Vax V-037 User Manual

UK SERVICE & HELP - VAX CARE 0870 6061248

Mon-Fri. 9.00am to 5.00pm. An answer phone is available out of these hours. If you have queries or concerns about using your VAX, call the HELPLINE. Calls are charged at the UK national rate.

Please make a note of the serial number and model number of your VAX before calling. There are over 400 approved VAX Service Agents in the UK . For your nearest Service Agent please call VAX Care.

V-037 Easy Guide

2

1 Hanging loop
2 Vac on/off button
3 Vac on/off lock
4 Mid-handle grip
5 Cleaning solution tank
6 Dust canister release button
7 Dust canister
8 Mop head
9 Vacuum cleaner nozzle
10 Cleaning pads

11 Charger
12 Multi Hard Floor cleaner
13 Solution dispensing trigger
14 Solution tank release button
15 Charger input
16 Charging indicator

*NOT MEANT FOR USE

WITH WAX BASED FLOORS

Parts checklist

1

2

3

4

5

6

7

9

8

10

11

12

13

4

5

14

15

16

FRONT BACK

3

To assemble the handle:

Insert the handle into the body of the unit and
push down firmly until it locks into place. Be sure
to line up the button on the handle with the notch
on the body, to help guide the lower handle into
the body. The pin should be visible in the hole on
the body.

NOTE: The vacuum may turn on during
handle assembly. To turn the vacuum off, press
the trigger on the handle once.

To disassemble the handle: Use a ball point
pen to push the button in while pulling the handle
up and out of the body of the cleaner.

Connect the charger to a wall socket.
NOTE: Charge for 24 hours before first use.

Plug the charger end into the side of the unit.

NOTE: The indicator light will come on to
indicate that the appliance is charging. Unit
will be charged in 16-24 hours. The light will
not change colour when the unit is charged.

Putting your cleaner together Charging

NOTE: Only use the charger supplied.

CHARGE 24 HOURS BEFORE FIRST USE.

Notch

Top view of cleaner

Storage Recommended use

Use the storage hook to hang the cleaner up.
NOTE: Hang in a place convenient for charging.

Use the dry vacuum to remove loose dirt and debris
from floors.

Wet mop by dispensing the cleaning solution and
using an absorbent pad to remove dirt and grime.

1

2

3

4