usha MG 2853, MG 3753 Instruction Manual

INSTRUCTION MANUAL

MIXER GRINDER

MG 2853, MG 3753

Dear Customer,

Congratulations!

You are now the proud owner of Usha Mixer Grinder.

Innovatively designed, using only the highest quality material and components, your

Usha Mixer Grinder is designed for years of trouble free performance.

Please read this Instruction Manual carefully before using and keep it cautiously after

reading for future reference.

Best Wishes

2

IMPORTANT PRECAUTIONS

DO’S

- Place your MG at a convenient height so that you can operate it easily. You should

be able to look down into the attachments to check the circulation of ingredients.

- Clear out some space around the machine. You will need it for keeping various

items required while operating the MG.

- Keep the MG away from direct heat or sun.

- In dry grinding, friction may heat up the jar. It has nothing to do with the motor, so

do not worry.

- Remember MG operates at optimum efficiency at the specified voltage only. Wide

voltage fluctuations during operation may affect quality of grinding even though the

motor may still be safe. If your area faces such periodic fluctuations and if you

cannot get a voltage stabilizer try to operate the machine during steadier voltage

stretches.

- Hold down the jar cover lightly with hand while mixer is in operation.

DON’TS

- Do not run the machine unless jar is in position. Lids too should be firmly placed.

- Do not allow children to handle MG.

- Do not burden motor with loads heavier than those specified in the instructions.

- Do not run MG without any load.

- MG should not run for more than 30 minutes at a stretch normally. Stop for 10

minutes before starting again. When hot air comes out of the ventilator, switch it off

for a while.

- Your MG cannot substitute for a storage container. So avoid storing food in

the jar.

- Never lay any thin plastic sheet or cloth under the basic unit. It may get sucked up

and block ventilation holes in the base.

- Blades should not be left inside the jar.

- Do not grind sugar in your MG. It may cause damage to the MG motor.

- Do not attempt to repair MG at home or allow any unauthorized person to do it

either. In the event your MG needs attention, contact Usha Care.

3

IDENTIFICATION OF PARTS

BASIC UNIT

1. Basic Unit

2. Speed Switch with pulse

3. Overload Switch

4. Cord Plug

5. Spatula

LIQUIDISING JAR (large)

6. Wet Grinding Jar Assembly

7. Shaft Katori

8. Lid 1500 ml Jar

9. Ring Liquidising Jar

10. Coupler

11. Wet Grinding Blade

GRINDING JAR (medium)

12. Dry Grinding Jar Assembly

13. Dry Grinding Jar lid

14. Dry Grinding Rubber Ring

15. Dry Grinding Blade

SMALL QTY. GRINDING

JAR (Small)

16. Small Dry Grinder

Jar Assembly

17. Blade / Shaft Assembly

18. Small Jar lid

19. Small Rubber Ring

20. Blade Knob

BASIC UNIT /

BLENDING JAR

MIXER / DRY

GRINDER JAR

4