UH200 Series
UHF CB Transceiver
For more exciting new products please visit our website:
Australia: www.uniden.com.au
Warnings and Information
WATER WARNING
Uniden does not represent this product to be waterproof.
Do not expose this product to Rain or Moisture.
LITHIUM ION BATTERY PACK WARNING
• This equipment contains a Lithium Ion Battery Pack.
• The Lithium Ion Battery Pack contained in this equipment may
explode if disposed of in a fire.
• Do not short-circuit the Battery Pack.
• Do not charge the Lithium Ion Battery Pack used in this equipment in
any charger other than the one designed to charge this Battery Pack.
Using another charger may damage the Battery Pack or cause the
Battery Pack to explode.
• Lithium Ion batteries must be disposed off properly.
User License Information
USER LICENSE INFORMATION
The citizen band radio service is licenced in Australia by ACMA
Radio-communications (Citizen Band Radio Stations) Class
Licence and in New Zealand by MBIE General User Licence
NOTE
for Citizen Band Radio and operation is subject to conditions
contained in those licenses.
UNIDEN UH200 Series
2
Included in your Package
2 x UH200 Radio
2 x Li-ion Battery*
2 x Belt Clips*
1 x Twin USB AC adaptor
2 x Micro USB cable
* Items may come pre-fitted
If any of these items are missing from the box, contact your
place of purchase, immediately.
NOTE
Controls & Indicators
1 Antenna
2 [ + ] Key
3 [ -- ] Key
4 [ M ] / ( I ) Menu/Power
5 Microphone
6 Speaker
7 Lanyard Hole
8 LCD Display
9 Accessory Jack
10 PTT Key
11 PTT/LED Indicator
12 Micro USB Charge
1
2
3
4
5
6
2 x Earpiece Mic
2 x Lanyards
1 x Soft Carry Case
1 x Owner's Manual
CH
VOL
PTT
7
8
9
10
11
12
3
UHF CB Transceiver
Controls & Indicators
LCD Display
1
2
3
5
4
1. Main Display/channel Indicator
2. Channel
3. Volume
CTCSS is active on this channel
4.
when this segment appears
DCS is active on this channel
5.
when this segment appears
Key Functions
Standby Mode
Key Press Press & Hold
[ + ] Volume Up Transmit Call Tone
[ - ] Volume Down Key Lock On/Off
[ M ] Menu Mode Power On/Off
Combination Keys (Standby Mode)
Press [ M ] and [ + ] Change Transmit Power between High and Low
Press [ M ] and [ - ] Key Beep On/Off
MENU Mode
Key Press Press & Hold
[ + ] Next setting Scroll up through settings
[ - ] Previous setting Scroll down through settings
[ M ] Menu Mode Save setting & Exit MENU Mode
UNIDEN UH200 Series
4
Getting Started
Install / Remove the Battery Pack
To install the battery pack
1. Lever the bottom of the battery into the bottom of the battery compartment
and then fit the battery in until the release latch at the top locks into place.
To remove the battery pack
1. Make sure the radio is powered off.
2. Push down on the release lever at the top of the battery and lever the
battery away from the radio.
Always ensure the radio is powered off before removing the
NOTE
Attach / Remove the Belt Clip
To attach the belt clip:
1. Align the belt clip over the 2 screw holes on the back of the battery pack.
2. Use a suitable Philips screwdriver to fasten the 2 belt clip screws to the
To remove the belt clip:
1. Use a suitable Phillips screwdriver to loosen the 2 belt clip screws to
battery.
battery pack.
release the belt clip from the battery pack.
5
UHF CB Transceiver