Uniden XDECT TE-SSE35 Setup Manual

www.evadale.com.au

For more information

or to order, freecall

1300 883 194

©2012 Evadale Healthcare. All rights reserved.

DESK

WALL

to wall

telephone

connection

1 Unpack the telephone

Remove the cordless handset, charger base and all components from the packaging.

Remove the protective plastic from front of the charger and handset.

Remove the printed tag from underneath the charger.

2 Install batteries in the cordless handset

Remove the battery cover from the back of the handset by pressing on the notch and
sliding the cover down and off.

To connect the battery pack, insert the connector into the jack located inside the handset
as shown (the connector will only fit one way). Push until it clicks into place.

Tug gently on the wires to make sure the connection is secure.

Place the battery pack into the battery compartment and replace the cover by sliding up
and into place. Do not attempt to remove the batteries from the white plastic casing.

3 Connect the power cord

Find the power adapter.

Turn the charger upside down and connect into the socket marked DC IN 9V.

Plug the adapter into your wall socket (standard 240V power)
and turn on power at the wall.

4 Connect the telephone cord

Find the telephone cord. Connect the telephone line by inserting one
end into the charger at the socket marked TEL LINE.

Insert the other end into your standard wall telephone connection.

DESK

WALL

AC adapter to
power socket

Uniden XDECT

TE-SSE35

Cordless Telephone

PAGE
1 of 4

BaSic SET-up guidE

www.evadale.com.au

For more information

or to order, freecall

1300 883 194

©2012 Evadale Healthcare. All rights reserved.

5 Charge the handset

Place the cordless handset into the charger cradle. A red charge light illuminates,
the display should activate and a battery icon will animate to indicate the handset is
charging.

Charge the handset for at least 15 hours before initial use.

If the handset
does not charge

Remove and replace the handset,
ensuring it is properly seated in the cradle

Check the power adapter connection.

Make sure power is switched on at the wall

6 Test the handset connection

Pick up the handset and press TALK.
You should hear a dial tone, and the handset display should say

TALK.

Press TALK again to hang up.

If you cannot get a dial
tone or the handset
display says

CHECK TEL

LINE

Check the telephone line is properly inserted, both in base and wall socket

Try an alternative telephone wall socket

If you continue to experience difficulty, contact your local telephone
provider

If there is a lot of
noise or static

See page 29 of the Owner’s Manual for tips on avoiding interference

When you hear a dial tone, make a quick test call.

Press TALK to hang up.

7 Setting the day and time

Setting the date and time on the any handset will set it on all handsets/bases.

Remove the handset from the cradle.

Press MENU/OK to open the menu screen.

Use Volume

buttons to move the selector bar to DATE & TIME.

Press MENU/OK again to confirm your selection.

Use telephone keypad to select the date and time. Use Volume

buttons

to select

AM or PM, and press MENU/OK to confirm your selection.

This returns you to the Main menu.

As an example of using the telephone keypad (to enter the date, hour and minutes:

to enter 27 February 2013 - 5:35pm, press on keypad ‘2’, then ‘7’, then ‘0’ and ‘2’
(for February), then ‘1’ and ‘3’ (for the year), then ‘0’, then ‘5’, then ‘3’ then ‘5’ then

(to select AM or PM) and MENU/OK.

Press END/CLEAR to exit the menu screen.

Uniden XDECT

TE-SSE35

Cordless Telephone

PAGE
1 of 4

BaSic SET-up guidE