Uniden VS2600XR, VS1600XR User Manual

®
VS1600XR / VS2600XR
Vehicle Security System
with Rolling Code and
Duel Immobilisers
Operating Guide
Congratulations! And thank you for purchasing the VS1600XR / VS2600XR Vehicle Security System!
The VS1600XR / VS2600XR Vehicle Security System are one of the most reliable and economical ways to protect your vehicle. Once armed, your starter, and ignition systems are cut, giving potential thieves 2 headaches! Even if they smash your VS1600XR / VS2600XR Vehicle Security System , they cannot start your car! In addition, opening a door or turning the ignition switch ON triggers the VS1600XR / VS2600XR Vehicle
Security System and siren or horn will sound. What's more? VS1600XR / VS2600XR Vehicle Security System is equipped with the patented Rolling Code technology!
REMOTE CONTROL TRANSMITTER
Rolling Code
With the Rolling Code technology, the alarm's RF code changes every time you press the remote control button, the receiver never responds twice to the same code. In addition, with over 18 quintillion codes, the chances of ever repeating a code are virtually non­existent. So-called "code grabbers" and "scanners" are rendered obsolete  a thing of the past.
FUNCTIONS OF TRANSMITTER
Button 1 Arm, Disarm, AEI deactivation and Panic activation are usually controlled by
button 1.
Button 2 Quiet Mode, Boot release and second car operation are usually controlled by
button 2.
Button 3 Optional garage door opener (part SEA910.)
Uniden's policy is one of continual development and improvement. For this reason, Uniden reserves the right to change specifications without notice. Copyright 2002 Uniden. All rights reserved.
File:\DTP\MANUAL\Uniden\MoVs2600Xr.P65\JUL2001
OPERATING THE VS1600XR / VS2600XR
VEHICLE SECURITY SYSTEM
ARMING
The system ARMS by pressing your transmitter button 1 once. The red LED will begins to flash once per second. When the system arms, you will hear a short chirp and see the parklights flash once.
NOTE: If extra chirps are heard, refer to
PASSIVE ARMING
The system can be programmed to arm itself automatically. With Passive Arming Selected, the system will enter arming mode once ignition is
turned off and the last open door is closed. During the 30 second delay period, you can temporarily stop the arming by opening a door. Upon closing the open door the delay period will restart. A siren chirp and a parklight flash signifies that the alarm has entered arming mode. Passive arming is also indicated by rapid flashing of the red LED.
ZONE BYPASS
For cars with a faulty door switch or fading interior lights, the system can only be armed through the transmitter. Three siren chirps and parklight flashes indicate that the open zone is bypassed and that the system has entered arm mode.
DISARMING
To disarm the alarm, press button #1. The siren chirps twice, the parking lights flash twice then turn steady ON for 6 seconds (or until you turn the ignition ON), and the LED turns OFF. What happens next depends on how your alarm is set (ask your dealer):
q Alarm set for passive arming with security lock enable
The system will enter arming mode. If a door is opened, the system is only temporar­ily disarmed. Closing the open door will again cause the system to re-enter arming mode and relock the door.
q Alarm set for passive arming with security lock disable
The system will enter arming mode. If a door is opened, the system is only temporar­ily disarmed. Closing the open door will again cause the system to re-enter arming mode and the door will not lock.
q Alarm set for active arming with security lock disable
The alarm is now completely disarmed.
q Alarm set for active arming with security lock enable
The system will enter arming mode. If a door is opened, the system is permanently disarmed.
TAMPER INDICATORS
If your alarm was triggered when you were away, the siren will chirp twice and the indicator lights flash four times then turn ON for 6 seconds when you disarm your alarm.
These flashes automatically reset when the ignition is turned ON.
PATENTED STAY-SAFE DISARM
When your system is triggered, pressing transmitter button 1 will only terminate the alarm sound. The system will remain armed and locked, therefore, continually protecting your car.
ZONE BYPASS.
Loading...
+ 2 hidden pages