Uniden XDECT R001 Owner's Manual
XDECT R001
For more exciting new products please visit our website:
Australia: www.uniden.com.au
New Zealand: www.uniden.co.nz
2
XDECT R001 Accessory Handset
Owner's Manual
What's in the box?
AC adapter for
Repeater (AAD041S(M))
If any items are missing or damaged, contact your place of
purchase. Never use damaged products!
Need Help? Get answers at our website:
www.uniden.com.au for Australian model or www.uniden.co.nz
for New Zealand model.
Important Safety Instructions!
When using your telephone equipment, basic safety precautions should always be
followed to reduce the risk of re, electric shock and injury to persons, including the
following:
This unit is NOT waterproof.
DO NOT expose this unit to rain or moisture.
Do not use this product near water, for example, near a bath tub, wash bowl, kitchen
sink or laundry tub, in a wet basement or near a swimming pool.
Avoid using a telephone (other than a cordless type) during an electrical storm. There
may be a remote risk of electric shock from lightning.
Do not use the telephone to report a gas leak in the vicinity of the leak.
Use only the power cord indicated in this manual. Check with local codes for possible
special disposal instructions.
SAVE THESE INSTRUCTIONS!
Repeater, desk-stand, plug
cover, and wallmount screws
3
Using the Repeater
How it Works
The XDECT R001 repeater works to extend the range of the XDECT
R055, XDECT R035, Elite 9035BT or Elite 9045BT base in just the
same way as the repeater/charger unit. The only difference is the
XDECT R001 repeater and handset-charger are separate units.
Refer to your Base owner's manual for more information on how
repeaters work.
To use the repeater function, you must register the repeater to
an XDECT R055, XDECT R035, Elite 9035BT or Elite 9045BT
base. (Any repeaters that came packaged with the base are
already registered to that base for you.)
An XDECT R055, XDECT R035, Elite 9035BT or Elite 9045BT
base can support up to six repeaters, including any that were
supplied with your phone.
Usually, you can't tell when a handset switches between the
base and the repeater in the middle of a call, but sometimes, you
might notice a brief pause in your conversation.
Repeaters can be up to 3 chain-links (maximum) from the base.
Connect the Repeater
Remove the repeater Plug Cover from the plug section.
Connect the AC adapter to the repeater's
DC IN 9V jack and
route the cord (This adapter might already be connected).
Place the repeater Plug Cover over the plug section and slide
into place. Plug the other end of the adapter into a standard
240V AC power outlet.
Loading...