Us robotics USR5422, USR5462, USR5470 Installation Guide
Wireless Starter Kit
802.11g 54Mbps Router
802.11g 54Mbps USB Adapter
Installation Guide
Guide d'installation
Installationsanleitung
Guida all'installazione rapida
Guía breve de instalación
Beknopte installatiegids
R24.0496.00
English
802.11g 54Mbps Router Installation .......................................................... 1
802.11g 54Mbps USB Adapter Installation................................................. 5
Troubleshooting and Support.................................................................... 9
USR5470 Package Contents
USR5462 802.11g 54Mbps Router One (1) Ethernet cable
19VAC Power Supply USR5422 54Mbps USB Adapter
Installation Guide Installation CD-ROM
802.11g 54Mbps Router Installation
Prepare for Installation
Note: It is important that you have your serial number written down before you install the
802.11g 54Mbps Router. You can find your serial number on the bottom label of the
802.11g 54Mbps Router. If you ever need to call our Technical Support department, you
will need this number to receive assistance.
Model Number Serial Number
USR5462
Note: Be sure to find out what letter your CD-ROM drives uses before you begin installing
your new product. You will need to know this to properly install your software.
Step One: Connect your modem to the 802.11g 54Mbps Router
• Turn off your computer and your cable or DSL modem.
• Locate the Ethernet cable from your cable or DSL
modem that is connected to your computer’s Ethernet
adapter.
• If your broadband is connected, disconnect that Ether-
net cable from your computer’s Ethernet adapter.
• Use the Ethernet cable to connect your cable or DSL
modem to the WAN port on the rear of the 802.11g
54Mbps Router.
Note: Some cable or DSL modems can be connected using either a USB cable or an Ethernet cable. To connect your cable or DSL modem to the 802.11g 54Mbps Router, you must
use an Ethernet cable.
1
Step Two: Connect your 802.11g 54Mbps Router to your computer and connect the power supply
Connect one end of the supplied Ethernet cable to your
computer’s Ethernet adapter. Connect the other end to
one of the LAN ports on the 802.11g 54Mbps Router.
Turn on your cable or DSL modem. Connect the
included power adapter to the power socket on the
802.11g 54Mbps Router. Plug the power adapter into
a standard power outlet. Turn on your computer.
Step Three: Configure the basic connection settings
Perform the steps of the Setup Wizard to configure the basic connection settings of the 802.11g
54Mbps Router.
Note: For more detailed configuration information, refer to the User Guide on the Installation CD-ROM.
Your Internet connection user name and password will be required for the installation of the
802.11g 54Mbps Router. Depending on your ISP, you may need to know some of the following
information: IP Address, Subnet Mask, Gateway/Router, DNS Servers/ Name Servers, and Service Name (optional).
Note: To obtain the necessary information, first look within your login application. If you
cannot find all the necessary information, contact your ISP for assistance in obtaining this
information.
2
Loading...