Vantec UGT-FW050 User Manual

4-Port FireWire 400
PCI Host Card
User Manual
Model: UGT-FW050
All brand names and trademarks are properties of their respective owners.
w w w . v a n t e c u s a . c o m
Features and Benefits
z VIA VT6306 chipset z PCI 32-bit 33MHz Interface z Compliant IEEE 1394-1995, 1394a (rev. 1.1) and OHCI
Interface Specification 1.0
z Supports data transfer rates of 100, 200 and 400 Mbps z Hot-swapping features allows you to connect/disconnect
devices without powering down your system
z Adds four IEEE 1394a (FireWire 400) ports to your PC for
high-speed I/O connectivity and support up to 63 devices
z One (1) internal IEEE 1394a port (Sharing with first external
IEEE 1394a port P2)
Ports
z 2 x external IEEE 1394a 6-pin Ports z 1 x external IEEE 1394a 4-pin Port z 1 x internal IEEE 1394a 6-pin Port
System Requirements
z Windows® 2000, XP/2003 32/64 bit, Vista 32/64 bit z Available PCI slot
UGT-FW050Page2
Package Contents
z 1 x 4-Port FireWire 400 PCI Host Card Adapter z 1 x User’s Manual z 1 x 1394a DV Cable (6-pin to 4-pin)
Hardware Description
Before installing the 4-Port FireWire 400 PCI Host Card, please see the photo below highlighting the available IEEE 1394aports of the card.
Note: The Internal Port (P1)) shares with first External Port (P2). DO NOT use P1 and P2 at the
UGT-FW050Page3
same time.
Hardware Installation
1. Turn Off the power to your computer.
2. Unplug the power cord and remove your computer’s cover.
3. Remove the slot bracket from an available PCI slot.
4. To install the card, carefully align the card’s bus connector with the selected PCI slot on the motherboard. Push the board down firmly.
5. Replace the slot bracket’s holding screw to secure the card.
6. Replace the computer cover and reconnect the power cord.
Driver Installation
Windows® 2000/XP/Vista will automatically detect and install the correct driver for the 4-Port FireWire 400 PCI Host Card. Make sure that the driver has been installed correctly, right click My
Computer, then click Manage, click Device Manager. The Device Manager window opens. Scroll to the IEEE 1394a Bus host controller icon and click on the plus symbol, the VIA OHCI Compliant IEEE 1394a Host Controller should be displayed.
UGT-FW050Page4
Loading...