U-Line U-2075DWRRB-06 Installation Manual

Installation Guide

2075DWRR —
Drawer Model Refrigerator

™

www.U-LineService.com

Phone [phone] • FAX [phone]

Service & Parts Tech Lines Phone [phone] • FAX [phone]

[e-mail]

©2005 U-Line Corporation

02/2005

2075DWRR — Drawer Model Refrigerator

™

Contents

Exterior Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Cut-Out Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Product Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Clearances Information . . . . . . . . . . . . . . . . . . . . . . . . . 5

Other Site Requirements . . . . . . . . . . . . . . . . . . . . . . . . 6

No Custom Drawer Panels . . . . . . . . . . . . . . . . . . . . . . . 7

Custom 1/4" Drawer Panel Inserts . . . . . . . . . . . . . . . . 7

Full Overlay Drawer Panels . . . . . . . . . . . . . . . . . . . . . . 8

Checking Drawer Alignment . . . . . . . . . . . . . . . . . . . . 9

Adjusting Drawer Alignment . . . . . . . . . . . . . . . . . . . . 10

Electrical Specifications . . . . . . . . . . . . . . . . . . . . . . . . . 12

Leveling Information . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

Installation Tip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

Installation of the 2075DWRR . . . . . . . . . . . . . . . . . . . 13

Anti-Tip Kit Installation . . . . . . . . . . . . . . . . . . . . . . . . . 13

Installation Troubleshooting . . . . . . . . . . . . . . . . . . . . . 14

Initial Start-Up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

Start-Up Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . 15

Service Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15

1 Follow Safety Precautions

IMPORTANT

PLEASE READ all instructions completely before

attempting to install or operate the unit.

•This unit requires connection to a grounded (three-

prong), polarized receptacle that has been placed by a

qualified electrician in accordance with applicable

electrical codes.

Safety Alert Definitions

Safety items throughout this guide are labeled with a

Danger, Warning or Caution based on the risk type:

DANGER

Danger means that failure to follow this safety
statement will result in severe personal injury or
death.

WARNING

Warning means that failure to follow this safety
statement could result in serious personal injury,
or death.

CAUTION

Caution means that failure to follow this safety statement

may result in minor or moderate personal injury, property

or equipment damage.

www.U-LineService.com 2 02/2005

™

2075DWRR — Drawer Model Refrigerator

General Precautions

Use this appliance for its intended purpose only and

follow these general precautions along with those listed

throughout this guide:

WARNING

SHOCK HAZARD — Electrical Grounding Required.

• Keep the unit unplugged throughout installation
except during testing.

• Never remove the round grounding prong from
the plug and never use a two-prong grounding
adapter.

• Never use an extension cord to connect power to
the unit.

• Always keep your working area dry.

WARNING

The Anti-Tip Kit must be installed on this unit
before it is used. Never use the drawers as steps
or as a shelf to support more than the drawers’
contents. Serious personal injury could occur.

CAUTION

•Use care when moving and handling the unit. Use

gloves to prevent personal injury from sharp edges.

•Do not lift the unit by the drawer handle.

•Do not install the unit behind closed doors or in any

way that would obstruct airflow to the front grille,

which may cause the unit to malfunction.

2 Inspect and Plan

You have received a carton containing your 2075DWRR

Drawer Model Refrigerator with a package inside

containing a User Manual, a Product Registration

Card and Anti-Tip Kit. Complete and mail the

Product Registration Card or register online at

www.U-LineService.com. Once your unit is installed,

keep the User Manual and this Installation Guide in

a safe place for future reference.

Your unit is Black or Stainless Steel. Black units have

drawers with top handles designed for the installation of

full overlay drawer panels. When full overlay panels will

not be used, replacement handles MUST be installed (part

number 11926-4-BLK). Stainless Steel units have drawers

with seamless full wrap stainless steel fronts (that do

not accept custom panels), sculpted stainless steel handles

and black vinyl-clad cabinets. Please carefully follow the

directions that apply to your unit and your intended

design.

Tools/Materials Required

•Wrenches

•Screwdrivers — slotted and Phillips head

•1/4-inch thick drawer panel material and cutting tools

(Black units)

•3/4-inch thick drawer panel overlay material, cutting

tools, drill and bits (Black units)

Inspection

Unwrap and inspect the unit on a flat, level surface

capable of supporting its entire weight.

Removing Protective Coating

All Models:

The protective coating covering the inside of both top

and bottom drawers must be removed before using.

Stainless Steel Models:

When inspecting/installing a Stainless Steel unit, the

protective coating covering the drawer fronts must be

removed. Start at a corner of the drawers and pull back

the protective coating to remove it from the drawer

fronts.

After all the protective coating has been removed from

the drawers, clean all Stainless Steel surfaces with Claire

Stainless Steel Polish and Cleaner or comparable product

or a mild detergent and warm water solution and soft

cloth. Do NOT use abrasive cleaning agents.

Note: If cleaning with mild detergent and warm water

solution and soft cloth, the unit MUST be treated with

Claire Stainless Steel Polish and Cleaner or comparable

product to prevent discoloration.

02/2005 3 www.U-LineService.com

2075DWRR — Drawer Model Refrigerator

™

Exterior Cleaning

(As Required)

Black Models:

•The drawers, grille and cabinet may be cleaned with a

mild detergent and warm water solution. Do not use

solvent-based or abrasive cleaners. Use a soft sponge

and rinse with clean water. Wipe with a soft, clean

towel to prevent water spotting.

Stainless Steel Models:

•Stainless steel models can discolor when exposed to

chlorine gas, pool chemicals, salt water or cleaners with

bleach.

•Keep your stainless steel unit looking new by cleaning

with a good quality all-in-one stainless steel cleaner/

polish on a monthly basis. For best results use Claire

Stainless Steel Polish and Cleaner, which can be

purchased from U-Line Corporation. (The part number

is 173348.) Comparable products are acceptable.

Frequent cleaning will remove surface contamination

that could lead to rust. Some installations may require

cleaning on a weekly basis.

• Do not clean with steel wool pads.

• Do not use cleaners that are not specifically
intended for stainless steel (this includes glass,
tile and counter cleaners).

•If any surface discolors or rusting appears, clean it

quickly with Bon-Ami or Barkeepers Friend Cleanser

and a non-abrasive cloth. Always clean in the direction

of the grain. Always finish this process with Claire

Stainless Steel Polish and Cleaner or comparable

product to prevent further problems.

• Use of abrasive pads such as Scotchbrite will
cause the graining in the stainless to become
blurred.

•Rust that is allowed to linger can penetrate into the

surface of the stainless steel and complete removal of

the rust may not be possible.

3 Prepare Site

Your U-Line product has been designed for built-in

installation. Your unit does not require additional air

space for top, sides or rear. However, the front grille must

NOT be obstructed and clearance is required for electrical

connection in the rear.

Note: Unit can NOT be installed behind a closed cabinet

door.

Cut-Out Dimensions

See Electrical

Specifications

for Power Supply

34-1/4"

to

35-1/8"

24-3/16"

Figure 1

Follow the cut-out drawing in Figure 1. The 24-3/16"

width allows 1/4" for ease in installation and removal of

the unit. 24" is the counter depth in most installations.

The unit is 23-11/16" deep including the drawer and not

the full handle or 3/4" overlay (see Figure 2).

23-11/16"

www.U-LineService.com 4 02/2005

™

or Wall

2075DWRR — Drawer Model Refrigerator

Product Dimensions

23-11/16"

34-1/8"

23-15/16"

Black

24-7/16"

Including

Overlay

25-13/16"

Including

Handle

23-15/16"

Stainless Steel

34-1/8"

Clearances Information

The unit must be installed in a wall or under a counter-

top to allow for the installation of the Anti-Tip Kit (see

Page 13).

WARNING

The Anti-Tip Kit must be installed on this unit
before it is used. Never use the drawers as steps
or as a shelf to support more than the drawers’
contents. Serious personal injury could occur.

The unit is designed so it can be installed next to a wall on

either side (see Figure 3).

34-1/8"

23-15/16"

Wood Overlay

Figure 2

Please note that the unit has adjustable feet that can add

one additional inch to height during leveling or to match

adjacent cabinets (see Figure 25 on Page 12).

Cabinet

Figure 3

02/2005 5 www.U-LineService.com