Page 1
Bagless Upright
User Guide
Vax Careline: AU: 1300 361 505
NZ: 0800 800 900
Get Cleaning...
What’s your Vax’s model number?
V A F T H U
What’s your serial number?
Note these down in case you need them in future. Please keep instructions for further use.
vax.com.au VAFTHU
(Located on the base of the machine)
Page 2
Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
vax.com.au
Page 3
Machine Overview
1 Telescopic extension tube / handle
2 Handle height adjuster
3 Dirt container release button
4 Carry handle
5 Power on/o button
6 Inner cyclones
7 Dirt container
8 Hose
9 Hose to machine connector
10 Height adjustment
11 Hose extension tube connector
12 Handle cord hook
(for attaching the cord when the
machine is in use)
13 Handle release button
14 Turbo tool caddy
15 Upper cord hook
16 3-in-1 crevice, upholstery and
dusting brush tool
17 Cord
18 Lower cord hook
19 Turbo tool
20 Hard oor tool
21 Pre-motor lter
22 HEPA H12 antibacterial post motor lter
3
5
8
9
10
11
1
12
2
4
13
14
6
15
7
17
16
18
PLEASE NOTE: some parts may vary
according to model. Please check inside ap
of box for more details.
Accessories
19
16
vax.com.au 2
Unit
1
20
Filters
21
22
Page 4
vax.com.au
General Safety Information
FOR HOUSEHOLD USE ONLY.
When using the vacuum cleaner, basic safety precautions should
always be observed, including the following:
1. Only use the vacuum cleaner indoors on dry surfaces.
2. Turn off the on/off switch on the vacuum cleaner controls
before disconnecting or connecting from the mains supply.
3. Always unplug the vacuum cleaner before connecting or
disconnecting the vacuum hose and accessories.
4. Children should be supervised to ensure that they do not play
with the appliance.
5. This appliance is not intended for use by children and persons
with reduced physical, sensory or mental capabilities or lack
of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance
in a safe way and understands the hazards involved.
6. Cleaning and maintenance shall not be made by children.
7. The appliance should only be used as described in this
user guide.
8. Only Vax recommended attachments should be used with
this appliance.
9. Do not use this vacuum cleaner if it has been dropped,
damaged, left outdoors or dropped into water. Do not use this
vacuum cleaner with a damaged cord or plug.
10. Do not pull or carry this appliance by the cord. Do not use the
cord as a handle, close a door on the cord or pull the cord
around sharp edges or corners. Do not run the vacuum cleaner
over the cord. Keep the cord away from heated surfaces.
11. Do not handle the plug or the vacuum cleaner with wet hands.
12. Keep hair, loose clothing, fingers and all parts of the body away
from openings and moving parts.
13. Do not pick up any hot coals, ash, cigarette butts, matches or
any hot, smoking or burning objects.
14. Do not pick up any flammable or combustible materials (lighter
fluid, petrol, kerosene etc.) or use in the presence of explosive
liquids or vapours.
15. Do not vacuum harmful or toxic material (chlorine, bleach,
ammonia, drain cleaner etc.).
16. Do not vacuum hard or sharp objects such as glass, nails,
screws, coins etc.
17. Do not vacuum plaster dust, concrete dust or any other building
or vitreous materials.
18. Do not vacuum baking soda or any other powder-based carpet
refresher or deodoriser.
19. Store the vacuum cleaner in a cool, dry area.
20. Use only SAA approved 10amp extension cords. Non-approved
cords may overheat. Care should be taken to arrange the cord
so that the cord cannot be tripped over.
21. Do not put any objects into openings. Do not use with any
openings blocked and do not restrict airflow. Keep all openings
free of dust, lint, hair or anything that might reduce airflow.
22. Do not use the vacuum cleaner with blocked filters and without
all of the filters in place.
23. Take extra care when positioning the vacuum cleaner on the stairs.
24. Please ensure that the brushbar is turned off when you are
vacuuming on the stairs.
25. Keep vacuuming area well lit.
3
Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
Page 5
General Safety Information
WARNING: Always switch off and unplug the vacuum
cleaner from the electrical socket before assembling, opening
or emptying the dirt container, or before connecting/
disconnecting the attachments.
CAUTION: The vacuum cleaner is a very powerful unit.
Before plugging the cord into the electrical socket, make sure
the switch is in the ‘off’ position.
IMPORTANT: If the inlet, hose or telescopic tube is blocked,
switch off the vacuum cleaner and remove the blockage(s)
before re-starting the vacuum cleaner.
IMPORTANT: Vax recommends the use of Residual Current
Device Rating of 30mA or less.
IMPORTANT: It is very important that filters are kept clean
to obtain maximum performance from your vacuum cleaner.
Not cleaning and not replacing your filters regularly can
reduce the suction power and cause overheating and
permanent damage to the vacuum cleaner.
NOTE: If the supply cord is damaged it must be replaced by
the manufacturer, or a similarly qualified person in order to
avoid hazard, or invalidating the warranty.
DAMAGE TO THE VACUUM CLEANER CAUSED AS A
DIRECT RESULT OF NOT ADHERING TO THE GENERAL
SAFETY INFORMATION AND THE INSTRUCTIONS IN
THIS USER GUIDE INVALIDATES THE WARRANTY
This vacuum cleaner is intended for household use only
and NOT for commercial or industrial use.
PLEASE KEEP THESE INSTRUCTIONS FOR
FURTHER USE.
IMPORTANT: The motor is equipped with a thermal cut-out.
If for any reason the unit should overheat (eg. from blocked
nozzles, a full dust container or unclean filters), the
thermostat will automatically turn off the switch. Should this
occur, unplug the vacuum cleaner from the electrical socket
and turn off the switch. Remove dirt container and empty.
Clean filters. Allow the unit to cool for approximately one (1)
hour. To re-start, plug into an electrical socket and switch
back on.
vax.com.au 4
Page 6
vax.com.au
Operation
Keep your Vax like new
IMPORTANT: The condition of the lters aects the performance of your machine. For best cleaning
results, check the condition of your lters every time you empty the dirt container and clean accordingly.
If your lters are washable make sure they are completely dry before inserting them into the vacuum
cleaner. For full cleaning instructions, see pages 8 and 9.
IMPORTANT: Do not use the vacuum cleaner without all of the lters in place.
IMPORTANT: Even with regular cleaning, lters have a limited lifespan and will eventually need to be
replaced during the lifetime of the vacuum cleaner. If the performance of your vacuum cleaner is
compromised and/or the lters are severely discoloured, the lters may need to be replaced. As a general
guide, Vax recommends lters be replaced every 3-6 months depending on the level of use to ensure
optimum performance of your vacuum cleaner.
Assembling your vacuum cleaner
5
Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
Page 7
Operation
Operating the appliance
Twist cord hook to
release cord.
Recline unit by pressing
foot on front of unit.
Adjust handle height.
In upright position turn
height adjustment to
desired setting.
High setting for high
carpet pile and hard oors.
Low setting for low
carpet pile.
Plug into mains. Turn unit on.
IMPORTANT: When the vacuum cleaner is stood in the upright position or when using the hose and tools,
the carpet height adjustment must be set to the high setting.
NOTE: Vax recommends that you raise the height of the brushbar to the high setting when using this cleaner
on lino and hard ooring due to constant rotation. Vax cannot be held responsible for damage to these
surfaces if the customer fails to take notice of this recommendation.
vax.com.au 6
Page 8
vax.com.au
Operation
Using accessories
NOTE: The 3-in-1 tool and TurboTool can be attached to the telescopic tube or hose directly.
NOTE: The hard oor tool can ONLY be attached to the telescopic tube.
NOTE: To change setting on your 3-in-1 tool, press in the Vax logo located at the top of the tool.
Attaching the hose
Press the latch release on
the hose before removing.
Choose an accessory.
Attaching the telescopic extension tube
Remove telescopic
extension tube.
Attach hose to telescopic
extension tube ensuring
the latch secures the hose.
Choose an accessory.
Attach accessory to
telescopic extension tube.
Attach accessory to hose
ensuring the latch secures
the accessory.
Hard oor tool can only be
attached to telescopic tube.
7
Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
Page 9
Maintenance
(Keep your Vax as good as new)
Emptying and cleaning the dirt container
Cleaning the HEPA pre-motor lter
Tap to remove dirt and debris for
a quick clean and before washing.
IMPORTANT: Water temperature should not exceed 40°C when washing the pre-motor lter.
IMPORTANT: Ensure the pre-motor lter is completely dry before inserting back into the vacuum cleaner.
vax.com.au 8
Page 10
vax.com.au
Maintenance
Advanced lter cleaning
(Keep your Vax as good as new)
Cleaning the post-motor lter
9
WARNING: Do not wash the post-motor lter
Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
Page 11
Maintenance
(Keep your Vax as good as new)
Removing blockages
WARNING: To reduce the risk of electric shock, turn the vacuum cleaner o and unplug from the electrical
outlet before performing maintenance/troubleshooting checks.
Disconnect the hose from the vacuum cleaner and remove any blockages found then reconnect the hose securely.
Removing blockages from the brushbar
Unscrew the 4 screws
on the base of unit.
Remove cover of
oor nozzle.
Lift the brush bar out of its
position.
Removing blockages from the TurboTool
Slide o the locking ring. Pivot lowering housing and
remove clog.
Remove the belt from the
end of the brushbar.
To re-assemble, be sure that the
tabs are engaged. Pivot the lower
housing closed. Slip the locking ring
into the groove at the neck of the
Turbo Tool to complete reassembly.
vax.com.au 10
Page 12
vax.com.au
FAQ’s
WARNING: To reduce the risk of personal injury, unplug the vacuum cleaner before performing
maintenance/troubleshooting checks.
Problem Solution
Is there an accessory missing?
Why won’t the vacuum cleaner
pick up?
Why is dust escaping from
the vacuum?
What do I do if the unit/an accessory
becomes damaged or broken?
Why won’t the accessories pick
up properly?
Check the ‘Machine Overview’ page in this guide to make sure the part is definitely
included in your unit.
If it is missing, we’re here to help. Simply call us on AU 1300 361 505 or NZ 0800 800 900
The dirt container may be incorrectly installed; remove the dirt container from the unit by
pressing the dirt container release catch and then re-attaching it to the unit, ensuring it is locked
firmly back into place.
The filter may be clogged; refer to ‘Keep you Vax like new’ on page 5 and ‘Maintenance: Cleaning
the filters’ on pages 8 and 9.
The dirt container may be blocked; refer to ‘Maintenance: Emptying and cleaning the dirt
container’ on page 8.
There may be a blockage in the hose/tube; disconnect from the vacuum cleaner. Carefully
remove any blockages found and reconnect securely.
The filter may be clogged; refer to ‘Keep you Vax like new’ on page 5 and ‘Maintenance: Cleaning
the filters’ on pages 8 and 9.
The dirt container may be blocked; refer to ‘Maintenance: Emptying and cleaning the dirt
container’ on page 8.
The dirt container may be incorrectly installed; remove the dirt container from the unit by
pressing the dirt container release catch and then re-attaching it to the unit, ensuring it is locked
firmly back into place.
We’re here to help. Simply call us on AU 1300 361 505 or NZ 0800 800 900
Hose blockages: remove the hose from the unit. Carefully remove any blockages found and
reconnect hose securely.
Accessory blockages: remove accessory from handle/tube. Carefully remove blockage and
re-attach to the vacuum cleaner.
Why will the vacuum cleaner
not run?
11
The accessory may be faulty. Simply call us on AU 1300 361 505 or NZ 0800 800 900
It may not be plugged into the electrical outlet correctly; ensure that the plug is pushed in securely.
The electrical outlet may not be working properly; check the fuse or breaker, or consult an electrician.
The motor thermostat may have tripped; switch off and unplug the vacuum cleaner, and leave for
one hour before switching the cleaner back on.
Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
Page 13
Other Information
Insulated
Use
Instructions
Vax Service & Help
Vax Careline:
Australia 1300 361 505
New Zealand 0800 800 900
Monday-Friday 8.30am to 5.00pm
If you have queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the standard
local rate. Please make a note of the serial number and model number of the vacuum cleaner before calling.
For the nearest Service Agent, please call the Vax Customer Careline or visit vax.com.au
Technical Specication
Voltage: 220-240V ~50Hz
Wattage: 1600W
Capacity: 4 Litres
Filter: Pre-motor lter – washable
HEPA H12 antibacterial post motor lter – tap to clean (do not wash)
Cord length: 10m
Weight: 8kg
Subject to technical change without notice.
N197
Double
\
Indoor
Read
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
vax.com.au 12
Page 14
Distributed by Techtronic Industries Australia Pty. Ltd.
Level 1, 660 Doncaster Road, Doncaster, Australia 3108.
www.vax.com.au Service Line: AU: 1300 361 505 / NZ: 0800 800 900
Loading...