Page 1
Assembly Instructions
Caution: You must read this before you proceed
Rocking Chair
1
Page 2
No. Picture Description QTY
Part List
Label Picture Description QTY
2
A Backrest Panel 1
B Right Leg Panel 1
C Left Leg Panel 1
D Seat Panel 1
E Seat Cushion 1
Hardware
①
② Bolt (M6x45mm) 5
③ Bolt (M8x80mm) 3
④ Allen Key 2
Screw (M7X70mm)
3
Page 3
FRONT FACING
Assembly Preparation
3
Before Beginning Assembly:
Assembly Steps
Overview
Backrest Panel (A)
Left Leg Panel (C)
Right Leg Panel (B)
Seat Cushion (E)
Seat Panel (D)
This Rocking Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the
Rocking Chair parts, the above picture is to help you put the various parts into perspective. Please read through the
instructions below to familiarise yourself with the parts and steps before assembly.
Page 4
Do not fully tighten the Screw and Bolt.
D
Step 1
4
Unpack and place all parts on a clean, non-marring surface.
Step 2
C
Align Seat Panel(D) with Left Leg Panel(C) as shown above.
Attach Seat Panel(D) to Left Leg Panel(C) using Screw(①), and Bolt(③) with Allen Key(④).
Page 5
Do not fully tighten the Screw and Bolt.
Do not fully tighten the Bolts.
B
D
A
B
C
A
C
B
④
Step 3
5
Align Seat Panel(D) with Right Leg Panel(B) as shown above.
Attach Seat Panel(D) to Right Leg Panel(B) using Screw(①), and Bolt(③) with Allen Key(④).
Step 4
Attach Backrest Panel(A) to Right Leg Panel(B), Left Leg Panel(C), and Backrest Panel(A) using Bolts(②) with Allen
Key(④).
Page 6
E
Step 5
6
Exert pressure floorwards, onto the Rocking Chair with both your hands.
This pressure will help the Rocking Chair reach full alignment at all joints.
In a sequential manner, gradually tighten all Screws and Bolts until evenly secured.
Inspect the Rocking Chair and make sure all parts are adequately connected.
Place Seat Cushion(E) onto the Rocking Chair.
Lay the Rocking Chair down and tie the velcro straps of the Cushion(E) under the Seat Panel(D) as shown above.
Step 6
Your Rocking Chair is ready for use.
This Rocking Chair can only be used on a flat, level surface.
Page 7
Care & Maintenance
7
Loading...