Vax V-2300U User Manual

Download

U87-VU-C UG_User guide 05/03/2013 17:33 Page 1

Bagless Upright V-2300U

User Guide

Vax Careline: (UK) 0844 412 8455

(ROI) 1-800 928 308

Get Cleaning...

What’s your Vax model number? (Located on the top flap of the packaging)

e.g. U88-VU-T-A

What’s your serial number? (Located on the base of the machine)

– – – – –

Note these down in case you need them in future. Please keep instructions for further use.

vax.co.uk

U88-VU-T-A, U87-VU-C

U87-VU-C UG_User guide 05/03/2013 17:33 Page 2

---

Machine Overview

Handle

1 2 TurboTool caddy (some models only) 3 Dirt container release button

Carry handle

4 5 Dirt container lid 6 Separator

Dirt container

Pre-motor filter housing

8 9 Brushbar height adjust

10 Cord storage hook

11 Cord 12 Cord safety hook 13 Hose storage 14 Power on/off button 15 Recline pedal 16 Hose 17 Extension tube 18 Crevice tool 19 Dusting brush 20 TurboTool 21 Flexi crevice tool (some models only) 22 Flat nozzle/upholstery tool

(some models only)

23 Pre-motor filter 24 Fur ‘n’ Fluff tool

(some models only)

3 4

PLEASE NOTE: some parts may vary according to model. Please check inside flap of box for more details.

Accessories

Unit

Filters

Vax Careline: (UK) 0844 412 8455

(ROI) 1-800 928 308

U87-VU-C UG_User guide 05/03/2013 17:33 Page 3

General Safety Information

FOR HOUSEHOLD USE ONLY.

When using the vacuum cleaner, basic safety precautions should always be observed, including the following:

. Only use the vacuum cleaner indoors on dry surfaces.

2. Turn off the vacuum cleaner controls before disconnecting or onnecting from the mains supply.

3. Always unplug the vacuum cleaner before connecting or isconnecting the vacuum hose and accessories.

. Children should be supervised to ensure that they do not play with

the appliance.

5. This appliance is not intended for use by persons (including

children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

6. Use only as described in this manual. Use only Vax

recommended attachments.

7. Do not use the vacuum cleaner if it has been dropped,

damaged, left outdoors or dropped into water. Do not use the vacuum cleaner with a damaged cord or plug. If the supply cord is damaged, it must be replaced by the manufacturer or a recommended Service Agent to avoid hazard and invalidating the guarantee.

8. Do not pull or carry by cord/hose. Do not use the cord/hose as

a handle, close a door on the cord/hose or pull cord/hose around sharp edges or corners. Do not run the vacuum cleaner over the cord/hose. Keep the cord away from heated surfaces.

9. Do not handle the plug or vacuum cleaner with wet hands. Do

not use outdoors or on wet surfaces.

10. Do not put any objects into openings. Do not use with any

openings blocked and do not restrict air-flow. Keep all openings free of dust, lint, hair or anything that might reduce airflow.

11. Keep hair, loose clothing, fingers and all parts of the body away

from openings and moving parts.

12. Do not pick up hot coals, cigarette butts, matches or any hot,

smoking or burning objects.

13. Do not pick up flammable or combustible materials (lighter fluid,

petrol, kerosene etc.) or use in the presence of explosive liquids or vapours.

14. Do not vacuum up harmful or toxic material (chlorine, bleach,

ammonia, drain cleaner etc.).

15. Do not vacuum up hard or sharp objects such as

glass, nails, screws, coins, etc.

16. Do not use without ALL of the filters in place.

7. Take extra care when vacuuming on stairs.

8. Keep vacuuming area well lit.

19. Store the vacuum cleaner in a cool, dry area.

20. Turn off the on/off switch before unplugging the vacuum cleaner

1. Use only CE-approved 13 amp extension cords. Non-approved

ords may overheat. Care should be taken to arrange the cord

c so that the cord cannot be tripped over.

ARNING: Always switch off and unplug the vacuum cleaner

from the electrical outlet before assembling, opening or emptying the dirt container, or before connecting/disconnecting the attachments.

CAUTION: The vacuum cleaner is a very powerful unit. Before plugging the cord into the electrical outlet, make sure the switch is in the ‘off’ position.

IMPORTANT: If the inlet, hose or telescopic tube is blocked, switch off the vacuum cleaner and remove the blockage(s) before restarting the vacuum cleaner. See Maintenance; Clearing Blockages.

IMPORTANT: Cleaning filters maintains vacuum performance. Vax recommends that your filters should be checked and cleaned periodically. If your filters are washable make sure they are completely dry before inserting back into the vacuum cleaner.

IMPORTANT:

If for any reason the unit should overheat, the thermostat will automatically turn the unit off. Should this occur, unplug the vacuum cleaner from the electrical outlet and turn off the switch. Remove dirt container and empty. Clean filters. Allow the unit to cool for approximately one (1) hour. To re-start, plug into an electrical outlet and switch back on.

This vacuum cleaner is intended for household use only and NOT for commercial or industrial use.

PLEASE KEEP INSTRUCTIONS FOR FURTHER USE.

The motor is equipped with a thermal cut-out.

vax.co.uk

U87-VU-C UG_User guide 05/03/2013 17:33 Page 4

---

Operation

Keep your Vax like new

performance of your machine. For best cleaning results, filters require

cleaning at least every three months. For full cleaning instructions,

see page 7.

filters in place.

Assembling your vacuum cleaner

Push the lower back panel onto the base of the unit.

Secure with the two long screws provided.

IMPORTANT: The condition of the filters affects the

IMPORTANT: Do not use the vacuum cleaner without all of the

Slide end of the hose into the hose connector.

Attach handle to the back panel by pushing down firmly.

Place pre-motor filter and holder onto the base of the unit.

Insert locking pin into place at the bottom of the handle.

Connect hose. Attach dirt container and click into

Secure locking pin with the small screw provided.

place.

Vax Careline: (UK) 0844 412 8455

(ROI) 1-800 928 308

U87-VU-C UG_User guide 05/03/2013 17:33 Page 5

Operation

Operating the appliance

Twist cord storage hook to release cord. Turn unit on.

Recline unit. In upright position turn brushbar

height adjust to desired setting.

High - long carpet pile and hard floors Low - short carpet pile

IMPORTANT: Vax recommends that you raise the height of the brushbar to the highest position when using

this cleaner on lino and hard flooring due to constant rotation. Vax cannot be held responsible for damage to

these surfaces if the customer fails to take notice of this recommendation.

IMPORTANT: When the

vacuum cleaner is stood in the

upright position or when using the

hose and tools, the brushbar height

adjust must be set to the highest

position.

vax.co.uk

U87-VU-C UG_User guide 05/03/2013 17:33 Page 6

---

Operation

Using accessories

NOTE: The crevice tool and TurboTool can be attached to both extension tube and hose directly.

NOTE: The dusting brush can only be attached to the hose directly.

NOTE: This unit has a constantly rotating brushbar. Vax recommends you raise the brushbar before

attaching accessories.

Attaching to hose

Remove hose from its holder and unwind hose from unit.

Choose an accessory. Attach accessory to hose.

Attaching to extension tube

Remove extension tube from holder. Attach extension tube to hose. Attach accessory to extension tube.

Vax Careline: (UK) 0844 412 8455

(ROI) 1-800 928 308

24hr

U87-VU-C UG_User guide 05/03/2013 17:33 Page 7

Maintenance (Keep your Vax as good as new)

Emptying and cleaning the dirt container

Cleaning the HEPA pre-motor filter

NOTE: Wash filters with warm water (40° C max) at least every 3 months for best cleaning results.

vax.co.uk

40° C

max

U87-VU-C UG_User guide 05/03/2013 17:33 Page 8

---

Maintenance (Keep your Vax as good as new)

Advanced filter cleaning

Vax Careline: (UK) 0844 412 8455

(ROI) 1-800 928 308

U87-VU-C UG_User guide 05/03/2013 17:33 Page 9

Maintenance (Keep your Vax as good as new)

Removing blockages

WARNING: To reduce the risk of electric shock, turn the vacuum cleaner off and unplug from the electrical

outlet before performing maintenance/troubleshooting checks. Disconnect the hose from the vacuum cleaner

and remove any blockages found then reconnect the hose securely.

Removing blockages from the brushbar

Unscrew the four screws on the base of unit.

Remove floor nozzle cover.

Lift brushbar. Remove the belt from

Removing blockages from the TurboTool (some models only)

Locking

ring

Turn the TurboTool over and slide off the locking ring.

Detach lower housing and remove blockage.

To re-assemble the TurboTool, ensure that the tabs are engaged and pivot the lower housing closed. Slip the locking ring over the neck of the TurboTool and into the groove to finish.

the end of the brushbar.

Tabs

vax.co.uk

(UK) 0844 412 8455

(ROI) 1-800 928 308

vax.co.uk

vaxireland.ie

This does not aect your statutory rights

Instead of taking me back

to the shop, simply call:

we’re here to help

U87-VU-C UG_User guide 05/03/2013 17:33 Page 10

---

FAQs

WARNING: to reduce the risk of personal injury, unplug the vacuum cleaner before performing maintenance/troubleshooting checks.

s there an accessory missing?

• Check the ‘Parts Overview’ page in this guide to make

sure the part is definitely included in your unit.

• If it is missing, we’re here to help. Simply call us on 844 412 8455

Why won’t the vacuum cleaner pick up?

• The dirt container may be incorrectly installed; remove the

dirt container from the unit by pressing the dirt container release button and then re-attaching it to the unit, ensuring it is locked firmly back into place.

• The filter may be clogged; refer to ‘Maintenance: Cleaning

the filters’ on page 7.

• The dirt container may be blocked; refer to ‘Maintenance:

Emptying and cleaning the dirt container’ on pages 7 and 8.

• There may be a blockage in the hose/tube; disconnect

from the vacuum cleaner. Carefully remove any blockages found and reconnect securely.

hy won’t the accessories pick up properly?

• Hose blockages: remove the hose from the unit. Carefully

remove any blockages found and reconnect hose securely.

• Accessory blockages: remove accessory from andle/tube. Carefully remove blockage and re-attach to

h the vacuum cleaner.

• The accessory may be faulty. Simply call us on

0844 412 8455 for assistance.

Why will the vacuum cleaner not run?

• It may not be plugged into the electrical outlet correctly;

ensure that the plug is pushed in securely.

• The electrical outlet may not be working properly; check

the fuse or breaker, or consult an electrician.

• The motor thermostat may have tripped; switch off and

unplug the vacuum cleaner, and leave for one hour before switching the cleaner back on.

Why is dust escaping from the vacuum?

• The filter may be clogged; refer to ‘Maintenance: Cleaning

the filters’ on pages 7 and 8.

• The dirt container may be blocked; refer to ‘Maintenance: Emptying and cleaning the dirt container’ on page 7.

• The dirt container may be incorrectly installed; remove the dirt container from the unit by pressing the dirt container release button and then re-attaching it to the unit, ensuring it is locked firmly back into place.

What do I do if the unit/an accessory becomes damaged or broken?

• We’re here to help. Simply call 0844 412 8455 or visit vax.co.uk

Vax Careline: (UK) 0844 412 8455

(ROI) 1-800 928 308

U87-VU-C UG_User guide 05/03/2013 17:33 Page 11

Other Information

UK Service & Help

Vax Customer Careline 0844 412 8455

Monday-Friday 8.30am to 6.30pm Saturday 9.00am to 5.00pm

If you have any queries about using your Vax, call the Vax Careline. Calls are charged at the UK national rate. Please make a note of the serial number and model number of the carpet cleaner before calling. For the nearest Service Agent, please call the Vax Customer Careline or visit vax.co.uk

Consumables

To purchase spares and accessories, please visit vax.co.uk

Pre-Motor filter (Type B): 1-1-130851-00

Technical Specification

Voltage: 220-240V ~50Hz Wattage: 2300W Capacity: 5L Filters: pre-motor filter (washable) Cord length: 10m (approx) Weight: 8.7kg - 8.9 kg (depending on model)

Subject to technical change without notice.

EEC Statement of Compliance

Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the

U87, U88-VU series is manufactured in compliance with the following Directives:

Safety: 2006/95/EC Low Voltage Directive

EMC: 2004/108/EC Electromagnetic Compatibility Directive

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.

Check with your Local Authority or retailer for recycling advice.

vax.co.uk

U87-VU-C UG_User guide 05/03/2013 17:33 Page 12

---

Vax Ltd., Kingswood Road, Hampton Lovett, Droitwich, Worcestershire, WR9 OQH, UK

Version 1.0

email: info@vax.co.uk - website: vax.co.uk

Vax V-2300U User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual