U-Line U-2015WCOL-00 Installation Manual
Overlay Door Panel
Installation Instructions
for Wine Captain
Models 2075WCOL and
2015WCOL
U-Line Corporation
P.O. Box 245040 •Milwaukee, WI 53224-9540
Phone 414.354.0300
•
FAX 414.354.7905
www.U-LineService.com
Printed in U.S.A.
P/N 30009 (Rev. 3/03)
2
Part Number Description Quantity
12041 Insert 8 mm Plug 2
20002 Screw #6 x 1 Pan Head 10
42122 Screw #6 x 1/2 Large Flat Head 2
35003 Foam Tape - .093 x .375 x 8' 1
OVERLAY PANEL KIT PARTS SUPPLIED
3
PREPARE THE NEW OVERLAY PANEL
Refer to the Overlay Panel Preparation instruction sheet, part
number 30010.
FIGURE 1 – REMOVE EXISTING DOOR FROM THE CABINET
a. Remove top hinge screw pin
(7/64" hex key). Remove the
door by tilting forward and
lifting off the bottom hinge pin.
b. Lay door on a clean flat surface
with the door gasket facing down.
Remove two screws (1, Figure 1)
securing top pivot plate (2); discard
screws.Keep pivot plate for later
use when installing the door.
c. Turn door over so gasket is facing
up.Pull door gasket out of the
groove completely. Start in the
middle and pull outward, moving
toward the edge (Figure 1).This may
take some force, but be careful.
FIGURE 2 – CHECKING OVERLAY FIT
Figure 2
a. Turn door over.Make sure panel is fully seated on all four
sides.
K
Figure 1
The overlay door panel must not weigh more than
20 lbs.The thickness of the door panel must be 3/4".
If panel does not seat properly, determine the cause of
the problem by reviewing the Preparation Instructions
P/N 30010.
!
2
1
DOOR
WCO001
GAS
NOT FULLY SEATED LITTLE OR NO GAP OBJECTIONABLE GAP
Loading...