Uniden XDECT 8105WP Owner's Manual

1

XDECT 8105WP

Waterproof Accessory Handset

For more exciting new products please visit our website:

Australia: www.uniden.com.au

New Zealand: www.uniden.co.nz

2

When using your telephone equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock and injury to
persons, including the following:

• The charger is NOT waterproof: Do not use or place the charger near
water (e.g., near a bathtub, wash bowl, kitchen sink or laundry tub, in a wet
basement or near a swimming pool).

• If the charger falls into the water, unplug the AC adaptor before removing it
from the water.

• Wipe excess water off the handset before returning it to the charger.

• Avoid using a telephone (other than a cordless type) during an electrical

storm. There may be a remote risk of electric shock from lightning.

• Do not use the telephone to report a gas leak in the vicinity of the leak.

• Use only the power cord and batteries indicated in this manual. Do not

dispose of batteries in a fire. They may explode. Check with local codes for
possible special disposal instructions.

• Do not place the handset in any charging cradle without the battery
installed and the battery cover securely in place.

SAVE THESE INSTRUCTIONS!

IMPORTANT SAFETY INSTRUCTIONS

• The grant of a NZ Telepermit for any item of terminal equipment indicates
only that Telecom has accepted that the item complies with minimum
conditions for connection to its network. It indicates no endorsement of the
product by Telecom, nor does it provide any sort of warranty. Above all, it
provides no assurance that any item will work correctly in all respects with
another item of Telepermitted equipment of a differentmake or model, nor
does it imply that any product is compatiblewith all of Telecom’s network
services.

• The maximum volume setting of this telephone exceeds the Telecom
specified volume requirement. Telecom takes no responsibility for the
high volume available on this telephone, who believe this telephone is too
loud should contact the manufacturer at the website indicated on owner’s
manual warranty page.

• For telephone networks other than Telecom there may be a charge
incurred for local calls if the Insert 0 feature is on. Turn Insert 0 off.

• This equipment may not provide for the effective hand-over of a call to
another device connected to the same line.

General Notices for New Zealand Model:

Important Notice:

Under power failure conditions this appliance may not operate. Please
ensure that a separate telephone, not dependent on local power, is available
for emergency use.

3

If any item is missing or damaged, contact your place of purchase
immediately. Never use damaged products!

Need help? Get answers at our website:

• www.uniden.com.au for Australian model

• www.uniden.co.nz for New Zealand model.

What’s in the Box?

XDECT 8105WP

The handset complies with JIS7 water submersion specifications. It
can remain submerged under 1m of water for up to 30 minutes without
damage or loss of functionality. If the handset falls into water, just remove
it; you can continue using the handset as normal.

The handset will still receive calls even if it is under water, but you
probably won’t be able to hear the ringer or the earpiece. To avoid any
accidents, do not try to use the handset while it is still under water.

If you notice that the sound is distorted after your handset is submerged
in water, there might still be water around the speaker and microphone.
Just shake the handset to clear the water, and the sound should return to
normal. Don’t place the handset where it will be subjected to direct
sunlight for long periods of time.

Understanding the Waterproof Handset

XDECT 8105WP waterproof accessory
handset & water resistent charger

Charger
AC Adaptor
AAD-600S(M)

Not pictured:

- Factory installed rechargeable battery

- Belt clip

4

INSTALLING YOUR HANDSET

Charge the Battery

1. Remove the cardboard spacer.

2. Press the power on/off (activation) pin according to the directions on

the label.

3. Remove the label once the handset is powered on.

Save the power on/off pin in case you need to change the
handset’s power status later (i.e., to power off the handset when
it will not be used for a long time). Use the plastic power on/off
pin or a blunt-tipped object like an uncurled paper clip to press
the power on/off toggle through the rubber seal. Do not use a
sharp object; sharp objects might puncture the rubber seal and
jeopardize the handset’s waterproof status.

4. Connect the AC adaptor to the charger’s DC IN 9V jack and set the

cord into the notch. (This adaptor might already be connected.)

5. Plug the other end of the adaptor into a standard 240V AC power

outlet.

6. Place the handset in the charger with the display facing forward. The

display on the handset should turn on.

The handset’s rechargeable battery is already installed. Before you can
charge the battery, you have to power it on.

If.. Try..

the handset display does not
turn on

• Checking the AC adaptor
connection.

• Seeing if the outlet is controlled
by a wall switch.

#Charge the Handset completely (16 hours) before using it.