8
EEC STATEMENT OF COMPLIANCE
Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declares that the product
V-074 bagged cylinder is manufactured in compliance with
the following Directives:
Safety: 73/23/EEC Low Voltage Directive
EMC: 89/336/EEC Electromagnetic Compatibility Directive
Waste electrical products should not be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or retailer for recycling advice.
Vax Ltd., Kingswood Road, Hampton Lovett, Droitwich, Worcestershire WR9 0QH, UK
email: info@vax.co.uk - website: www.vax.co.uk
V-074_Artwork.qxd 30/3/06 12:50 Page 1
Instruction Manual
www.vax.co.uk
Vax Careline:
0870 6061248
Please read carefully before using
the cleaner. Always fully extend
the mains cable before use.
BAGGED CYLINDER VACUUM CLEANER
Vax Model Number: V-074
V-074_Artwork.qxd 30/3/06 12:50 Page 2
1
Carry handle
2
Hose Inlet
3
Bag full Indicator
4
Tool storage
(Inside machine)
5
Variable power switch
6
On/off button
7
Post-motor filter cover
8
Cable rewind
9
Wheel
2
P
arts Overview
Top cover
Paper dust bag
Pre-motor filter
11.. DDiiaaggrraamm
Fig.1/2
Fig.1/3
2
3
7
4
1
5
6
Fig.1/1
11
12
10
10
11
12
Parking slot
Plug
13
14
14
13
9
8
V-074_Artwork.qxd 30/3/06 12:50 Page 3
3
Accessories
AAcccceessssoorriieess
3
1
Combination floor head
2
Hose
3
Telescopic extension tubes
1
Upholstery tool
2
Dusting brush
3
Cr
evice tool
1
2
3
1
2
V-074_Artwork.qxd 30/3/06 12:50 Page 4
4
S
afety Information
2. Safety Information
FOR HOUSEHOLD USE ONLY. When using the
vacuum cleaner, basic safety precautions should
always be observed, including the following:
1. Only use the vacuum cleaner indoors on dry
surfaces.
2. Turn off the vacuum cleaner controls before
connecting to or disconnecting from the mains
supply.
3. Always unplug the vacuum cleaner before
connecting or disconnecting the vacuum hose.
4. Close attention is necessary when used by or near
children. Do not allow children to use as a toy.
5. Use only as described in this manual. Use only the
manufacturer’s recommended attachments.
6. Do not use the vacuum cleaner if it has been
dropped, damaged, left outdoors or dropped into
water. Do not use the vacuum cleaner with a
damaged cord or plug. If the supply cord or plug is
damaged, return the vacuum cleaner to a Vax
Authorised Service Agent or suitably qualified
person for examination, repair or adjustment.
7. Do not pull or carry by the cord. Do not use the
cord as a handle, close a door on the cord or pull
the cord around sharp edges or corners. Do not
run the vacuum cleaner over the cord. Keep the
cord away from heated surfaces.
8. Do not handle the plug or vacuum cleaner with
wet hands. Do not use outdoors or on wet
surfaces.
9. Do not put any objects into openings. Do not
use with any openings blocked and do not restrict
air flow. Keep all openings free of dust, lint, hair or
anything that may reduce airflow.
10. Keep hair, loose clothing, fingers and all parts
of the body away from openings and moving parts.
11. Do not pick up hot coals, cigarette butts,
matches or any hot, smoking or burning objects.
12. Do not pick up flammable or combustible
materials (lighter fluid, petrol, kerosene, etc) or use
in the pr
esence of explosive liquids or vapours.
13. Do not vacuum up harmful or toxic material
(chlorine bleach, ammonia, drain cleaner, etc).
14. Do not vacuum up hard or sharp objects such
as glass, nails, screws, coins, etc.
15. Do not use without the filters in place.
16. T
ake extra car
e when vacuuming on stairs.
17. Keep vacuuming area well lit.
18. Store the vacuum cleaner indoors in a cool, dry
area.
19. Turn off the switch before unplugging.
20. Use only CE-approved 13 amp extension
cords. Non-approved extension cords may
overheat. Care should be taken to arrange the cord
so that the cord cannot be pulled or tripped over.
WARNING: Always switch off and unplug the
vacuum cleaner from the electrical outlet before
assembling, opening or emptying the dust bag, or
before connecting/disconnecting the attachments.
CAUTION: The vacuum cleaner is a very powerful
unit. Before plugging the cord into the outlet make
sure the switch is in the ‘off’ position. Hold the
vacuum cleaner firmly when starting and in use.
IMPORTANT: If the inlet or hose is blocked, switch
off the vacuum cleaner and remove the blockage(s)
before re-starting the vacuum cleaner.
IMPORTANT: Washing filters and changing the
dust bag improves vacuum performance. Make
sure all filters are completely dry before inserting
back into the vacuum cleaner.
This vacuum cleaner is intended for household use
only and not for commercial or industrial use.
PLEASE KEEP THESE INSTRUCTIONS FOR
FURTHER USE.
Motor Thermostat
IMPORTANT: The motor is equipped with a
thermal cut-out. If for any reason, the vacuum
cleaner should over-heat, the thermostat will
automatically turn the unit off. Should this occur,
unplug the vacuum cleaner from the electrical
outlet and turn off the switch. Remove the dirt
container and empty. Clean the filters. Allow the
cleaner to cool for approximately one (1) hour. To
re-start, plug into an electrical outlet and switch
back on.
V-074_Artwork.qxd 30/3/06 12:50 Page 5
3. How to Assemble
IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet before assembling or
removing the accessories.
1. Insert the flexible hose into the inlet on the main
body of the vacuum cleaner. Push in until it clicks
into position (Fig.3/1).
2. Push the telescopic extension tube on to the
end of the handle (Fig.3/2).
3. The telescopic extension tube can be
lengthened or shortened by pushing the button in
and sliding the tube apart or together as required
(Fig.3/3).
4. Fit the combination floor head by pushing
onto the extension tube (Fig. 3/4).
4. How to Operate
Cord Release
Fully unwind the power cord. A yellow mark on the
power cord indicates the recommended cord
length. Do not exceed the cord length beyond the
red mark.
On/off Button
1. Insert the power plug into the electrical outlet.
Make sure the vacuum cleaner is switched off.
2. Press the on/off switch located on the top of
the vacuum cleaner, to switch on the vacuum
cleaner and press the button again to turn the
vacuum cleaner off.
Carpet Cleaning
For carpet and rug cleaning, press the rocker
switch on the combination floor head to raise the
brushes.
Hard Floor Cleaning
For hard floor cleaning, press the rocker switch on
the combination floor head to lower the brushes.
Cord Rewind
To rewind the power cord, press the cord rewind
button, located on the top of the vacuum cleaner,
and guide the power cord with one hand. This will
prevent the cord from whipping which could cause
damage or injury.
Variable Power
Located between the on/off and cord rewind
buttons there is a variable power switch. Slide this
forwards and backwards to adjust the suction
power.
Carry Handle
Use the carry handle located at the front of the
vacuum cleaner to move from room to room.
Hose Storage
For convenience, there is a slot located at the back
of the vacuum cleaner where the floor tool and
hose can be parked for carrying and storage.
5. Accessories
1. The accessories can be attached directly to
the handle by removing the telescopic tubes and
pushing in the desired accessory.
2. The accessories can also be attached to the
telescopic extension tube for extra r
each. Remove
the combination floor head and push on the
desir
ed accessory
.
Cr
evice tool:
for cr
evices, corners and cracks, etc.
Dusting brush: for delicate surfaces.
Upholstery tool: for carpet, upholstery, stairs, etc.
5
H
ow to Assemble/How to Operate/Accessories
Fig.3/1
Fig.3/2
Fig.3/3
Fig.3/4
V-074_Artwork.qxd 30/3/06 12:50 Page 6
D
irt Container & Filters: Removal & Replacement/Storage
6
6. Dirt Container & Filters: Removal
& Replacement
IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet before removing the dust
bag.
IMPORTANT: Do NOT use the vacuum cleaner
without ALL of the filters in place.
IMPORTANT: The vacuum cleaner is equipped
with a bag full indicator. If the indicator turns red,
the bag will need to be changed.
1. Turn off the vacuum cleaner and unplug from the
electrical outlet. Lift up the top cover to gain access
to the dust bag compartment. (Fig6/1)
2. Push in the tab to unlock the bag from position
and lift out. (Fig.6/2)
3. Dispose of the full dust bag and insert a new
dust bag. Click into place, then close the top cover
.
Pre Motor Filter:
1. T
ur
n of
f the vacuum cleaner and unplug fr
om the
electrical outlet. Lift up the top cover to gain access to
the dust bag compartment.
2. Lift out the pre-motor filter situated at the back of
the compartment (Fig.6/3) and replace with new one.
N.B. Vax recommend replacing the filter after 5 bag
changes or when it appears soiled.
Post Motor Filter:
1. Turn off the vacuum cleaner and unplug from the
electrical outlet.
2. Located at the rear of the vacuum cleaner is the
post-motor filter. This can be removed (Fig.6/4) and
replaced with a new one.
N.B. Vax recommend replacing the filter every 4-6
months, when the bag has been emptied 5 times,
when appearance is soiled or when loss of suction is
experienced (whichever is sooner).
Fig.6/4
Fig.6/3
Fig.6/1
Fig.6/2
7. Clearing Blockages
WARNING: To reduce the risk of electric shock,
the power cord must be disconnected before
performing maintenance/troubleshooting checks.
1. Switch the vacuum cleaner off and disconnect
the power plug from the electrical outlet.
2. The flexible hose can be disconnected from the
vacuum cleaner by pushing in the button on the
hose and pulling away
from the machine.
(Fig.7/1). Remove any
blockages found then
reconnect the hose
securely.
Fig.7/1
V-074_Artwork.qxd 30/3/06 12:50 Page 7
7
T
roubleshooting/UK Service & Help/Technical Specification
10. UK Service & Help
Vax Care 0870 6061248
Monday-Friday. 9.00am to 5.00pm.
An answerphone will be available out of these
hours. Any queries or concerns about using your
Vax, call the Vax Careline. Calls are charged at the
UK national rate.
Please make a note of the model number and serial
number of your Vax before calling. There are over
400 approved Vax Service Agents in the UK. For the
nearest Vax Service Agent, please call the Vax
Careline or visit www.vax.co.uk
www.vax.co.uk
11. Technical Specification
Voltage: 240V ~50Hz
Wattage: 1800W
Capacity: 2.6 litres
Filters: Fibre pre-motor filter
Fibre post-motor filter
Cord length: 4.6m
Weight: 6.3kg
Subject to technical change
without notice.
9. Troubleshooting
WWAARRNNIINNGG::
TO REDUCE RISK OF PERSONAL INJURY, UNPLUG VACUUM CLEANER BEFORE SERVICING
PROBLEM: Cleaner won’t run
CCaauussee::
Not properly plugged into electrical outlet.
Solution: Plug in firmly.
CCaauussee::
No electricity in electrical outlet.
Solution: Check fuse or breaker.
CCaauussee::
On/off switch not turned on.
Solution: Push on/off switch to on.
CCaauussee::
Motor thermostat has tripped.
Solution: Switch off and unplug cleaner. Leave for one (1) hour before switching the cleaner back on.
CCaauussee::
Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
PROBLEM: Vacuum cleaner won't pick up/loss of suction
CCaauussee::
Dust bag not installed correctly.
Solution: Review dust bag removal and replacement.
CCaauussee::
Dust bag full or blocked.
Solution: Replace dust bag.
CCaauussee::
Clogged filter.
Solution: Remove filter and clean.
CCaauussee::
Blockage in hose.
Solution: Disconnect hose, remove obstruction and then re-fit.
PROBLEM: Accessories won't pick up
CCaauussee::
Accessories not attached correctly.
Solution: Refer to page 5 for fitting information.
PROBLEM: Dust escaping from the vacuum cleaner
CCaauussee::
Dust bag full.
Solution: Dispose of dust bag and replace with a new one.
CCaauussee::
Dust bag not installed correctly.
Solution: Review dust bag removal and replacement.
CCaauussee::
Hose not installed correctly.
Solution: Review hose installation.
CCaauussee::
Filter not installed completely.
Solution: Review filter removal and replacement.
V-074_Artwork.qxd 30/3/06 12:50 Page 8
Loading...