Two Brothers Racing R1-FE User Manual

2009 Yamaha

R1

Fen de r El im in ato r Ki t
Par t # 01 3-23 8

V.A.L.E.

V A R I A B L E A X I S L O C K I N G E X H A U S T

1. Remove passenger seat.

2. Locate fender wires and un-plug from main harness.

3. Remove the 3 bolts securing the OEM fender to
motorcycle.

4. Remove fender assembly.

TM

5. Cut OEM wires on fender assembly back 6” (inches) from
plugs.

6. Attach gray plug to left side turn signal using the supplied
buttsplace connector.

Installation Instructions

WIRING DIAGRAM

Wiring Harness

Parts List

Qty. Description Part Number

1 Fender Bracket 005-23804B
2 Lighted License Plate Bolt 005-8504LTZ
1 Turn Signals (set of 2) 005-88T2
6 Butt Splice Connectors 005-BS1614
2 Zip Tie 005-ZT458B
2 Zip Tie Tab 005-ZTM4
3 6mm Flange Nut 005-FN6
1 TBR Sticker Kit 015-10212

IMPORTANT - PLEASE READ CAREFULLY

We recommend that this performance part be installed by a qualied motorcycle

technician. If you have any doubts as to your ability to install this performance

part, please consult with your local motorcycle dealer. Read all instructions rst

before starting installation. Make sure the motorcycle and exhaust system are
completely cool before starting the installation. Also, make sure the bike is secure
on a centerstand or ideally a service lift during installation. Be sure to save all stock
components for possible use later.

7. Attach black plug to right side.

8. Attach the 2 bullet connectors to the plate light bolts.
Black goes to black.
Red goes to blue/red.

9. Attach turn signals and plate lights to TBR fender and
attach using the OEM bolts and supplied 6mm flange nuts
to motorcycle.

10. Route wires through center hole and plug into main
harness.

11. Use zip-tie tabs and zip-ties to keep wires away from
exhaust.

12. Double check all your work.

13. Re-install passenger seat.

14. Before you run the bike, clean off all fingerprints and
dirt, as any oily residue will etch the metal and become
somewhat permanent when the system gets hot. Also,
remove any plastic film from the name badge(s) and or
canister clamp(s). Run the bike and enjoy. It is normal
for some white smoke to appear the first time you start
the bike. This is packing/manufacturing oil from inside
the pipe burning off. Check for gaps or leaks. If you find a
leak, a little high temperature silicon sealant should fix it.
After 50 to 100 miles, recheck all fasteners for tightness.

Left Turn Signal

(Grey connector)

Black

Right Turn Signal

(Black connector)

Blue/Red

Black

Plate Lights

Red

Black

Red

Warranty

Two Broth ers Racing products are inten ded for c losed cour se competi tion purp oses only, and theref ore are s old “as i s”
without warranty. Two Bro thers Racing specificall y disclaims any warranti es of merchan tability or fitness for a particular
purpose and disclaims all re sponsibilit y for consequent ial and incident al damag es or any oth er losse s arisin g from the
use of these produ cts or part s.