U-Line H-1024, H-1025, H-1026 User Manual

H-1024 , H-1025
H-1026

MANUAL
CARTON STAPLER

STAPLER SPECIFICATIONS

Dimensions (L x H x W) 15 x 11½ x 4½"
Weight (Without Fasteners) 3.75 lb.
H-1025/H-1026 Staple Specification S-289 C58 Stick and/or S-1396 C34 Stick
H-1024 Staple Specification S-1397 A58 Stick
Staple Capacity 100 Staples

WARNING

Before operating this stapler familiarize yourself with the safety warnings and

instructions in this manual. Keep these instructions with the stapler for future

reference. If you have any questions, contact Uline at 1-800-295-5510.

0812 IH-1024PAGE 1 OF 7

SAFETY INSTRUCTIONS

SAFETY INSTRUCTIONS

1. Read the manual and understand all safety
instructions before operating the stapler. If you have
questions, contact Uline at 1-800-295-5510.

2. Always wear protective equipment; e.g., safety
glasses, hearing protection and head protection.

3. Do not place your hand or any other body part in
the staple clinching area.

4. Never point the stapler at yourself or anyone else.

LOADING THE STAPLER

1. Pull the pusher back until it stops on pusher pivots.
Rotate pusher to position. (See Figure 1)

2. Insert up to 2 sticks of appropriate staples into the
magazine. Let the sticks slide forward to the front of
the magazine. (See Figure 2)

3. Pull the pusher back to an upright position and
gently let the pusher slide forward against the
staples. Do not let the pusher slide forward and
strike the staples at high speed as this may deform
the staples and damage the stapler.

ADJUSTING STAPLE LEG LENGTH

1. Loosen the set screw with a 3mm Allen wrench on
the bottom. (See Figure 3)

2. Turn adjusting rod 180º with a screw driver to the
desired setting.

3. If you are using ¾" staples set L up.

4. If you are using 5⁄8" staples set S up. (See Figure 4)

5. Tighten the set screw.

Figure 1 Figure 2

Figure 3 Figure 4

0812 IH-1024PAGE 2 OF 7

SAFETY INSTRUCTIONS (CONTINUED)

CLINCH ADJUSTMENT

Loosen securing nut closest to body. Turn adjustment

nut clockwise to loosen clinch. Turn adjustment nut
counter-clockwise to tighten clinch. After adjusting,
tighten securing nut. (See Figure 5)

DEPTH ADJUSTMENT

1. Loosen front 2 screws with a 4 mm Allen w rench.
(See Figure 6)

2. Push the body up and adjust to the desired depth.
(See Figure 7)

Figure 6

Figure 5

Figure 7

0812 IH-1024PAGE 3 OF 7