT1500 model only)
14 Combination floor head
(VCAB1500 model only)
15 Telescopic extension tube
16 Dusting brush
17 Crevice tool
18 Flexible hose and handle
19 Hard floor tool
(VCAT1500 model only)
20 TurboTool (VCAT1500 model only)
21 Stretch hose (VCAT1500 model only)
22 Upholstery tool
23 TurboTool connector
(VCAT1500 model only)
11
12
18
20
15
22 23
13
14
16
17
NOTE: Some parts may vary
according to model. Please check
inside flap of box for more details.
19
Accessories
Filters
21
---
www.vax.com.au
4
FOR HOUSEHOLD USE ONLY.
Whenusing the vacuum cleaner,basic safety precautions
should always be observed, including the following:
1. Only use the vacuum cleaner indoors on dry surfaces.
Do not handle the plug or vacuum cleaner with wet
hands. Do not use outdoors or on wet surfaces.
2. Turn off the vacuum cleaner controls before
disconnecting or connecting from the mains supply.
3. Always unplug the vacuum cleaner before connecting or
disconnectingthevacuum hose and acc
essories.
4. Children s
hould be supervisedto ensure that theydo not
playwith the appliance.
5. This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a
person responsible for their safety.
6. Use only as described in this manual. Use only Vax
recommended attachments.
7. Do n
ot use the vacuum cleane
r if it has been dropped,
damaged, left outdoors or dropped into water. Do not
use the vacuum cleaner with a damaged cord or plug.
If the supply cord is damaged, it must be replaced by
the manufacturer or a recommended Service Agent to
avoid hazard and invalidating the guarantee.
8. Do not pull or carry by cord. Do not use the cord as a
handle, close a door on the cord or pull cord around
sharp edges or corners. Do not run the vacuum
cleaner over the cord. Keep the c
ord away from
heated surfaces.
9. Do not put any objects into openings. Do not use with
any openings blocked and do not restrict air-flow. Keep
all openings free of dust, lint, hair or anything that might
reduce airflow.
10. Keep hair, loose clothing, fingers and all parts of the
body away from openings and moving parts.
11. Do not pick up hot coals, cigarette butts, matches or
any hot, smoking or burning objects.
12. Do not pick up flammable or combustible materials
(lighter flu
id, petrol, kerosene et
c.) or use in the
presence of explosive liquids or vapours.
13. Do not vacuum up harmful or toxic materials (chlorine,
bleach, ammonia, drain cleaner etc.).
14. Do not vacuum up hard or sharp objects such as glass,
nails, screws, coins, etc.
15. Do not use without ALL of the filters in place.
16. Take extra care when vacuuming on stairs.
17. Keep vacuuming area well lit.
18. Store the vacuum cleaner in a cool, dry area.
19. Turn off the on/off switch before un
plugging the
vacuum cleaner
20. Use only SAA approved 10amp extension cords.
Non-approved cords may overheat. Care should be
taken to arrange the cord so t
hat the cord cannot be
tripped over.
WARNING: Always switch off and unplug the
vacuum cleaner from the electrical outlet before
assembling, opening or emptying the dirt container, or before
connecting/disconnecting the attachments.
CAUTION: The vacuum cleaner is a very powerful
unit. Before plugging the cord into the electrical
o
utlet, make sure the switch is in the ‘off’ position.
IMPORTANT: If the inlet, hose or telescopic tube is
blocked, switch off the vacuum clean
er and remove
the blockage(s) before re-starting the vacuum cleaner. See
Maintenance: Clearing blockages.
IMPORTANT: Washing filters maintains vacuum
performance. Vax recommends that they should
be checked and cleaned periodically (depending on the level
of use). Make sure all filters are completely dry before
inserting back i
nto the vacuum cleaner.
IMPORTANT: The motor is equipped with a thermal
cut-out. If for any reason the unit should overheat, the
thermostat will automatically turn the unit off. Should this
occur, unplug the vacuum cleaner from the electrical outlet
and turn off the switch. Remove dirt container and empty.
Clean filters. Allow the unit to cool for approximately one (1)
hour. To re-start, plug into an electrical outlet and switch back
on.
This vacuum cleaner is intended for h
ousehold use
only and NOT for commercial or industrial use.
PLEASE KEEP INSTRUCTIONS FOR FURTHER USE.
!
!
!
!
!
General Safety Information
---
Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
5
Operation
Assembling your vacuum cleaner
Operating the appliance and accessories
NOTE: Fully unwind the power
cord. A yellow mark on the cord
indicates the recommended
cord length. Do not exceed the
cord length beyond the yellow
mark.
Keep your Vax like new
IMPORTANT: The condition of the filters affects the
performance of your machine. Please check and
wash filters periodically (depending on the level of use).
For full cleaning instructions, see pages 5 and 6.
!
IMPORTANT: Do not use the vacuum cleaner without
all of the filters in place.
!
1
2
15
18
15
15
14
NOTE: The TurboTool (with TurboTool connector attached), Turbobrush, hard floor tool, crevice
tool, upholstery tool and dusting brush can all be attached to the telescopic tube or
hose handle.
NOTE: Stretch hose should not be used as the main vacuum hose. The stretch hose is
recommended to be used for a period of 20 minutes maximum.
Carpets
Hard floors
1
2
To vary the suction power,
open/close the sliders on the
hose handle/Turbobrush.
---
www.vax.com.au
6
Operation
Emptying and cleaning the dirt container
NOTE: For convenience there is a parking slot located at the rear of the
vacuum cleaner where the floor head and tubes can be attached for storage
and carrying.
1
2
Packing away and storage
tap
24hr
Advanced cleaning - primary separator
!
40° C max
1
1
2
2
Press dirt container release button and lift. Press the dust release lever to empty dirt.
---
Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
7
Maintenance (Keep your Vax as good as new)
tap
Cleaning the pre-motor filter
tap
24hr
!
40° C max
!
WARNING: Do not wash the post-motor filter.
Cleaning the HEPA post-motor filter
Advanced cleaning - cyclone separator
1
1
1
1
2
2
2
2
Wipe to clean. Parts
must be completely
dry before using
your machine.
---
www.vax.com.au
8
Maintenance (Keep your Vax as good as new)
WARNING: To reduce the risk of electric shock, the power cord must be disconnected
before performing maintenance/troubleshooting checks. Turn the vacuum cleaner off and
unplug from the electrical socket
!
Hose blockages
The flexible hose may be disconnected
from the vacuum cleaner. Carefully remove
any blockages found and reconnect the
hose securely.
Lay the Turbobrush floor head on a flat surface and turn over to
expose the brushbar. Using a pair of scissors, cut through any
threads or hairs caught by the brushbar that have wrapped
around the guides. Be careful not to cut the bristles on the
Accessory blockages
Remove accessory from the hose/telescopic
tube. Carefully remove the blockage and
return to the cleane
r.
Removing blockages from the TurboTool (VCAT1500 model only)
Locking ring
Tabs
Turn the TurboTool over and
slide off the locking ring.
Removing blockages from the Turbobrush (VCAT1500 model only)
Pivot lowering housing and
remove clog.
To re-assemble, be sure that
the tabs are engaged. Pivot
the lower housing closed. Slip
the locking ring into the
groove at the neck of the
TurboTool to complete
reassembly.
Clearing blockages
brush bar.
---
Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
9
FAQs
!
WARNING: to reduce the risk of personal injury, unplug the vacuum cleaner
before performing maintenance/troubleshooting checks.
Is there an accessory missing?
• Check the ‘Parts Overview’ page in this
guide to make sure the part is definitely
included in your unit.
• If it is missing, we’re here to help. Simply call
us on AU: 1300 361 505
NZ: 0800 800 900
Why won’t the vacuum cleaner pick up?
• The dirt container may be incorrectly
installed; remove the dirt container from the
unit by pressing the dirt con
tainer release
catch and then re-attaching it to the unit,
ensuring it is locked firmly back into place.
• The filter may be clogged; refer to
‘Maintenance: Cleaning the filters’ on
pages 5 and 6.
• The dirt container may be blocked; refer to
‘Maintenance: Emptying and cleaning the dirt
container’ on page 5.
• There may be a blockage in the tube/hose.
Disconnect from the vacuum cleaner,
carefully remove any blockages found and
reconnect securely.
Why is dust escaping from the v
acuum?
• The filter may be clogged; refer to
‘Maintenance: Cleaning the filters’ on
pages 5 and 6.
• The dirt container may be blocked; refer to
‘Maintenance: Emptying and cleaning the dirt
container’ on page 5.
• The dirt container may be incorrectly
installed; remove the dirt container from the
unit by pressing the dirt container release
catch and then re-attaching it to the unit,
ensuring it is locked firmly back into place.
What do I do if the unit/an accessory
becomes damag
ed or broken?
• We’re here to help. Simply call
AU: 1300 361 505
NZ: 0800 800 900
or visit www.vax.com.au
Why won’t the accessories pick up
properly?
Hose blockages: remove the hose from the
unit. Carefully remove any blockages found
and reconnect hose securely.
Accessory blockages: remove accessory
from handle/tube. Carefully remove blockage
and re-attach to the vacuum cleaner.
• The accessory may be faulty. Simply call us
on
for assistance.
Why will the vacuum cleaner not run?
• It may not be plugged into the electri
cal
outlet correctly; ensure that the plug is
pushed in securely.
• The electrical outlet may not be working
properly; check the fuse or breaker, or consult
an electrician.
• The motor thermostat may have tripped;
switch off and unplug the vacuum cleaner,
and leave for one hour before switching the
cleaner back on.
AU: 1300 361 505
NZ: 0800 800 900
www.vax.com.au
AU: 1300 361 505
NZ: 0800 800 900
---
www.vax.com.au
10
VAX Service & Help
Vax Careline:
Monday-Friday 8.30am to 5:00pm
Technical Specification
Voltage: 220-240V ~50Hz
Wattage: 1500W
Capacity: 2.5L
Filters: pre-motor filter (washable)
HEPA H12 post-motor filter/HEPA H12 antibacterial post-motor filter (not washable)
Cord length: 6m (approx)
Weight: 5.6kg (approx)
Subject to technical change without notice.
Australia: 1300 361 505
New Zealand: 0800 800 900
If you have queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the
standard
local rate. Please make a note of the serial number and model number of the vacuum
cleaner before calling. For the nearest Service Agent, please call the Vax Customer Careline or
visit www.vax.com.au.
Indoor
Use
EEC Statement of Compliance
Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the
Vax Air Cylinder series is manufactured in compliance with the following Directives:
Safety: 2006/95/EC Low Voltage Directive
EMC: 2004/108/EC Electromagnetic Compatibility Directive
Waste electrical products should not be disposed of with household waste. Please recycle where
facilities exist. Check with your LocalAuthority or retailer for recyclin
g advice.
Read
Instruction s
Other Information
---
Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
11
Notes
---
Distributed by Techtronic Industries Pty. Ltd.
Level 1, 660 Doncaster Rd, Doncaster, Australia 3108.
www.vax.com.au. Service Line: AU: 1300 361 505 / NZ: 0800 800 900
U91-MA Mach Air Series User Guide.qxd:User guide 9/7/09 09:54 Page 12
Loading...