Utica Boilers SFH-W IV Brochure

Starre IV

There Are Some Things You Can Always Depend On...

Starfire Water IV

Up to 86% AFUE Oil Fired Hot Water Boiler

• Available in 9 sizes from 103 MBH to 252 MBH.

• Dependable Cast Iron Heat Exchanger with Cast Iron Push
Nipples. The Sections and Push Nipples expand at the same rate
when heated. By using similar materials instead of less expensive
gaskets the boiler maintains a water tight seal over time.

• Honeywell High Limit and Circulator Relay Control.

- Digital temperature display and diagnostics.

- Less Coil: Control monitors water temperature and delays the burner

starting until any residual heat has been transferred. Thermal purge
logic measures rate of temperature change inside the boiler and

delays burner ring accordingly. This maximizes efciency by turning

on the burner only when needed.

- With Coil: The Boiler utilizes a Honeywell non-thermal purge High

Limit, Low Limit and Circulator Relay control.

• Atmospheric Chimney Vent Boiler.

• Optional Tankless Heater Coil.

• Textured paint Jacket.

• Limited Lifetime Warranty (Residential Applications).

• Made in the U.S.A.

Utica Starre IV Residential Oil Fired Water Boiler

(1)

Heating

Capacity

Tankless Heater

Dimensional Diagram Model

SFH-3085W 0.85 119 103 90 8”x8”x15’

SFH-3100W 1.00 140 119 103 8”x8”x15’

SFH-4100W 1.00 140 122 106 8”x8”x15’

SFH-4125W 1.25 175 151 131 8”x8”x15’

SFH-4145W 1.45 203 173 150 8”x8”x15’

Front View

SFH-5160W 1.60 224 193 168 8”x8”x15’

SFH-5185W 1.85 259 221 192 8”x8”x15’

SFH-6175W 1.75 245 212 184 8”x8”x15’

SFH-6210W 2.10 294 252 219 8”x8”x15’

(1) Oil burner input based on 140,000 Btu per gallon.

2)Net AHRI water ratings shown are based on a piping and pickup allowance of 1.15. Consult manufacturer before selecting a boiler for installation having unusual piping and
pickup requirements, such as intermittent system operation, extensive piping systems, etc.

3) Heating Capacity and AFUE based on 13.0% CO

General Information (See Installation, Operation and Maintenance Manual for complete instructions)

Clearances

Required
distances
measured from
boiler.

Connections
(All Models)

Electrical 120 Volts AC, 60 hertz, 1 phase, Less than 12 amps (15 amp circuit recommended).

Side View

Tankless
Heater
Capacities

Dimensions/
Weights

Standard
Equipment

Options Taco, Grundfos or Less Pump; Tankless Coil.

AHRI Oil Burner Input

G.P.H. MBH Water MBH

with -0.02” W. C. draft over re and #1 smoke or less. Tested in accordance with U.S. Department of Energy test procedures.

2

Top

Sides

Front

Rear 6" (152 mm)

Flue Connector

Supply Tapping - 2", Return Tapping 1-1/2" NPT, Oil Line 3/8" O.D. copper tubing for runs of 50 feet or
less, and ½" O.D. for longer runs.

Model

SFH-3085WT 0.85 T3 3 10.5
SFH-3100WT 1.00 T3 3-1/4 10.5
SFH-4100WT 1.00 T4 3-1/4 13.5
SFH-4125WT 1.25 T4 3-3/4 13.5
SFH-4145WT 1.45 T4 4 13.5
SFH-5160WT 1.60 T4 4 16.5
SFH-5185WT 1.85 T4 4-1/4 16.5
SFH-6175WT 1.75 T4 4-1/4 19.5
SFH-6210WT 2.10 T4 4-1/2 19.5

No. of

Sec.

3 17-7/8" 11-1/4" 6" 534 lbs.
4 21-1/2" 12-5/8" 6" 668 lbs.
5 25-1/8" 14-1/4" 7" 781 lbs.
6 29-1/4" 15-15/16" 8" 901 lbs.

Boiler Controls: Primary Control, High Limit and Circulator Control
Heat Exchanger: Cast Iron Heat Exchanger with Cast Iron Push Nipples. Swing out Burner Door.
Combustion: Oil Burner, Target Wall/Liner.
Electrical: Wiring Harness, Burner Electrical Disconnect.
Other: Crated Boiler, Flush Jacket, Circulator- 1¼", Supply Tapping-2", Return Tapping-1 1/2", Temperature
Pressure Gauge, Safety Relief Valve, Drain Valve.
For Tankless Heater Units add Tankless Hot Water Coil and Triple Combination High Limit/Low Limit/Circulator
Control.

Input Rate

G.P.H.

A

(Depth of Flush Jacket)

Net AHRI

Ratings

(3)

MBH

Number

(Front of Jacket to Center

Line of Flue Outlet)

Tankless Heater Capacity

Intermittent Draw G.P.M.

B

(2)

Min. Natural Draft

Chimney Size

Combustible Materials (Required)

24" (610 mm)

6" (152 mm)

24" (610 mm)

9" (229 mm)

Boiler Water

Content (Gallons)

(Flue Outlet Diameter)

C

AFUE

85.0%

84.0%

86.0%

85.0%

84.0%

85.0%

84.0%

85.0%

84.0%

Weight

(3)

Contractor
Assistance: 800.325.5479

Certications

Tested for 75 psi ASME

Working Pressure

tel: [phone]

PN 240009798 Rev. 12/14All ratings and specications subject to change.

P.O. Box 4729

Utica, New York 13504

• fax: [phone]

www.uticaboilers.com