Uniden XDECT SSE05 Owner's Manual

XDECT SSE05

Accessory Handset

For more exciting new products please visit our website:

Australia: www.uniden.com.au

New Zealand: www.uniden.co.nz

2

Rechargeable
battery pack

(BT-694n)

Charger AC adapter
(AAD-600S(M))

Battery cover

SS E05 accessory
handset and charger

If any items are missing or damaged, contact your place of
purchase. Never use damaged products!

Need Help? Get answers at our website: www.uniden.com.au for
Australia or www.uniden.co.nz for New Zealand

Important Safety Precautions!

When using your telephone equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock and injury to
persons, including the following:

Do not use this product near water, for example, near a bath tub, wash bowl,

-

kitchen sink or laundry tub, in a wet basement or near a swimming pool.
Avoid using a telephone (other than a cordless type) during an electrical

-

storm. There may be a remote risk of electric shock from lightning.
Do not use the telephone to report a gas leak in the vicinity of the leak.

-

Use only the power cord and batteries indicated in this manual. Do not

-

dispose of batteries in a fire. They may explode. Check with local codes for
possible special disposal instructions.

Do not place the handset in any charging cradle without the battery installed

-

and the battery cover securely in place.

SAVE THESE INSTRUCTIONS!

SS E05 Accessory Handset Owner's Manual

What's in the box?

Belt clip

3

Installing Your Handset

Charge the Battery

1) Unpack the handset, battery pack, and battery
cover. If the battery cover is already on the
handset, press in on the notch and slide the
cover down and off.

Line up 2)
the battery pack connector with
the jack inside the handset. (The
battery connector will only fit
one way.)
Push the battery pack connector 3)
in until it clicks into place. Tug
gently on the wires to make
sure the battery pack is securely
connected.
Place the cover over the battery 4)
compartment and slide
it up into place.

5) Connect the AC adapter to the charger's

DC IN 9V

jack and set the plug into the notch as
shown.
Plug the other end of the adapter 6)
into a standard 240V AC power
outlet.
Place the handset in the charger 7)
with the display facing forward.

The

CHARGE

light should

turn on.

If... Try...

the

CHARGE

light

does not turn on

reseating the handset. ­checking the AC adapter connection. -

Charge the handset completely (about 15 hours) before using it.

Red

Black