Vax Astrata Power VZL-401 Instruction Manual
www.vax.co.uk
Please read carefully before using this cleaner.
Always fully extend the mains cable before use.
Retain for future reference.
Vax careline
0870 6061248
instruction manual
Bagless upright
Vax model number:
VZL-401
Vax VXL 401 User Guide.qxd:VZL-401 User Guide 13/6/07 18:01 Page 1
VZL-401
1. Diagram
www.vax.co.uk
2
parts overview
1 Handle Grip
2 Handle
3 TurboTool
4 Carry Handle
5 Pre-motor filter assembly (located
behind dirt container)
6 Post-motor filter assembly
(located under dirt container)
7 Dirt container release button
8 Dirt Container
9 Central Dust Chamber
10 Bin release empty button (located
on the back of the dirt container)
11 Headlight
12 Carpet Height Adjuster
13 Scuff guard bumper
14 Dust Brush / Upholstery Tool
15 Hose caddy
16 Upper Cord Wrap
17 Crevice Tool and extension wand
18 On/ off pedal
19 Lower Cord Wrap
20 Handle Release Pedal
21 Upper hose
22 Power Cord
23 Lower Hose
24 Wheels
Fig.1/1
3
2
1
4
8
9
10
11
13
12
5
6
21
22
23
24
15
14
16
19
18
20
17
7
Vax VXL 401 User Guide.qxd:VZL-401 User Guide 13/6/07 18:01 Page 2
3
V
ax Careline 0870 606 1248
safety information
2. Safety Information
For Household Use Only
When using the vacuum cleaner, basic safety precautions
should always be observed, including the following:
1. Only use the vacuum cleaner indoors on dry
surfaces.
2. Turn off the vacuum cleaner controls before
connecting or disconnecting from the mains supply.
3. Always unplug the vacuum cleaner before
connecting or disconnecting the vacuum hose and
accessories.
4. Close attention is necessary when used by or near
children. Do not allow children to use as
a toy.
5. Use only as described in this manual.
Use only the manufacturer’s recommended
attachments.
6. Do not use the vacuum cleaner if it has been
dropped, damaged, left outdoors or dropped into
water. Do not use the vacuum cleaner with a
damaged cord or plug. If the supply cord or plug is
damaged, return the vacuum cleaner to a Vax
Authorised Service Agent or suitably qualified
person for examination, repair or adjustment.
7. Do not pull or carry by the cord. Do not use the cord
as a handle, close a door on the cord or pull the cord
around sharp edges or corners. Do not run the
vacuum cleaner over the cord. Keep the cord away
from heated surfaces.
8. Do not handle the plug or vacuum cleaner with wet
hands. Do not use outdoors or on wet surfaces.
9. Do not put any objects into openings. Do not use
with any openings blocked and do not restrict air
flow. Keep all openings free of dust, lint, hair or
anything that may reduce airflow.
10. Keep hair, loose clothing, fingers and all parts of the
body away from openings and moving parts.
11. Do not pick up hot coals, cigarette butts, matches or
any hot, smoking or burning objects.
12. Do not pick up flammable or combustible materials
(lighter fluid, petrol, kerosene, etc) or use in the
presence of explosive liquids or vapours.
13. Do not vacuum up harmful or toxic material (chlorine
bleach, ammonia, drain cleaner, etc).
14. Do not vacuum up hard or sharp objects such as
glass, nails, screws, coins, etc.
15. Do not use without the filters in place.
16. Take extra care when vacuuming on stairs.
17. Keep vacuuming area well lit.
18. Store the vacuum cleaner indoors in a cool, dry area.
19. Turn off the on/off switch before unplugging the
vacuum cleaner.
20. Use only CE-approved 13 amp extension cords. Nonapproved extension cords may overheat. Care should
be taken to arrange the cord so that the cord cannot
be pulled or tripped over.
WARNING: Always switch off and unplug the
vacuum cleaner from the electrical outlet
before assembling, opening or emptying the dirt
container, or before connecting/disconnecting the
attachments.
CAUTION: The vacuum cleaner is a very
powerful unit. Before plugging the cord into
the electrical outlet, make sure the switch is in the
‘off’ position. Hold the vacuum cleaner firmly when
starting and in use.
IMPORTANT: If the inlet, hose or extension
tube is blocked, switch off the vacuum cleaner and
remove the blockage(s) before re-starting the
vacuum cleaner.
IMPORTANT: Cleaning filters regularly improves
vacuum performance. Make sure all filters are
replaced back into the vacuum cleaner before using.
This vacuum cleaner is intended for household use
only and not for commercial or industrial use.
PLEASE KEEP THESE INSTRUCTIONS FOR
FURTHER USE.
!!!
!
Motor Thermostat
IMPORTANT: The motor is equipped with a
thermal cut-out. If for any reason, the
vacuum cleaner should over-heat, the thermostat
will automatically turn the unit off. Should this
occur, unplug the vacuum cleaner from the
electrical outlet and turn off the switch. Remove
the dirt container and empty. Clean the filters.
Allow the cleaner to cool for approximately one
(1) hour. To re-start, plug into an electrical outlet
and switch back on.
!
Vax VXL 401 User Guide.qxd:VZL-401 User Guide 13/6/07 18:01 Page 3
www.vax.co.uk
4
how to assemble / how to operate
3. How to assemble
Handle Assembly
Slide handle piece into slot in the back of the unit. Insert
screws into holes indicated (Fig.3/1).
Tool Storage
Attach tools: (a) Clip the dusting brush into the holster at
the side of the cleaner with bristles facing out. (b) Insert
the crevice tool and extension wand into the slots on the
side of the cleaner (Fig.3/2). (c) Clip Turbo Tool onto the
front of the cleaner (Fig.3/2).
4. How to operate
Cord release
Turn Upper Cord Release for easy cord removal (Fig.4/1).
Carpet height adjuster
Turn the carpet height adjuster knob to match the
surface being cleaned (Fig.4/2).
IMPORTANT: For easiest adjustment, place
cleaner in full upright position.
On/Off Switch
Plug cord into electrical outlet. Turn cleaner on by
pressing the on/off switch located on the lower back
of unit.
Handle Release Pedal
To release handle, push the handle release pedal located
on the lower left side of the cleaner (Fig.4/3).
CAUTION: Brushbar continues to rotate while
hose is removed or in use and at all times
while cleaner is on. Keep hair, loose clothing, fingers,
and all parts of body away from brush area while
cleaner is on. Cleaner must be in the upright position
to lift the rotating brush off the carpet when
cleaning above the floor.
Fig.3/2
Fig.4/1
Fig.4/2
Fig.4/3
!
!
Cord Release
Height adjuster
Fig.3/1
Vax VXL 401 User Guide.qxd:VZL-401 User Guide 13/6/07 18:01 Page 4
Loading...