Uniform TS890 User Manual

TS890 Simple Manual 2013-6-14

TS890 SERIES Transaction Terminal

(Support Paypass, Paywave, J/speedy, express pay, D-PAS)

Thank you for purchasing the TS890 series products.

The contactless & Signature Pad TS890 is to support the mag-stripe card ,

EMV / ISO 7816 card and contactless payment systems . The small footprint

size of the device makes it easily to integrate to the current transaction system

such as Point-of-Sale terminal as the part of the system. The device

communicates with bank host by Modem , Ethernet or GPRS. Allow to connect

peripherals by RS232 or USB.

FEATURES

Build-in thermal printer



Support mag-stripe , ICC , contactless transaction



Support quad-band GPRS communication



Support Modem and Ethernet



TS890 Specifications

Processor

Memory System

LCD Display

SAM

Contactless

RTC

Communication

Dimensions

32 bits high performance processor

Flash 8/16Mb , SDRAM 16Mbb .

128 x 64 pixels Graphical Display with LED Backlight

3 SAM Card Slots (support 5V and 3.3V SAM) (option)

Build-in contactless module (option) , supported ISO

14443 13.56Mhz contactless card .

Battery backup real time clock

Provided RS232/USB Ports for peripherals connection

Provideed standard USB Port to connect PC/Terminal

Modem/Ethernet/GPRS

(L)199 x (W) 94 x (H) 75mm

Power Requirements

Operation Environment

9VDC 5A

Temperature 0 °C to +50 °C; Humidity 5% to 90%

TS890 Simple Manual 2013-6-14

AGENCY APPROVAL

●

Specifications for FCC Class B

Changes or modifications are not expressly approved by the manufacturer could void the

user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation.

This device complies with Part 15 of the FCC Rules.

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

Operation is subject to the following

This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/ TV technician for help.

You are cautioned that any change or modifications to the equipment not expressly approve by

the party responsible for compliance could void your authority to operate such equipment.

Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with minimum distance 20cm between the radiator &

your body.