Euro Style Panel
u-line.com
INSTALLATION
U-ESP45S |
18" (45cm) Solid Door |
U-ESP60S |
24" (60cm) Solid Door |
U-ESPF60S |
18" (45cm) Frame Door |
U-ESPF60S |
24" (60cm) Frame Door |
U-DWRESP60S |
24" (60cm) Drawers |
1. Fully open door/drawers.
2. Starting at corner, pull gasket away from door and remove. (Leave gasket in place for drawer models)
3.Upon removal, lay gasket down on a flat surface.
Frame panels include a pre-installed black insert. Remove the protective foil on the top and bottom sides.
4.Align the pilot holes by placing the panel on the top corner edge of the door/drawer.
(For U-DWRESP60S - Locate 4 holes on each drawer. Drill through foam using a 3/16" bit.)
Align Top Of Panel With Highest Point Of Door/Drawer
Align Panel
Against
Door Edge
5. Have a second |
Bar |
|
person hold the |
||
Clamp |
||
panel in place or |
|
|
secure with a |
|
|
clamp. |
|
|
|
Door/Drawer |
|
6. Locate the 6 |
Stainless Steel |
|
Panel |
||
#8-32x1-1/4(32 |
|
|
mm) screws |
|
|
provdied with your |
|
|
panel. (Drawer |
|
|
panels use only 4 |
|
|
screws per panel) |
Bar |
|
|
Clamp |
7. Using a # 2 Phillips
screwdriver, place 1 screw in each of the 6 pilot holes and secure. Do not overtighten.
8. Reinstall gasket beginning at the corners.
30436 REV. B
Loading...