
INCLUDES OPERATOR'S MANUAL
INSTALLATION INSTRUCTIONS AND PARTS CATALOG
MODEL NAME : MM60
MODEL MID MOWER
60" MOWER AND MOUNTING

The safety of the operator was the prime consideration on the design of the mower.
Proper shielding,convenient controls,simple adjustments,and other safety features have been built into
this implement.
The following decals are located on the mower deck. Keep decals clean and replace them immediately
if they are missing or damaged. contact your dealer for replacements.
Part NO : JHM 1000-071-100 Part NO : JHM 1000-072-100
Located on RH and LH Belt Shields Located on Deck Weldment
Part No : JHM 1000-075-100
Located on Deck Weldment

INFORMATIONAL DECALS
Part NO : JHM 1000-074-100
Part NO : JHM 1000-073-100

LUBRICATION
NOTICE: It is not recommended to use a preassure washer to clean the mower assembly. High pressure
water may cause damage to spindles, pulleys, belts, or bearings shortening life and reducing
serviceability.
Life of the mower depends upon the maintenance given. Proper lubrication is very important.
Always lubricate the deck and lift components before operation.
Always wipe the fittings to be lubricated with a clean cloth before greasing. Dirt injected into the fitting
will cause damage to the machined parts.
Use SAE Multi-purpose lithium base grease on all lubrication locations shown below. Remember to
wipe away excess grease, which has built up around parts.
Lubricate grease fittings after every 50 hours of operation.
Miscellaneous working parts not porvided with lubrication fittings should be oiled daily with a good
grade of lubricating ail.

1
2
3
4
5
6
7
8
9
10
12
14
15
16
17
18
17
17
19
11
20
21
16
23
25
25
26
26
27
28
29
30
30
30
31
31
32
32
33
33
34
34
34
34
34
34
35
35
36
37
28
38
40
40
40
36
40
39
39
39
39
39
39
41
41
41
39
34
42
42
42
42
44
45
45
45
46
47
20
20
20
11
11
12
12
12
48
19
ARM PIN ORIENTATION
43
15
39
32
34
18
19
VELT TENSION SPRING MOUNTING
42
40
36
41
33
16
48
37
1
IDLER PULLEY MOUNTING
34
18
41
40
33
1
MOWER DECK SERVICE PARTS