EM151/EM201
Electronic
Manometer
INSTRUCTION MANUAL
-+
PSI
EM201
|
|
|
www.ueitest.com |
® |
|
Email: info@ueitest.com |
|
TABLE OF CONTENTS |
|
Safety Rules................................................................................ |
2 |
Features...................................................................................... |
3 |
Operating Instructions.............................................................. |
4 |
EM151/EM201 Specifications ................................................. |
6 |
Pressure Conversion Chart...................................................... |
7 |
Warranty..................................................................................... |
8 |
INTRODUCTION
The EM151 and EM201 provide a simple, timesaving alternative to U-tube pressure measurements. Use the UEi EM151 & EM201 to measure gas supply and draft pressures in residential or light commercial properties. The EM201 differential mode provides a convenient method to measure pressure drops.
SAFETY RULES
WARNING!
Before every use, check to be sure the meter and its tubing are free from breaks or blockage. While using the meter, if you suspect gas is leaking, or if you can smell gas, close off the gas supply and ventilate the occupied space. Identify and repair the source of the leak before continuing with the test.
In the interest of safety, this instrument should only be used by trained, competent professionals who know the hazards and consider the risks of working on and with industrial equipment.
These meters do not measure water pressures; under these conditions they will fail. Do not exceed 10 PSI input pressure
2
FEATURES
EM151
•Single input to measure pressure to ±20” wg
•Triple Scale: inWG, mBar and PSI
•Ruggedized, including rubber boot with integral magnet
•Simple two-button operation
•Measures in inches water gauge
•Auto power-off after 20 minutes
•3 year limited warranty
EM201
•Dual input differential measurement to ±60” wg
•Triple Scale: inWG, mBar and PSI
•Ruggedized, including rubber boot with integral magnet
•Measures in inches water gauge and mBar
•Auto power-off after 20 minutes
•Min/Max value capture
•Data Hold
•Back-lit display
•3 year limited warranty
3