U-Line 2175WCCS00 Installation Manual

WARNING

WARNING

IMPORTANTIMPORTANT

10 Wood Grille Overlay

Back

Front

Wood Overlay

Grille

24 Inch Models

Application

Area

Back

Front

Wood Overlay

Grille

15 Inch Models

Application

Area

Grille Overlay

Your models grille is designed to accept a wood grille over­lay. An overlay may be used to compliment a door overlay
and provides a seamless look for your surrounding decor.
Follow the instructions below to prepare and install your
grille overlay. Be sure to read over this chapter completely
before beginning.

Preparation

The grille overlay MUST have venting as shown in the
drawing below. Failure to have proper venting can
result in damage to your model.

The grille overlay may only be installed on indoor units.

1. Prepare your overlay using the dimensions provided in the
figure on page 12 for 24 inch models and page 13 for 15 inch
models. If using a hook and loop style mount, drill hole A will
not be used.

2. If desired, stain and finish your grille to match your surrounding
decor. Follow the stain manufacturers instructions to apply stain
to your overlay.

You may also mount your overlay to your grille using hook and
loop type fasteners. U-Line recommends using 3M® Dual lock®
fasteners. To mount your overlay using a hook and loop fastener
follow the instructions below.

1. Read the instructions provided with your hook and loop
fastener carefully.

2. Apply hook and loop fastener system to the back of the overlay
and front of the grille. Use the shaded areas in the diagram
below for application location.

Installation

The wood overlay grille must be installed in such a
manner that the grille assembly can still be removed from
the unit.

Screw Mount (Recommended)

1. Remove the grille from your unit by removing the two
mounting screws. See below.

Remove Screw

2. Lay the back of your grille overlay onto the front of the grille.
Make certain the screw holes and vents are aligned.

3. Slide each of the screws removed in step 1 through the grille
overlay and grille.

4. Mount your new overlay onto your unit by screwing the overlay
back onto the base of your unit.

Hook and Loop Fastener Mount

3. Carefully align the wood overlay with the grille and press into
position.

Remove Screw

U-Line Grill Overlay Installation 11

Grille Drawing 24 inch

(7/16 )

10-5/16

8-1/2

5/16

1/2

TYP 3X

5/16

TYP 2X

1/2

FULL R

22-7/8

19-5/8

23-7/8

Grille Overlay Dimensions 24 Inch Models

11/64

2-1/8

3-3/32

1/2

1/4

U-Line Grill Overlay Installation 12