Ubiquiti M2BW User Manual

Zero-Variable Outdoor Radio

Model: BM2-Ti

Introduction

Zero-Variable Outdoor Radio

Model: BM2-Ti

Thank you for purchasing the Ubiquiti Networks® airMAX®

™

Bullet

Titanium. This Quick Start Guide is designed to guide

you through installation and includes the warranty terms.

Package Contents

Bullet Titanium N-Type Right

PoE Adapter

(24V, 0.5A)

Products may be different from pictures and are subject to change without notice.

TERMS OF USE: Ubiquiti radio devices must be professionally installed. Shielded Ethernet
cable and earth grounding must be used as conditions of product warranty. TOUGHCable is
designed for outdoor installations. It is the professional installer’s responsibility to follow local
country regulations, including operation within legal frequency channels, output power, and
Dynamic Frequency Selection (DFS) requirements.

Angle Adapter

Power Cord Quick Start Guide

Hardware Overview

N-Type

Connector

Bullet Titanium

Radio

Ethernet Port

Rubber Washer

Cable Gland Body

Compression Seal

Compression Nut

Hardware Installation

1. Unscrew the Cable Gland Body and detach it from the Bullet

Titanium Radio.

2. Unscrew the Compression Nut and remove the Compression
Seal from the Cable Gland Body.

3. Slide the Compression Nut over the Ethernet cable with
the threaded end facing the RJ-45 connector. Slip the
Compression Seal around the cable.

4. Feed the Ethernet cable through the Cable Gland Body and
seat the Compression Seal into the Cable Gland Body.

5. Connect the Ethernet cable to the port located on the
bottom of the Bullet Titanium Radio.

6. Securely screw the Cable Gland Body into the Bullet
Titanium Radio so that the Rubber Washer seals the bottom
of the radio.

7. Tightly screw on the Compression Nut. Ensure the
Compression Seal is securely compressed and tightly sealed
around the cable.