BAGLESS HANDHELD VACUUM CLEANER
Vax Model Number: V-039
Vax Careline:
0870 6061248
Instruction Manual
Please read carefully before using
the vacuum cleaner. Always fully
extend the mains cable before use.
www.vax.co.uk
2
1. Diagram
1 Vacuum cleaner
2 Shoulder strap
3 Combination floor tool 8
4 Storage bag
5 Crevice tool (located on unit) 6
6 Narrow nozzle adapter 7
7 Brush tool (located on unit) 5
8 Oval nozzle adapter 3
9 Connector 4
10 Large inflator adapter 10
11 Medium inflator adapter 10
12 Small inflator adapter 10
13 Flexible hose (long) 9
14 Cleaning brush 13
15 Hose handle 14
16 3 extension tubes 2
17 Flexible hose (grey), inflator hose 9
1
Fig.1
Fig.1/1
On/off switch
Fig.1/2
Transparent dust container
window
Fig.1/3
Dust container release
button
2
3
4
5
6
7
8
9
10
12
11
13
14
15
16
17
3
Parts Overview
2. Safety Information
FOR HOUSEHOLD USE ONLY
When using the vacuum cleaner, basic safety
precautions should always be observed, including the
following:
1. Only use the vacuum cleaner indoors on dry
surfaces.
2. Turn off the vacuum cleaner controls before
connecting to or disconnecting from the mains
supply.
3. Always unplug the vacuum cleaner before
connecting or disconnecting the vacuum hose.
Do not allow the plug to whip when rewinding.
4. Close attention is necessary when used by or near
children. Do not allow children to use as a toy.
5. Use only as described in this manual. Use only
the manufacturer’s recommended attachments.
6. Do not use the vacuum cleaner with a
damaged cord or plug. Do not use the vacuum
cleaner if it has been dropped, damaged, left
outdoors or dropped into water. Return the
vacuum cleaner to a Vax Authorised Service
Agent or suitably qualified person for examination,
repair or adjustment.
7. Do not pull or carry by the cord. Do not use the
cord as a handle, close a door on the cord or
pull the cord around sharp edges or corners. Do
not run the vacuum cleaner over the cord. Keep
the cord away from heated surfaces.
8. Do not handle the plug or vacuum cleaner with wet
hands. Do not use outdoors or on wet surfaces.
9. Do not put any objects into openings. Do not
use with any openings blocked and do not
restrict air flow. Keep all openings free of dust,
lint, hair or anything that may reduce airflow.
10. Keep hair, loose clothing, fingers and all parts of
body away from openings and moving parts.
11. Do not pick up hot coals, cigarette butts,matches
or any hot, smoking or burning objects.
12. Do not pick up flammable or combustible
materials (lighter fluid, petrol, kerosene, etc) or
use in the presence of explosive liquids or
vapours.
13. Do not vacuum up harmful or toxic material
(chlorine bleach, ammonia, drain cleaner, etc).
14. Do not vacuum up hard or sharp objects such
as glass, nails, screws, coins, etc.
15. Do not use without the filters in place.
16. Use extra care when vacuuming on stairs.
17. Keep vacuuming area well lit.
18. Store the vacuum indoors in a cool, dry area.
19. Turn off the switch before unplugging.
20. Use only CE-approved 13A extension cords.
Non-approved extension cords may overheat.
Care should be taken to arrange the cord so
that the cord cannot be pulled or tripped over.
WARNING:
FOR BLOWING AND INFLATOR OPERATION:
1. The blower and inflator operation of the vacuum
cleaner can result in foreign objects being blown
into eyes, which can result in eye damage.
Always wear eye protection (not provided) when
operating as blower or inflator.
2. Do not permanently cover openings of
inflator accessories.
3. Take care when using inflator accessories, as
some surfaces may become warm.
4. Do not leave the vacuum cleaner unattended
when inflating any items.
WARNING: Do not point air outlet openings at people
or animals.
WARNING: Always switch off and unplug the vacuum
cleaner from electrical outlet before assembling,
opening or emptying the dust container, or
connecting/disconnecting the attachments.
CAUTION: Keep the suction intake opening free from
obstruction at all times; otherwise the motor will
overheat and vacuum cleaner damage may result.
CAUTION: The vacuum cleaner is a very powerful
unit. Before plugging cord into outlet make sure the
switch is in the ‘off’ position. Hold the vacuum cleaner
firmly when starting and in use.
IMPORTANT: If the vacuum inlet or hose are blocked,
switch off the vacuum cleaner and remove the
blockage(s) before starting the vacuum cleaner.
IMPORTANT: Washing filters improves vacuum
performance. Make sure all filters are completely dry
before inserting back in the vacuum cleaner.
This vacuum cleaner is intended for household use
only and not for commercial or industrial use.
The vacuum cleaner is fitted with a thermal cut-out
which switches the vacuum cleaner off automatically.
Should this happen, turn the vacuum cleaner ‘off’,
allow the unit to cool for an hour, check and clean
filter system and switch back ‘on’.
4
Safety Information
PLEASE KEEP THESE INSTRUCTIONS FOR
FURTHER USE.
3. Use & Function
To turn the vacuum cleaner on, press the ‘on’ switch.
To turn off, press the ‘off’ switch.
4. Vacuum Accessories
Accessories contained in vacuum cleaner
Two of the on-board accessories are stored in the
vacuum cleaner; the brush tool 7 and the crevice tool
5. They are positioned as shown in Fig.2.
For insertion of these tools into the suction
opening see Fig.3.
How to connect the connection piece
Before using, please check that ‘this side up BLOW’
and ‘this side up SUCK’ are shown on the two sides
of the universal adapter (part no. 4 ). Make sure the
suck side is uppermost when using as a cleaner
(Fig.4). This fitting is only suitable for suction.
Carpets & Hard Floors
The combination floor tool 3, has two positions, depending
on the floor type:
1. Hard floors (tiles, parquet, etc): the brushes on the
combination floor tool must be lowered, by pressing
the rocker switch as shown in (a).
1. Carpets or rugs: the brushes on the combination
floor tool must be raised, by pressing the rocker
switch as shown in (b).
NOTE: Make sure accessories are securely attached
before use.
5. Blower/Inflator Accessories
WARNING: Always wear eye protection when operating
as blower or inflator. Clean the vacuum before using for
blowing or inflating.
CAUTION: Make sure the accessories are securely
attached before use. When using the accessory hose for
blowing or inflating, hold the hose end securely before
turning ‘on’ and during use.
Fig.2
Fig.3
Fig.4
Fig.5
5
Use & Function/Vacuum Accessories/Blower/Inflator Accessories
How to connect the accessories
The accessories provided can be used in
various combinations, depending on the task.
Refer to Fig.6 for suggested combinations of
accessories to complete some typical tasks.
Fig.6
Vacuum Accessories/Blower/Inflator Accessories
6
Fig.7 shows two typical arrangements of accessories to
carry out either blowing or inflation. For increased
flexibility in blowing, it is also possible to fit the tubes to
the end of the hose.
Blower
To attach the blowing adapter, open the rear door by
pulling on the top recess as shown in Fig.8.
Insert the flexible grey inflator hose 9 into the
opening as shown in Fig.9.
Fit the inflation adapter on to the hose, aligning the tab
on the adapter with the hole in the hose adapter as
shown in Fig.10.
Push adapter in direction of arrow until it clicks.
To remove, lift the tab up and pull off the adapter.
During inflation, control the airflow and pressure by
covering the air bypass hole with a thumb as shown in
Fig.11.
NOTE: Ensure that the flexible hose is clean inside
before inflation.
CAUTION: Do not permanently cover the air bypass
hole.
CAUTION: Unplug the vacuum cleaner before
performing any maintenance.
WARNING: The air holes on the inflation adapter
serve to prevent the object being inflated from
bursting under the high inflation pressure. Ensure that
these holes are never blocked.
Fig.8
Blower/Inflator Accessories
Fig.9
Fig.10
Fig. 11
7
Fig.7
6. Cleaning the Vacuum Cleaner
IMPORTANT: Switch off and unplug the vacuum
cleaner before performing any maintenance.
The vacuum cleaner is equipped with a transparent
window on the dust container as shown in Fig.12. When
the dust container is full or the filters are clogged or when
the vacuum cleaner suction power becomes low and you
see the container is full, the vacuum cleaner should be
switched off and emptied. The filters should also be
cleaned and the accessories checked for blockages.
After emptying the container or removing the blockage
the vacuum cleaner can be turned on and vacuuming
continued.
Grasp the unit as shown in Fig.13 with a thumb
pushing down on the release button and the dust
container cover will open so that the dust can be
removed.
7. Removing the Filters
Switch off and unplug the vacuum cleaner before
performing any maintenance.
WARNING: Do not operate the vacuum cleaner
without filters in place.
The vacuum cleaner comes equipped with a
permanent filter in the container plus an air
outlet filter. The vacuum cleaner should be switched off
and unplugged before removing the filter. Remove the
permanent filter from the vacuum cleaner as shown in
Fig.14. To remove the permanent pleated
filter from the filter basket, remove it as shown in Fig.15.
Both filters can be cleaned by shaking out the dust.
To replace the filters simply reverse the process, making
sure the permanent pleated filter is located in the hook
on the bottom face of the unit. To clean the air
outlet filter, open the rear air outlet grille and pull the filter
out of the recess. Shake and tap the filter out and
replace it.
Fig.13
Fig.14
Fig.15
Cleaning the Vacuum Cleaner/Removing the Filters
8
Fig.12
Storage/Maintenance
9
8. Storage
WARNING: Make sure the vacuum cleaner is
unplugged before wrapping the cord around the
vacuum cleaner.
The electrical cord is wrapped around the vacuum
cleaner for storage as shown in Fig.16. Apart from
accessories 5 and 7 (contained in the vacuum
cleaner), all other accessories can be stored in the
storage bag.
9. Maintenance
IMPORTANT: Switch off and unplug the vacuum
cleaner before performing any maintenance.
Use only mild soap and a damp cloth to clean the
vacuum cleaner. Never let any liquid get inside the
vacuum cleaner; never immerse any part of the
vacuum cleaner in a liquid.
NOTE: Make sure that the vacuum cleaner is
completely dry before using it.
IMPORTANT: To ensure vacuum cleaner safety and
reliability, repairs, maintenance and adjustments (other
than those listed in this user guide) should be carried
out only by the Vax Authorised Service Centre.
This vacuum cleaner is not intended for
commercial use.
Fig.16
Troubleshooting/Technical Specification
10. Troubleshooting
PROBLEM: Vacuum cleaner won't run
Cause: Power cord not firmly pushed into mains socket.
Solution: Plug cord in firmly to power outlet.
Cause: Blown fuse or tripped circuit breaker.
Solution: Check fuse/breaker. Replace fuse or reset breaker.
Cause: Thermal cut out operates.
Solution: Switch off vacuum cleaner and unplug from mains socket. Leave vacuum cleaner for at least 1 hour and
clean filters and change dust bag in the meantime.
PROBLEM: Vacuum cleaner won't pick up/loss of suction/loss of blow operation
Cause: Nozzle/dirt passage clogged.
Solution: Remove obstruction.
Cause: Filters are clogged.
Solution: Replace filters.
Cause: Accessories not attached correctly.
Solution: Check the accessories are firmly connected.
Cause: Combination floor tool in wrong position
Solution: Check the rocker is in the correct position for carpets or hard floors.
PROBLEM: Dust escaping from vacuum cleaner
Cause: Dust container full.
Solution: Empty the dust container.
11. Technical Specification
Power supply: 220-240V/50Hz
Motor power: 900W (max)
Dust container: Bagless
Dust container volume: 1 litre
Filter system: Permanent filter
Air outlet filter
Cord length: 6 metres
Weight: 2.5kg
Subject to technical change without notice.
10
11
This page has been intentionally left blank.
EEC STATEMENT OF COMPLIANCE
Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the product
V-039 Ultra Hand Vac is manufactured in compliance with the following:
Safety: 73/23/EEC Low Voltage Directive as modified by 93/68/EEC
EMC: 89/336/EEC Electromagnetic compatibility Directive as modified by 93/68/EEC
Waste electrical products should not be disposed of with household waste. Please recycle where
facilities exist. Check with you local Authority or retailer for recycling advice.
Vax Ltd., Kingswood Road, Hampton Lovett, Droitwich, Worcestershire, WR9 OQH, UK.
email: enquiry@vax.co.uk - website: www.vax.co.uk
Version 1
Loading...