Vava VA-AD011 User Manual

VAVA AROMA DIFFUSER
User Guide
Specifications
Model
Power source
Water tank capacity
Working time
Mist output (continuous misting)
VA-AD011
DC 5V 0.55A
30 ml / 1.04 oz.
3 hours
5±2 ml / 0.18±0.07 oz. per hour
3.0±0.1 MHz
Product Diagram
1. Mist Output
2. Cover
3. Power Button
4. Water Tank
5. Max Water Level
6. Drain Side
7. Air Outlet
8. Base
9. Water Outlet
10. Air Inlet
11. DC Socket
VA-AD011
www.vava.com
E-mail: support@vava.com Tel: 1-888-456-8468 (Monday-Friday: 9:00 – 17:00 PST) Address: 46724 Lakeview Blvd, Fremont, CA 94538
NORTH AMERICA
Learn more about the EU Declaration of Conformity: https://www.vava.com/downloads-VA-AD011-CE-Cert.html
Troubleshooting Guide
Solution
Connect to power
Refer to the instructions
Add water into water tank
Power off and place in a well ventilated area for 10 minutes
Get rid of some water
Clean the water tank as instructed
Please add water
Cap on the cover properly
Move the unit to a well ventilated area
Cause
No power
Did not press the Mist Button
No water in water tank
The diffuser is getting too hot
Water exceeding max level
Stain built up inside water tank
Not enough water
Cover not properly covered
Temperature and humidity of environment is too high
Problem
No mist coming out
Abnormal mist
Wate r leakage
Adding Water
·Remove th e cover.
·Add up to 30 ml / 1.04 oz water into the water tank.
·Add 1 - 2 drops of essential oil into the water.
·Put the cover back on.
How to Use
·Connect the USB cable to a power source. The diffuser is now in
standby status. Make sure there is enough water inside the tank. Use the Power Button to control the mist and light mode.
Mist Mode
1. Press the Power Button to enter continuous misting mode, the light will turn on.
2. Press again to enter intermittent misting mode where the misting turns on and off respectively for 30 seconds with the lighting on.
3. Press a third time to return to continuous misting mode.
4. Press and hold for 1.5 seconds to turn off the mist and light.
Note: The unit will stop working once there’s not enough water.
Light Mode
·In continuous misting mode, press the Power Button twice to turn on / off the light.
Important
·Stop using when there is no water in the tank.
·Do not power on when the lid is not properly covered.
·Do not use essential oil directly. Always mix it with water.
·Do not use synthesized essential oil as it may damage the unit. Use
natural essential oil only.
Caution
·Do not alter or repair the unit. Return to the manufacturer for
repairing.
·If a bad odor or anything unusual is detected, turn off immediately.
·Do not remove power plug with wet hands.
·Do not place near any heat source or under direct sunlight.
·Keep away from other electric appliances prone to humidity
damage.
·If not in use, regularly clean the unit. Store in a dry and cool place.
·Do not leave the unit unattended around children when plugged in.
·Do not clean the device from its base.
Clean water tank as instructed, use after air drying
Clean water tank as instructed, use clean water
Use natural essential oil
Unit is new
Dirty water
Synthesized essential oil
Bad / strange smell
Loading...