Utica Boilers SFE IV Steam Brochure

SFE Series IV

There Are Some Things You Can Always Depend On...

SFE IV

82% AFUE Oil Fired Steam Boiler

• Available in 4 sizes from 106 MBH to 247 MBH.

• Dependable Cast Iron Heat Exchanger with Cast Iron Push Nipples. The Sections and Push Nipples expand at the same rate when heated. By using similar materials instead of less expensive gaskets the boiler maintains a water tight seal over time.

• Patented Protective Heat Shield Bafe to protect the casting above the water line.

• Honeywell Pressure Control, Boiler Water Level Gauge Glass, and Steam Pressure Gauge.

• Electronic Low Water Cutoff.

• Atmospheric Chimney Vent Boiler.

• Textured paint Jacket with compact footprint.

• Cast Iron swing door and large ueways allow for easy cleaning and servicing.

• 10 Year Limited Warranty (Residential Applications).

• Made in the U.S.A.

Utica SFE Series IV Residential Oil Fired Steam Boiler

Dimensional

Diagram

Front View

21.7/8”

Elwco Cycle Guard

Oil

Burner

Side View

A.S.M.E. Pressure

35.3/4”

16”

9.1/32”

“C”

Relief Valve

“B”

“A”

Model

AHRI Oil

Burner Input

G.P.H. MBH

Htg.

(1)

Cap.

(2)

MBH

SFE-3090S 0.90 126 106 80 333 6" 8”x8”x15’ 150

SFE-4125S 1.25 175 147 11 0 458 6" 8”x8”x15’ 140

SFE-5185S 1.85 259 216 162 675 8" 8”x8”x15’ 150

Without

Tankless

SFE-6210S 2.10 294 247 185 771 8" 8”x8”x15’ 145

SFE-3090ST 0.90 126 106 80 333 6" 8”x8”x15’ 150

SFE-4125ST 1.25 175 147 110 458 6" 8”x8”x15’ 140

With

SFE-5185ST 1.85 259 216 162 675 8" 8”x8”x15’ 150

Tankless

SFE-6210ST 2.10 294 247 185 771 8" 8”x8”x15’ 145

(1) Burner input is based on an oil heating value of 140,000 Btu/gal.

Pressure

Control

(2) MBH = 1000 Btu per hour [Btu = British Thermal Unit].

(3) Net AHRI Steam Ratings based on piping and pick-up allowance of 1.333. Consult manufacturer before selecting boiler for installations having unusual piping and

pick-up requirements, such as intermittent system operation, extensive piping, etc.

(4) Heating Capacity and AFUE based on 13.0% CO2 with -0.02” W.C. draft over re and #1 smoke or less. Tested in accordance with U.S. Department of Energy test

procedures.

General Information (See Installation, Operation and Maintenance Manual for complete instructions)

Top

Clearances

Required distances measured from boiler.

Connections (All Models)

Electrical 120 Volts AC, 60 hertz, 1 phase, Less than 12 amps (15 amp circuit recommended).

Tankless Heater Capacities

Dimensions/ Weights

Standard Equipment

Options Tankless Coil.

Left Side

Right Side

Front

Back 24” (610 mm)

Flue Connector

Supply Tapping Two 2”, Return Tapping 1-1/2”, Oil Line 3/8” O.D. copper tubing for runs of 50 feet or less, and ½” O.D. for longer runs.

Model

Input

Rate

G.P.H.

Tankless

Heater Number

SFE-3090ST 0.90 SFE-4125ST 1.25 41/2 13 9 SFE-5185ST 1.85 41/2 15 10 SFE-6210ST 2.10 41/2 15 10

No. of

Sec.

(Length of

Flush Jacket)

3 163/8” 61/2” 6” 534 lbs. 4 201/4” 81/2” 6” 688 lbs. 5 235/8” 101/4” 7” 781 lbs. 6 271/2” 85/16” 8” 901 lbs.

Boiler Controls: Honeywell Pressuretrol, Boiler Water Level Gauge Glass, and Steam Pressure Gauge.

Heat Exchanger: Cast Iron Heat Exchanger with Cast Iron Push Nipples, Swing Door.

Combustion: Beckett Oil Burner, Target Wall/Liner.

Electrical: Wiring Harness, Burner Electric Disconnect.

Safety: Electronic Low Water Cut Off.

Other: Crated Boiler, Flush Jacket, ASME Relief Valve, Drain Valve, Plastic Cover, Two 2” Supply Tappings,

1-1/2” Return Tapping and Skim Port. For Tankless Heater Units: Add Tankless Hot Water Coil and 4006 Limit Control.

(4)

L-24

Net AHRI Ratings

Steam

MBH

(Front of Jacket

to Center Line of Flue Outlet)

Min. Nat. Draft

(3)

Chimney Size

Sq. Ft. Steam

Round Square

Combustible Materials (Required)

Tankless Heater

Capacity Intermittent

Draw G.P.M.

2 11 8

Pump

Press.

PSI

Nozz. Furn.

0.75-60°B

1.10-60°B

1.50-70°B

1.75-70°B

0.75-60°B

1.10-60°B

1.50-70°B

1.75-70°B

24” (610 mm)

6” (152 mm)

24” (610 mm)

9” (229 mm)

Boiler Water

Content (Gallons)

To Water

Line

(Flue Outlet Diameter)

AFUE %

(4)

82.0%

To LWCO Line

Weight

Certications

All ratings and specications subject to change.

Contractor Assistance: 800.325.5479

Tested for 15 psi ASME

Working Pressure

tel: 315.797.1310

P.O. Box 4729

Utica, New York 13504

•

fax: 315.797.3762

www.uticaboilers.com

PN 240009857 Rev. 4/14