Ubiquiti M365N User Manual
NanoBridge
Package Contents
Package Contents
U
B
I
Q
N
U
E
T
I
T
W
I
U
O
N
B
I
R
E
Q
K
T
U
S
I
T
U
I
B
N
I
Q
N
U
E
T
I
T
W
I
U
O
N
B
I
R
E
Q
K
T
U
S
I
T
I
N
NanoStation 24v PoE
Power Cord Mounting Ties
Adapter
* Products may be different from pictures and are subject to change without notice.
Installation Requirements
• 10 mm wrench
• Shielded Category 5 (or above) cabling should be used for all
wired Ethernet connections and should be grounded through
the AC ground of the PoE.
We recommend that you protect your networks from the
most brutal environments and devastating ESD attacks
with industrial‑grade shielded Ethernet cable from Ubiquiti
Networks. For more details, visit www.ubnt.com/toughcable
Hardware Overview
Secondary
Ethernet Port
Secondary
Main
Reset
Main
Ethernet Port
Note: Secondary Ethernet Port is capable of 24V Power over
Ethernet output which can provide power to a secondary
device. It can be enabled using the AirOS interface.
1
Quick Reference Guide
LEDs
LAN1 LAN2
Signal These LEDs display the signal strength.
LAN2 LAN/Secondary Ethernet The LAN2 Ethernet LED
will light steady green when an active Ethernet
connection is made to the Secondary Ethernet Port.
LAN1 WAN/Main Ethernet The LAN1 Ethernet LED
will light steady green when an active Ethernet
connection is made to the Primary Ethernet Port and
flash when there is activity.
Power The Power LED will light steady green when
the NanoStation is connected to a power source.
Application Examples
NanoStation mounted outdoors without the dish installed
provides outdoor to indoor coverage using the antenna only.
NanoBridge mounted outdoors with the dish refelector installed
provides directional outdoor coverage (gain reflector dependent)
2
Typical Deployment
LAN or Computer to
Ethernet Port labeled
LAN on PoE Adapter
Typical Deployment
Connect the Power Cord to the
PoE Adapter and a power outlet
Ethernet Port on Ubiquiti
Device to Ethernet Port labeled
POE on PoE Adapter
Note: Shielded Category 5 (or above) cabling should be
used for all wired Ethernet connections and should be
grounded through the AC ground of the PoE.
3
Quick Reference Guide
Accessing AirOS
1. Make sure that your host machine is connected via Ethernet to
the Ubiquiti Networks device (as shown on previous page).
2. Configure the Ethernet adapter on your host system with a
static IP address on the 192.168.1.x subnet (e.g. 192.168.1.100).
3. Launch your Web browser and type http://192.168.1.20 in the
address field and press enter (PC) or return (Mac).
4. Enter ubnt in the Username and Password fields. Select your
country from the Select Your Country drop‑down. To use the
product you must agree to the terms of use. To do so, click
I agree to these terms of use. Click Login.
5. The AirOS Interface will appear allowing you to customize your
settings as needed.
4
Loading...