Vax Service line AU: 1300 361 505
Bagless Upright
VA X
User Guide
NZ: 0800 800 900
Get Cleaning...
What’s your Vax’s model number?
V A U 1 2 0
What’s your serial number?
– – – – –
Note these down in case you need them in future. Please keep instructions for further use.
www.vax.com.au
0
/
V UA R 1
(Located on the base of the machine)
2 0 0
VAU1200 / VARU1200 / VAUW1200
/
V WA U 1
2 0 0
---
Machine Overview
1 Handle
2 Handle height adjuster
3 Upper handle release button
4 Dirt bin release button
5 Carry handle
6 Power on/off button
7 Brushbar on/off button
8 Inner cyclones
9 Dirt bin
10 Post motor filter release button
11 Brushbar blockage indicator
12 Brushbar access clips
13 Rotating brushbar
14 Hose to extension tube connector
15 Quick release cord wrap
16 Cord
17 3-in-1 crevice, upholstery & dusting
brush tool
18 Wheels
19 Hose to machine connector
20 Brushbar reset button
3
6
7
14
1
2
4
5
15
8
16
9
17
10
Accessories
1
17
21 Telescopic extension tube
22 Pre-motor filter
13
Unit
21
24
25
23 Post motor filter
24 Tubo tool
(on VARU1200 model only)
23
11
12
20
Filters
25 Extension hose
(VARU1200 model only)
18
19
22
2
Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
---
General Safety Information
FOR HOUSEHOLD USE ONLY.
When using the vacuum cleaner, basic safety precautions
should always be observed,including thefollowing:
1. Only use the vacuum cleaner indoors on dry
surfaces.
2. Turn off the vacuum cleaner controls before
disconnecting or connecting from the mains supply.
3. Always unplug thevacuum cleaner before
connecting or disconnecting the vacuum hose and
accessories.
4. Children should be supervised to ensure that they
do not play with the appliance
5. This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
6. Use only as described in this manual. Use only Vax
recommended attachments.
7. Do not use the vacuum cleaner if it has been
dropped, damaged, left outdoors or dropped into
. Do not use the vacuum cleaner with a
water
damaged cord or plug. If the supply cord is damaged,
it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
8. Do not pull or carry by cord. Do not use the cord
as a handle, close a door on the cord or pull cord
around sharp edges or corners. Do not run the
vacuum cleaner over the cord. Keep the cord
away from heated surfaces.
9. Do not handle the plug or vacuum cleaner with wet
hands. Do not use outdoors or on wet surfaces.
10. Do not put any objects into openings. Do not use
with any openings blocked and do not restrict airflow. Keep all o
anything that might reduce airflow.
11. Keep hair, loose clothing, fingers and all parts of
the body away from openings and moving parts.
12. Do not pick up hot coals, cigarette butts, matches
or any hot, smoking or burning objects.
13. Do not pick up flammable or combustible
materials (lighter fluid, petrol, kerosene etc.) or use
penings free of dust, lint, hair or
.
in the presence of explosive liquids or vapours.
14. Do not vacuum up harmful or toxic material
(chlorine, bleac
15. Do not vacuum up hard or sharp objects such as
glass, nails, screws, coins, etc.
16. Do not use without ALL of the filters in place.
17. Take extra care when vacuuming on stairs.
18. Keep vacuuming area well lit.
19. Store the vacuum cleaner in a cool, dry area.
20. Turn off the on/off switch before unplugging the
vacuum cleaner
21. Use only SAA approved 10 amp extension cords.
Non-approved cords may overheat. Care should
be taken to arrange the co
cannot be tripped over.
WARNING: Always switch off and unplug the
!
vacuum cleaner from the electrical outlet before
assembling, opening or emptying the dirt container, or before
connecting/disconnecting the attachments.
CAUTION: The vacuum cleaner is a very powerful
unit. Before plugging the cord into the electrical
!
outlet, make sure the switch is in the ‘off’ position. Hold the
vacuum cleaner firmly when starting and in use.
IMPORTANT: If the inlet, h
!
is blocked, switch off the vacuum cleaner and
remove the blockage(s) before re-starting the vacuum
cleaner.
IMPORTANT: Cleaning filters improves vacuum
performance. Vax recommends that your filters
!
should be checked and cleaned periodically. If your filters are
washable make sure they are completely dry before
inserting back into the vacuum cleaner.
IMPORTANT: The motor is equipped with a thermal
!
cut-out. If for any reason the unit should overh
the thermostat will automatically turn the unit off. Should this
occur, unplug the vacuum cleaner from the electrical outlet
and turn off the switch. Remove dirt container and empty.
Clean filters. Allow the unit to cool for approximately one (1)
hour. To re-start, plug into an electrical outlet and switch back
on.
This vacuum cleaner is intended for household use
only and NOT for commercial or industrial use.
PLEASE KEEP INSTRUCTIONS FOR FURTHER USE.
h, ammonia, drain cleaner etc.).
rd so that the cord
ose or telescopic tube
eat,
www.vax.com.au
3
---
Operation
Keep your Vax like new
IMPORTANT: The condition of the filters affects the
!
performance of your machine. Please check and clean
filters periodically (depending on the level of use). For full
cleaning instructions, see page 6.
IMPORTANT: Do not use the vacuum cleaner without
!
all of the filters in place.
Assembling your vacuum cleaner
1721
Operating the appliance
15
6
Twist cord hook to
release cord.
7
Turn unit on. Adjust handle height. Recline unit.
Brushbar on - carpets.
Brushbar off - hard floors.
IMPORTANT: Switching the brushbar on whilst cleaning
!
hard floors may damage flooring.
2
2
1
4
Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
---
Operation
Using accessories
NOTE: The crevice tool, dusting brush and upholstery tool can all be attached to the telescopic
tube or directly to the hose.
Attaching to hose
24
17
Attach accessory to hose.
19
19
Remove hose.
17
Choose an accessory.
Turbo tool VARU1200 only
Attaching to telescopic extension tube
3
Remove telescopic
extension tube.
14
19
Attach hose to
telescopic extension
tube.
Attach accessory to
telescopic extension
tube.
17
21
IMPORTANT:
!
Hold unit while
using hose or
telescopic
extension tube.
Using the stretch hose (Not standard for all models - the VARU1200 model only)
25
Remove stretch hose
Attach stretch hose to
the existing base hose.
www.vax.com.au
19
25
21
25
A
ttach stretch hose to
telescopic extension
tube.
Hose can now be
extended for stair
cleaning
5
---
tap
tap
2 4hr
tap
Maintenance (Keep your Vax as good as new)
Emptying and cleaning the dirt container
Advanced cleaning
1
1
2
Lift off canister Press the release button
on canister to empty
Slide out the cyclone seperator. Tap over a bin to remove excess dirt or use
a brush to gently clean seperator.
Cleaning the pre-motor filter
Twist the canister lid
Lift off lid Pull out the filter from the canister base
2
40° C max
!
Tap over a bin to remove excess dirt
Cleaning the post-motor filter
Press the release clip at the front of the
filter cap
6
Wash filter with warm tap water - no hotter
than 40˚C
WARNING: Do not wash the post-motor filter.
!
Seperate filter from the holder Tap over bin to clean
Allow to dry for 24hrs
Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
---
Maintenance (Keep your Vax as good as new)
Removing blockages from the brushbar
WARNING: To reduce the risk of electric shock, turn the vacuum cleaner off and unplug from
!
the electrical outlet before performing maintenance/troubleshooting checks.
Disconnect the hose from the vacuum cleaner and remove any blockages found then reconnect
the hose securely.
Resetting jammed brushbar
A red flashing light will indicate a jammed brushbar. To reset press the butt
Red light Green light
on on the side of your vacuum.
Removing debris from the
If the light continues to flash red after resetting, the brushbar may still be blocked. Using a pair of
scissors, cut through any threads or hairs caught around the brushbar. To access brushbar:
Press the brushbar reset button again to ensure the blockage is fully cleared.
IMPORTANT: for your safety, never try to access / replace brush bar drive belt.
!
If problem persists please call our careline: AU: 1300 361 505 / NZ: 0800 800 900
Removing blockages from the TurboTool (
brushbar
VARU1200 model only)
Press the two side buttons
together and pull apart
www.vax.com.au
Carefully use scissors to
cut out the blockage
Realign turbo brush sides
and press together
7
---
FAQs
WARNING: to reduce the risk of personal injury, unplug the vacuum cleaner
!
before performing maintenance/troubleshooting checks.
Is there an accessory missing?
• Check the ‘Machine Overview’ page in this guide
to make sure the part is definitely included in your
unit.
• If it is missing, we’re here to help. Simply call us on
AU: 1300 361 505 / NZ: 0800 800 900
Why won’t the vacuum cleaner pick up?
• The filters may be clogged: Refer to the
Maintenance sections (Page 6).
• The Dirt Container is full or blocked: Refer to
the Maintenance sections (Page 6).
• The Dirt Container may be incorrectly installed:
Refer to the Maintenance sections (Page
• The brushbar may be blocked. Refer to the
maintenance section (Page 7).
Why is dust escaping from the vacuum?
• The filters may not be installed correctly. Refer to the
Maintenance sections (Page 6).
• The Dirt container may be incorrectly installed:
Remove the Dirt Container from the unit by
pressing the Dirt Container Release Button (Page
6) and reattach it to the unit, ensuring it is locked
firmly back into place.
• The filters may be clogged: Refer to the
Maintenance se
What do I do if an accessory/the unit becomes
damaged or broken?
• Visit www.vax.com.au for where to purchase
parts and spares.
• Or call our Vax careline
AU: 1300 361 505 / NZ: 0800 800 900
ctions (Page 6).
6).
Why won’t the accessories pick up properly?
• The accessory may be blocked: Refer to the
Maintanance section (Page 7).
• The accessory may be faulty: call our
Vax Careline to order a replacement:
AU: 1300 361 505 / NZ: 0800 800 900
Why will the vacuum cleaner not run?
• It may not be plugged into the electrical outlet
correctly. Ensure that the plug is pushed into the
electrical outlet secure
• The electrical outlet may not be working. Check the
fuse or breaker and consult an electrician.
• The motor Thermostat may have tripped. Switch
off and unplug the vacuum cleaner. Leave for one
hour before switching the vacuum cleaner back
on.
Why isn’t my brushbar rotating?
• The brushbar may not be turned on. Refer to the
operation section (Page 4).
• The unit may not be reclined. Refer to the
operation section (Page 4).
• The brushbar may be jammed. Refer to the
maintenance
(Page 7).
Why is there a red light on the nozzle?
• The brushbar may be jammed. Refer to the
maintenance section for how to reset the brushbar
(Page 7).
• If the red light still shows, we’re here to help.
Simply call us on:
AU: 1300 361 505 / NZ: 0800 800 900
section for how to reset the brushbar
ly.
Visit www.vax.com.au or call on AU: 1300 361 505 / NZ: 0800 800 900
for information on where to purchasze parts and spares.
8
Don’t take your machine
back to the shop, simply
contact us
AU: 1300 361 505
www.vax.com.au
AU: 1300 361 505 / NZ: 0800 800 900
NZ: 0800 800 900
Vax Service line
---
Other Information
Vax
Service & Help
Vax Customer Careline AU: 1300 361 505 / NZ: 0800 800 900
Monday-Friday 8.30am to 5.00pm
Any queries or concerns about using the Vax, call the Vax Careline. Calls are charged at the
standard national rate.
Please make a note of the serial number and model number of the carpet cleaner before calling.
For the nearest Service Agent, please call the Vax Customer Careline or visit www.
vax.com.au
Technical Specification
Voltage: 220-240V ~50Hz
Wattage: 1200 W
Capacity: 1.5L
Filters: Pre-motor filter (washable)
HEPA 12 Antibacterial post-motor filter (lifetime – tap to clean)
VAU1200 / VAUW1200 VARU1200
Cord length:
6m 10m
Product weight:
Packaged weight:
Subject to technical change without notice.
N197
Waste electrical products should not be disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or retailer for recycling advice.
4.9kg 5.3kg
7.1kg 7.7kg
www.vax.com.au
9
---
Notes
10
Vax Service line
AU: 1300 361 505 / NZ: 0800 800 900
---
Notes
www.vax.com.au
11
---
Distributed by Techtronic Industries Pty. Ltd.
Level 1, 660 Doncaster Rd, Doncaster, Australia 3108.
www.vax.com.au. Service Line: AU: 1300 361 505 / NZ: 0800 800 900
Loading...