SAFETY INFORMATION
39. Do not over extend retractable cord past stopping point.
FAILURE TO FOLLOW SAFETY INFORMATION AND WARNINGS MAY
CAUSE PERMANENT DAMAGE AND VOID PRODUCT WARRANTY.
Steam cleaner must be level and on the floor during use.
listed on the label.
supply cord.
!
Do not leave the steam cleaner on and unattended. Always
switch the steam cleaner off and remove plug from wall
outlet when unattended.
use only with a grounded outlet.
Vapamore in order to prevent a fire hazard.
Only use distiled water. Using hard water can cause
calcium or mineral build up and void the warranty.
Never use additives such as perfumes, stain removers, or
other chemicals in the water tank as they will void the
warranty, cause permanent damage, and be dangerous.
Make sure the water tank cap is fully secured
before use.
(See cleaning and storage).
Do not pull or drag steam cleaner using the
steam gun and hose.
Drain water tank prior to shipping, transporting.
storage.
37.*To provide continued protection against risk of electrical
shock, connect to properly grounded outlets only.
38. *Not for space heating purposes.
.
10.5lbs
TECHNICAL SPECIFICATIONS
PARTS LIST
PARTS OVERVIEW
2 Extension tubes
Detail adapter
Floor head with triangle brush
19 Floor head carpet slider
20 Water level dipstick
Brass brush
The accessories attach directly to the detail adapter
by pushing the accessory straight on the detail adapter
and then twist to lock in place. (Fig. 3)
Do not use excessive pressure on the
accessory tools. Let the steam do the work with light
scrubbing action used on the accessory tool.
Accessory
compartment
The MR-100 Primo accessory compartment houses
the detail adapter, Jet nozzle attachment, dipstick,
clothes / fabric tool, micro fiber pad, cotton pad
and all brushes. Open the accessory compartment
by pulling the accessory cover back, away from the
machine. Remove the desired accessory from
the accessory compartment and close the accessory
cover. (Fig. 1)
Connect the steam hose to the steam socket on
the front of the steam cleaner. To do this flip down
the dust cover door and push the connector on the
steam hose firmly into the socket until both tabs
click into place. To remove the steam hose, press
in both release tabs located on the left and right side
of the steam hose connector and pull out to release
from the socket. (Fig. 4)
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
!
STEAM CLEANER ASSEMBLY
Accessories twist lock onto the adapter
The detail adapter MUST BE USED with all accessories.
the detail adapter can be used directly to the steam gun
or to the extension tubes. Attach the detail adapter
by pusing on to the steam gun or extesion tube until the
lock tab clicks in place. (Fig. 2)
STEAM GUN & HOSE
(Fig. 5)
Detail adapter
!
Loading...