Vax V-060A, V-060R, V-060PP, XTX, V-060PA Instruction Manual

www.vax.co.uk

Please read carefully before using this cleaner.

Always fully extend the mains cable before use.

Retain for future reference.

Vax careline

0870 6061248

instruction manual

Bagless upright

Vax model number:

V-060 Series

WARNING: This cleaner has a constantly

rotating brush bar which, when left in
contact with lino, parquet and other hard flooring
could potentially cause some damage to the floor
surface.

NOTE: Vax recommends that you raise the height
of the brush bar when using this cleaner on lino and
hard flooring. Vax cannot be held responsible for
damage to these surfaces if the customer fails to
take notice of this recommendation.

!

1. Diagram

www.vax.co.uk

2

parts overview

V-060

8

7

6

4

5

1

2

3

22

23

21

20

19

18

16

14

13

12

11

17

10

9

Fig.1/1

1 Cable clip
2 TurboTool
3 Dirt container release latch
4 Dirt container lid
5 Hose tube
6 Lower hose
7 Lower hose cuff
8 Clear dirt path window
9 Handle

10 Stair tool

(V-060R, V-060C)

11 Crevice Tool (inside extension tube)
12 Extension tube
13 Pleated HEPA filter (V-060, V-060U, V-060R)

HEPA, antibacterial & carbon filter (V-060P)

HEPA and carbon filter (V-060C)
14 Dirt container
15 Brushbar height adjust

16 Scuff guard bumper
17 Six (6) screws
18 Upper tool caddy
19 Hose clip
20 Back panel
21 On/off pedal
22 Handle release pedal
23 Swivel wheels
24 Power cord
25 Carry handle
26 Cord wrap with quick release
27 Dusting brush
28 3.1m stretch hose

(V-060, V-060U, V-060P)

4.2m super stretch hose

(V-060R, V-060C)

29 Hose Caddy

24

23

25

26

27

29

28

15

6x

WARNING: This cleaner has

a constantly rotating brush
bar which, when left in contact
with lino, parquet and other hard
flooring could potentially cause
some damage to the floor surface.

NOTE: Vax recommends that you
raise the height of the brush bar
when using this cleaner on lino
and hard flooring. Vax cannot be
held responsible for damage to
these surfaces if the customer
fails to take notice of this
recommendation.

!

!

3

V

ax Careline 0870 606 1248

safety information

2. Safety Information

For Household Use Only

When using the vacuum cleaner, basic safety precautions
should always be observed, including the following:

1. Only use the vacuum cleaner indoors on dry
surfaces.

2. Turn off the vacuum cleaner controls before
connecting or disconnecting from the mains supply.

3. Always unplug the vacuum cleaner before
connecting or disconnecting the vacuum hose and
accessories.

4. Children should be supervised to ensure that they
do not play with the appliance.

5. This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by
person responsible for their safety.

6. Use only as described in this manual.
Use only the manufacturer’s recommended
attachments.

7. Do not use the vacuum cleaner if it has been
dropped, damaged, left outdoors or dropped into
water. Do not use the vacuum cleaner with a
damaged cord or plug. If the supply cord or plug is
damaged, return the vacuum cleaner to a Vax
Authorised Service Agent or suitably qualified
person for examination, repair or adjustment.

8. Do not pull or carry by the cord. Do not use the cord
as a handle, close a door on the cord or pull the cord
around sharp edges or corners. Do not run the
vacuum cleaner over the cord. Keep the cord away
from heated surfaces.

9. Do not handle the plug or vacuum cleaner with wet
hands. Do not use outdoors or on wet surfaces.

10. Do not put any objects into openings. Do not use
with any openings blocked and do not restrict air
flow. Keep all openings free of dust, lint, hair or
anything that may reduce airflow.

11. Keep hair, loose clothing, fingers and all parts of the
body away from openings and moving parts.

12. Do not pick up hot coals, cigarette butts, matches or
any hot, smoking or burning objects.

13. Do not pick up flammable or combustible materials
(lighter fluid, petrol, kerosene, etc) or use in the
presence of explosive liquids or vapours.

14. Do not vacuum up harmful or toxic material (chlorine
bleach, ammonia, drain cleaner, etc).

15. Do not vacuum up hard or sharp objects such as
glass, nails, screws, coins, etc.

16. Do not use without the filters in place.

17. Take extra care when vacuuming on stairs.

18. Keep vacuuming area well lit.

19. Store the vacuum cleaner indoors in a cool, dry area.

20. Turn off the on/off switch before unplugging the
vacuum cleaner.

21. Use only CE-approved 13 amp extension cords. Non­approved extension cords may overheat. Care should
be taken to arrange the cord so that the cord cannot
be pulled or tripped over.

WARNING: Always switch off and unplug the

vacuum cleaner from the electrical outlet
before assembling, opening or emptying the dirt
container, or before connecting/disconnecting the
attachments.

CAUTION: The vacuum cleaner is a very

powerful unit. Before plugging the cord into
the electrical outlet, make sure the switch is in the
‘off’ position. Hold the vacuum cleaner firmly when
starting and in use.

IMPORTANT: If the inlet or hose is blocked,

switch off the vacuum cleaner and remove the
blockage(s) before re-starting the vacuum cleaner.

IMPORTANT: Cleaning filters improves vacuum

performance. For models with filters that have
washable outers (V-060P, V-060C), please note the
filters must be given 24 hours to dry after rinsing
befroe being placed back into the cleaner.

This vacuum cleaner is intended for household use
only and not for commercial or industrial use.

!!!

!

Motor Thermostat

IMPORTANT: The motor is equipped with a thermal cut-

out. If for any reason, the vacuum cleaner should over­heat, the thermostat will automatically turn the unit off.
Should this occur, unplug the vacuum cleaner from the
electrical outlet and turn off the switch. Remove the dirt
container and empty. Clean the filters. Allow the cleaner
to cool for approximately one (1) hour. To re-start, plug
into an electrical outlet and switch back on.

Soft-start

IMPORTANT: Models V-060U, V-060R, V-060P, V-060C

are fitted with a soft-start system. When the unit is
switched on, the motor will take a few seconds to build up
to full power. The purpose of this function is to offer
better protection to the vacuum motor.

www.vax.co.uk

4

assembly

3. How to Assemble

IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet before assembling or

removing the accessories.

Tool required: Phillips screwdriver

1. Slide the back panel onto the base (Fig.3/1). Connect
lower hose to base by sliding it over the connector and
twisting to secure.

2. To secure, insert the two (2) screws into the front of the
back panel (Fig.3/2).

3. Slide the end of the hose onto the back panel inlet. Turn
anti-clockwise to secure (Fig.3/3).

4. Align the carry handle holes with the holes on the back
panel. Slide the handle forward. Insert two (2) screws into
the holes and tighten until secure (Fig.3/4).

5. Place the upper handle onto the upright back panel
(Fig.3/5).

6. Attach the TurboTool clip into the TurboTool caddy
(Fig.3/6).

7. Place the TurboTool caddy onto the front of the vacuum
lower handle (Fig.3/7).

Fig.3/1

Fig.3/5

Fig.3/6

Fig.3/7

Fig.3/2

Fig.3/3

Fig.3/4

!

5

V

ax Careline 0870 606 1248

assembly

8. Insert the two (2) screws into the back of the handle
and screw them into the tool caddy. Tighten until secure
(Fig.3/8).

9. Clip the TurboTool® onto the front of the TurboTool®
caddy (Fig.3/9).

10. Wrap the hose around the back of the hose caddy.
Push the hose tube down into the right side of the cleaner
to secure (Fig.3/10).

11. Align the tabs on the clear dirt path window with the
slots on the lower hose cuff. Push and turn the hose
clockwise until secure (Fig.3/11).

12. Attach the tools. Slide the dusting brush onto the post
in the upper tool caddy with the bristles facing out
(Fig.3/12A). Slide the extension tube/crevice tool into the
round opening on the front of the right side of the tool
caddy. Insert the stair cleaning tool into the top of the
extension tube (Fig.3/12B)

(V-060R, C-060C only).

13. Ensure the filter is secure by pressing it firmly into its
holding in the bottom of the dirt container. Align the slots
on the lid with the tabs on the dirt container. Push the lid
down and twist clockwise. Use the arrow marked on the lid
to ensure that the dirt container and lid are aligned
properly (Fig.3/13).

14. Insert the tab on the bottom of the dirt container into
the rectangular slot on the cleaner (Fig.3/14).

Fig.3/8

Fig.3/9

Fig.3/13

Fig.3/10

Fig.3/11

Fig.3/12

AB

www.vax.co.uk

6

assembly / operation

15. To secure the dirt container push the top in place,
there will be an audible click when it is secure (Fig.3/15).

4. How to Operate

Cord Release

Release the power cord by turning the quick cord release.
The cord should be inserted into the cord guide while
vacuuming to keep it out of the way (Fig.4/1)

Adjustment for Different Floor Types

Slide the height adjust lever to match the surface being
cleaned (Fig.4/2).

NOTE: For easiest adjustment, place cleaner in full
upright position.

CAUTION: The brushbar continues to rotate at

all times while the vacuum cleaner is on. Keep
hair, loose clothing, fingers and all parts of the body
away from the brush area while the vacuum cleaner
is on. The vacuum cleaner must be in the upright
position to lift the rotating brushbar off the carpet

!

Fig.3/14

Fig.3/15

Fig.4/1

Fig.4/2

WARNING: This cleaner has a constantly

rotating brush bar which, when left in contact
with lino, parquet and other hard flooring could
potentially cause some damage to the floor surface.

NOTE: Vax recommends that you raise the height of
the brush bar when using this cleaner on lino and hard
flooring. Vax cannot be held responsible for damage to
these surfaces if the customer fails to take notice of
this recommendation.

!

7

V

ax Careline 0870 606 1248

operation / accessories

when cleaning above the floor. Vax recommend that
the brushbar height adjust is turned to its highest
position when using the tools.

On/off Pedal

Plug the cord into the electrical outlet. Turn the vacuum
cleaner on by depressing the foot switch located on the
back left side of the vacuum cleaner (Fig.4/3A). The
vacuum cleaner can be turned off by pressing the on/off
switch again.

Handle Release Pedal

To release the handle, push the handle release pedal
located on the lower left side of the cleaner (Fig.4/3B).

Carpet Cleaning

Move the handle to the desired position for storage (A),
and normal operation (B). De-press the handle release
pedal again to clean under furniture (C) (Fig.4/4).

IMPORTANT: This vacuum cleaner is not

intended for use on hard floors. The powerful
rotating brush bar is designed to groom carpet pile and
could cause damage to some hard floor types.

5. Accessories

IMPORTANT: The vacuum cleaner must be in the

upright position to raise the brushbar. The
brushbar height adjust must also be at its highest
position.

1. Remove the hose from the tool caddy (Fig.5/1).

2. Choose any of the handy on-board accessories or use
the hose alone. Simply push the attachment firmly onto
the end of the extension tube or hose handle. To remove
the accessory, twist and pull apart gently (Fig.5/2).

Extension Tube

If additional length is needed, use the extension tube
and/or crevice tool. Pull the crevice tool out of the
extension tube or hose handle. To remove the tool, twist
and pull apart gently.

NOTE: The crevice tool is stored inside the extension
tube (Fig.5/3).

!

!

B

C

A

Fig.4/4

AB

Fig.4/3

Fig.5/1

Fig.5/2

Fig.5/3

www.vax.co.uk

8

accessories / dirt container & filter

Crevice tool: for crevices, corners and cracks etc.

Dusting brush: for delicate surfaces and skirting board.

Stair tool (V-060R, V-060C only): for stairs, upholstery

and curtains. Twist the head tool for best contact with
stair treads and risers (Fig.5/4).

TurboTool: for excellent pick up of pet hair and for stair
and upholstery cleaning. Attach to hose tube or extension
tube as per all other accessories. For best results, use
backward strokes on the surface you are cleaning.

Carry Handle

Use the carry handle on the back of the vacuum cleaner to
move the cleaner from room to room (Fig.5/5).

NOTE: Check that the dirt container is securely in place
before lifting the vacuum cleaner.

6. Dirt Container & Filter:
Removal and Replacement

WARNING: To reduce the risk of injury from

moving parts, unplug before servicing.

NOTE: Unplug the vacuum cleaner before changing filter.

NOTE: For best performance, replace filter annually.
Cleaning the Central Filter

1. Press the latch above the dirt container and remove the
dirt container from the vacuum cleaner (Fig.6/1).

2. Remove the dirt container lid by turning it anti­clockwise (Fig.6/2).

3. Hold the dirt container and grasp the top of the filter.
Twist and pull the filter up and out (Fig.6/3).

!

Fig.5/4

Fig.5/5

Fig.6/1

Fig.6/2

Fig.6/3