Universal Electronics R32140B Users Manual

How to setup your voice remote

A. Make sure you are pointing your voice

remote at the Set-Top Box you want to
pair with.

B. Press and hold the Play/Pause and 0

buttons at the same time for three

seconds. Release when the blue light
starts flashing on the remote.

C. When the blue light stops flashing, your

remote is connected and paired.

D. Follow on-screen directions to pair the

remote with your TV

Give voice control a try.

Hold the button down and say: “Tune to
CNN” or “Show me comedy movies.” Or,
click OK to go to Live TV.

For support, select Report an Issue at www.xxxxx.com

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

You are cautioned that changes or modifications not expressly approved by the party

responsible for compliance could void your authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may

cause undesired operation.