VADDIO EasyMic MicPOD Series, EasyMic Table MicPOD (with keypad), EasyMic Ceiling MicPOD, EasyMic Table MicPOD (without keypad) Release Notes & Update Instructions

RELEASE NOTES

& UPDATE INSTRUCTIONS

Release Notes for:

EasyMic MicPOD Microphones:

EasyMic Ceiling MicPOD
EasyMic Table MicPOD (with keypad)
EasyMic Table MicPOD (without keypad) - (Previous name: TRIO Table Mic Array)

Release Information:

----­03/14/2018
EasyMic 1.11
Notes:

- Improvements

- General audio processing improvements.

- Default behavior of camera button on EasyMic Table MicPOD (with keypad) has changed from
momentary to latching.

- Added ability to update MicPOD firmware from the Web UI of compatible Vaddio products.

- User Notes

- The firmware file and update process differs depending on the Vaddio product from which the connected
MicPOD is updated. See update instructions on the following pages for more details.

----­06/15/2015
EasyMic 1.09
Notes:

- New Features

- Added Interoperability Support for AV Bridge MATRIX PRO.

- User Notes

- For this firmware and all previous versions, microphones must be updated serially through the Vaddio
EasyUSB Mixer/Amp.

Page 2 of 11

Vaddio EasyMic MicPOD Firmware Update Instructions

Firmware for the EasyMic Table and Ceiling MicPODs can be updated from the following products using the
following methods:

Vaddio Product to update firmware from

Update method

AV Bridge MATRIX PRO

Web UI

ConferenceSHOT AV Camera

Web UI

EasyUSB Mixer/Amp

Vaddio Loader

Using the table above, find the product that you will be updating your EasyMic MicPOD’s firmware from and
navigate to the proper update method on the following pages. Once your firmware has been properly updated, it
is recommended that you give yourself a high five for a job well done.

Page 3 of 11

Web UI Update Instructions

Requirements:

- Network access to the Vaddio product from which you will update the connected MicPOD(s).

- The Web UI’s Admin password, if it has been changed from the factory default.

- The ‘Web’ version (.p7m) firmware file for your MicPOD, downloaded from the microphone’s
product page at www.vaddio.com.

Step-By-Step Process:

1. Enter the IP address for the AV Bridge MATRIX PRO or ConferenceSHOT AV Camera into a
browser.

- You can get the IP address for the AV Bridge MATRIX PRO from the front panel of the
unit under ‘Network Settings’.

- You can get the IP address for the ConferenceSHOT AV Camera by viewing the

camera’s USB stream and pressing the ‘Data Screen’ button on the camera’s remote.

The IP address will appear in the camera’s video output.

2. In the Web UI, use the menu access button in the top right to open the Admin Login dialogue
box.

If your web UI doesn’t have the menu access button like in the picture above (outlined
in blue) your connected unit may be on older firmware that had a different web UI layout.

Page 4 of 11

3. In the Admin Login dialogue box that pops up, enter the admin password. The default password
is password (lower case).

4. Go to the System page with the menu on the left of the page, then select the peripheral tab
within the System page.

If there is no Peripherals tab on the system page, you will need to update firmware on your product:

▪ AV Bridge MATRIX PRO must be on firmware version 2.0.0 or newer.
▪ ConferenceSHOT AV Camera must be on firmware version 1.1.0 or newer.