Page 1
Enclosure for 3.5” SATA 6Gbps HDD
3. Note the SATA interface in the Tray and your
SATA drive.
5. Push the drive in the direction shown to fully
connect the SATA interface.
6. Secure two screws on each side to hold the drive
to the Tray.
1. Verify the package contents. 2. Remove the end cover and slide the Tray out. 4. Align Tray SATA interface with Drive SATA
interface and insert to connect the SATA
interface together.
7. Align the Tray guide rail to the housing guide
and slide the Tray into the housing.
Housing
Tray
8. Replace the end cover plate and secure with
two screws.
Page 2
Copyright © 2016 Vantec Thermal Technologies. All Right Reserved. | All Registered Trademarks Belong To Their Respective Companies.
Information in this document is subject to change without notice.
Reproduction of these materials in any manner whatsoever without written permission is strictly forbidden.
Printed in China
Printed on Recycled Paper.
v1.01 NST-328S3-BK
www.vantecusa.com
12b. Once formatted, the NexStar TX is ready for use.
12a. The operating system should detect the hard drive. Proceed with the
necessary setup procedure to format the hard drive.
9. Connect the power cable. 10. Connect the USB cable. 11. Press the power button.
10
9
Power Cable
USB 3.0 Cable
11
Power Button
/Power Switch
Loading...