π
H-2302
ELECTRIC PALLET TRUCK
1- 80 0 -295 -5510
uline.com
OPERATING INSTRUCTIONS
SAFETY GUIDELINES
WARNING! Do not operate this truck unless you
have been trained to use it, authorized to do so
and have checked that it is in good condition.
The operator should read all of the warning
signs and instructions here and on the truck
before using it. The truck is strictly forbidden to
lift or carry a person.
1. In case of any failure or fault, please stop using the
truck until it can be properly repaired.
2. Do not repair the truck without professional training
and authorization.
3. Keep a two foot distance between the truck and
any person not operating it.
4. Do not operate on uneven ground or in a
dangerous environment.
5. The truck should not be driven on public roads.
6. The truck may only be driven into an elevator or
loading platform with enough load capacity to
support the truck. The operator must confirm this
point before entering elevator or loading platform.
Passengers must enter the elevator after proper
parking of the truck and walk out of the elevator
before moving the truck.
TRUCK ON ANOTHER VEHICLE'S LOADING
PLATFORM OR ON A GANGWAY
1. Before the truck is driven from a loading bay and
onto a vehicle, the operator must always check the
maximum load capacity of the gangway. There
should also be suitable devices that prevent the
gangway from sliding.
2. The operator must also check the maximum load
capacity of the vehicle. There should also be
suitable devices to prevent the vehicle from moving.
3. The truck should always be parked on a level
surface. The forks must be lowered to their lowest
position. Always turn the ignition to the "OFF" position.
Always remove the ignition key from the electrical
lock when leaving the truck.
NOTE: If the truck is left unused for a prolonged
period without being recharged, the battery
plug should be disconnected.
4. Protective shoes should be worn when working
with this truck according to local safety regulations.
7. The truck should always be driven with the height of
the forks in the lowest position except when placing
or moving a load.
0321 IH-2302PAGE 1 OF 7
OPERATING INSTRUCTIONS CONTINUED
ROUTINE CHECKLIST BEFORE START-UP
— Check for any defect of truck (especially on the
wheels).
— Check if battery is fixed firmly and cable connected
properly.
STARTUP OF TRUCK
— Rotate and turn off Emergency Shut-Off Switch.
— Insert key into On/Off Switch and turn right to
position "I".
— Battery capacity meter should indicate the current
ca pacity.
— Check to ensure the horn is working correctly.
— Check the brake function on the control handle.
OPERATION OF THE TRUCK
EMERGENCY SHUT-OFF SWITCH
— All electric control functions are cut off when the
Emergency Shut-Off Switch is pressed. (See Figure 1)
Figure 1
Emergency Shut-Off Switch
On/Off Switch
Battery Capacity Meter
LIFTING OF FORKS
— Press the RAISE button to raise the forks to
required height.
LOWERING OF FORKS
— Press the LOWER button to lower the forks to
required height.
EMERGENCY STOP BUTTON
— Truck will automatically brake when button is
pressed. (See Figure 2)
BRAKING
— Release the control handle and the truck
automatically brakes.
— The control handle will return to upright position.
DRIVING
— Drive speed is controlled by the FWD/BWD CONTROL
wheel.
CARGO LOADING/UNLOADING
CAUTION! Before loading the cargo, the
operator must check to confirm the cargo is
properly placed on the pallet and the weight
of cargo within load capacity of the truck.
Load weight should be evenly distributed
between the two forks.
Figure 2
1 2 3 4 2 5
1 LOWER Button
2FWD/BWD CONTROL Wheel
3HORN Button
4EMERGENCY STOP Button
5RAISE Button
0321 IH-2302PAGE 2 OF 7
TECHNICAL SPECIFICATIONS
Figure 3
3
Figure 4
9
8
1
11
5
13
4
2
6
DESCRIPTION KEY SPECIFICATION
Model Number ----------- H-2302
Power Supply ----------- Electric
Type of Operation ----------- Pedestrian
Capacity/Rated Load ----------- 3,300 lbs.
Load Center Distance 1 24"
Wheelbase 2 48"
Weight (including battery) ----------- 630 lbs.
Tire Size - Drive End ----------- 10 x 3.5"
Tire Size - Load End ----------- 3.3 x 3.6"
Handle Height in Neutral Position 3 48.6"
Fork Height Lowered 4 3"
Fork Height Raised 5 7.5 "
Overall Length 6 71"
Length of body 7 23"
Overall Width 8 27.5"
Fork Length 9 48.1"
Fork Width 10 6.4"
Fork Thickness 11 1.9"
Overall Fork Width 12 25.5"
Floor Clearance (center of wheelbase) 13 1.3"
Turning Radius ----------- 59"
Travel Speed (laden/unladen) ----------- 3.1/3.2 mph
Lifting Speed (laden/unladen) ----------- 4.5/3.5 sec
Lowering Speed (laden/unladen) ----------- 3.5/4.5 sec
Brakes ----------- Electric-magnetic
Drive Motor ----------- 1.0 kw
Lifting Motor ----------- 0.8 kw
Battery Voltage ----------- 12v / 80Ah
Sound Level ----------- <70 db
Steering Arc ----------- 205º
10
12
0321 IH-2302PAGE 3 OF 7