
Description
The MIM-93M1AKL is 37.9 KHZ miniaturized infrared
receivers for remote control and other appplications
requiring improved ambient light rejection.
The separate PIN diode and preamplifier IC are assembled
on a single leadframe.
The epoxy package contains a special IR filter.
This module has excellent performance even in disturbed
ambient light applications and provides protection against
uncontrolled output pulses.
Features
l Photo detector and preamplifier in one package
l Internal filter for PCM frequency
l High immunity against ambient light
l 5-Volt supply voltage; low power consumption
l TTL and CMOS compatibility
BLOCK DIAGRAM
ABLC
Unity Opto Technology Co., Ltd.
TRAP BPF
f
TRIMMING
unit : mm
V
S
Output
GND
07/06/2000

Absolute Maximum Ratings
Fig 2. Standard Transmitter Measurement circuit
: indicates horizontal and vertical directions
Item Symbol Ratings Unit Remark
Supply voltage V
Operating temperature T
Storage temperature T
Soldering temperature T
5.8 V
-10 ~ + 60 °C
-20 ~ + 75 °C
260 °C Maximum 5 seconds
Electro-optical characteristics (Vcc=5V)
(Ta=25°C , Vcc=5V)
Parameter Symbol Min. Typ. Max. Unit Remarks
Current consumption Icc 5.0 mA Under no signal
Response wavelength p 940 nm
Tuning frequency
f
0
37.9
KH
Z
Output form - - - - - active low output - - - - -
H level output voltage V0h 4.2 V
L level output voltage V0l 0.5 V
H level output pulse width Twh 400 800 s
L level output pulse width Twl 400 800 s
Distance between emitter & detector L 10.0 m Note 1
Half angle ±45 deg Horizonal direction
Test Method
A. Standard Transmitter
ON/OFF pulse width satisfied from 25 cm to detection limit
carrier frequency f
duty 50%
0
600µs
Fig 1. Burst Wave
600µs
600µs
Transmitter
Duty 50%
10µF
PD3516
10kΩ
Oscilloscope
GND
B. Detection Length Test
Transmitter output
Unity Opto Technology Co., Ltd.
V
out
D.U.T
L
7/6/00