Uniden TRU5885 User Manual

Welcome

Congratulations on your purchase of the Uniden TXC580 optional
handset and charger. This additional handset is for use with the
Uniden TRU5865 or TRU5885 base. You can place a fully featured
cordless handset anywhere in your home where AC power is available
to connect the handset charging cradle. The original base will support
up to 2 handsets (the original handset and one TXC580 handset).

The TXC580 will not be an alternative of the original handset,
if the original handset is damaged.

Important

The TXC580 will not operate unless it has been registered to a
Uniden TRU5865 or TRU5885. Before the additional handset can be
used, the battery must be charged and it must be registered with
the base.

This manual describes only the instructions specific to the
additional handset. For detailed operation, refer to the owner’s
manual supplied with the original unit (read “Expanding Your
Phone” chapter first).

Checking the Package Contents

Make sure you have received the following items in the package. If
any of these items are missing or damaged, contact the Uniden Parts
Department.

• Cordless Handset

• Charger

• Battery Pack (BT-446)
(Capacity: 800 mAH, 3.6V)

• AC Adapter (AD-446)
(INPUT: 120V AC 60Hz) (OUTPUT: 9V DC 210 mA)

• Beltclip

• This Owner’s Manual

• Other Printed Material

Uniden Parts Department at [phone]

Hours: M-F 7:00 a.m. to 5:00 p.m. CST.

We can also be reached on the web at

www.uniden.com.

– 2 –

Install the Battery Pack

Charge the battery pack for at least 15-20 hours before
completing the installation or using the handset.

Press down on the battery cover

1

release and slide the cover down until
it comes off.

Connect the battery pack connector

2

observing the correct polarity (black
and red wires) to the jack inside the
battery compartment.

Do not exert any force on this connection.
It could cause damage to the battery or to
the handset. The plastic connectors will fit
in only one way.

Once you are certain that you have made a
good connection, then insert the battery
pack into the battery compartment. Do
not pinch the wires.

Securely close the battery

3

compartment cover by sliding it
until it snaps into place.

Place the handset in the charging

4

cradle with the keypad facing forward.

• Use only the Uniden battery (BT-446)
supplied with your phone. Replacement
batteries are also available through the
Uniden Parts Department (See page 2).

• Recharge your handset on a regular basis
by returning the handset to the charger
after each phone call.

Battery Information

Battery use time (per charge)

From fully charged (15-20 hours charge time)

• 4 hours continuous use

• 8 days when the handset is in the standby mode

– 3 –