U-Line U-2015RB-00 Installation Manual

Full Overlay Door Panel
Installation Instructions

for Models

2075, 2015 and CLR 2060

U-Line Corporation

P.O. Box 245040 •Milwaukee, WI 53224-9540

Phone [phone]

•

FAX [phone]

Printed in U.S.A.
P/N 30-10011

Part Number Description Quantity

12041 Insert 8mm Plug 2
42120 Spacer Nylon 3/8 OD x .19 ID 8
42121 Screw #10 x 5/8 Round Head 8
42122 Screw #6 x 1/2 Large Flat Head 2

11901-2* Pivot Plate Wood 1

12020* Wood Panel Bottom Hinge 1
12021* Wood Panel Top Hinge 1
12029* Top Pivot Bracket 1

31672 Door Closer - Male 1
31673 Door Closer - Female 1

42161-ZP Screw #8-32 x 3/8 Hex Sems 2

42096 Pivot Post 2

42101 Screw #8-32 x 1/2 Flat Head 6
80-17006-01** 2015 BLK Modified Top Handle Assy. 1
80-17006-02** 2015 WHT Modified Top Handle Assy. 1
80-17006-03** 2075 BLK Modified Top Handle Assy. 1
80-17006-04** 2075 WHT Modified Top Handle Assy. 1

*Specify Black or White
**Only one handle is included with this kit

1. REMOVE EXISTING DOOR FROM THE CABINET

a. Remove top hinge screw pin

(7/64" hex key). Remove the
door by tilting forward and lifting
off the bottom hinge pin.

b. Pull door gasket out of the

groove (top edge of door only).
Start in the middle and pull
outward, moving toward the
edge (see Figure 1).This may
take some force.

c. Remove the three screws located

on the back of the handle (see
Figure 2).

d. Remove the top handle

and discard. (This handle
will be replaced with the
modified handle included
in the full overlay kit.)

e. Remove the two screws

located on both sides of
the lower handle.Remove
the handle.

f. Attach the modified

handle to the lower
handle using the three
screws removed in Step
1 C. Set aside.

g. Slide the existing door

panel out of the door frame.

2. PREPARE THE NEW OVERLAY PANEL

Refer to the Full Overlay Panel Preparation instruction sheet.

Figure 1

Figure 2

The full overlay door panel must not weigh more than
20 lbs.The thickness of the door panel must be 3/4".

NEW HANDLE

OLD HANDLE