
2009-2010 Yamaha FZ6R
PARTS LIST
Installation Instructions
1 Juice Box Pro™
1 USB Cable
1 Top Tune CD-ROM
1 Installation Guide
2 Velcro strip
1 Alcohol swab
THE IGNITION MUST BE TURNED
OFF BEFORE INSTALLATION!
DOWNLOAD THE TOPTUNE SOFTWARE
AND LATEST MAPS FROM OUR
WEBSITE:
www.twobros.com
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
401 S. Grand Ave. Santa Ana, CA 92705
(800) 211-2767 www.twobros.com
ITBR001-257 www.twobros.com 2009-2010 Yamaha FZ6R - 1

Selecting the Map Position
The J uice Box Pro co mes loaded w ith up to ten m aps. U s ing a #1 Phillips
screwdriver, turn the map select dial to toggle be tween the loade d m aps. R efer to
the map position table below for the maps included in your Juice B ox Pro.
Using the RPM Range Dials
The Low, Mid, and High RPM Dials refer to the RPM range, in thirds, of your
vehicle. Each dial allows +/- 10% fuel adjustment on top of what fuel changes are
done in the map. With the dial facing straight up, there is no additional fuel change.
For example, if your vehicle revs to 15,000 RPM:
• the low RPM dial will adjust 0-5000 R PM
• the mid RPM dial will adjust 5001-10000 RPM
• the high RPM dial will adjust 10001-15000 RPM
Using Top Tune
Take y ou r tuning to the next level w ith the Top Tune softw are.
Position 0 Zero map
Position 1 Stock exhaust
Stock air fi lter
Position 2 Two Brothers full exhaust
Stock air fi lter
USB Port
High RPM Dial
Mid Dial RPM
Low Dial RPM
Map Select
Status Light
(Power to Unit)
2009-2010
Yamaha FZ6R
2009-2010
Yamaha FZ6R
I ns t a l li n g t h e Top Tu ne S o ft w a r e
1 Insert the CD provided into your computer’s cd-rom drive. The launch program
will run automatically.
If auto-run is disabled, double-click the My Computer icon then double-click the
CD drive icon. Double-click TB R Top Tune.exe to manually start the CD.
2 Click Install S oftware and follow the on-screen instructions to install the Top
Tune software. The Top Tune software and maps will be stored in C:\Program
Files\T BR Top Tune.
3 C lick M ap Databas e. All m aps will a uto matically be ins talled to the C:\Pr ogram
Files\TBR Top Tune\maps folder.
Loading Additional Maps
1 Connect the US B cable from the computer to the Juice Box Pro. Verify the cable
is fully seated in the J uice B ox Pro.
2 Run the Top Tune s oftware by double-clicking the program icon ins talled on your
desktop or on your start menu.
3 Click Open Map File and select a map file.
4 C lick Send M ap. You can send the map to any of the ten m ap positions.
A ltering M aps Us ing Top Tune
The values in the map represent a percentage of fuel change over stock. A value of
10 in the map indicates at that throttle position a nd RPM range the v ehicle w ill be
10% richer than stock. If the value is -10, then it would be 10% leaner than stock. You
ha ve the ability to fine tune y our fuel curve by altering these values . The To p Tu ne
software allows a value of +250 to -100 in each cell.
ITBR001-257 www.twobros.com 2009-2010 Yamaha FZ6R - 2

Figure A Figure BFigure C
1. Remove the seat.
2. Prop the front of the fuel tank up.
Figure A is shown with the fuel tank removed which is not necessary.
3. Using the supplied velcro, secure the Juice Box Pro underneath the inner fairing
panel as shown in Figure A.
Make sure to clean both surfaces with the alcohol swab before attaching.
Juice Box Pro
harness
4. Route the Juice Box Pro wiring harness down the left side of the air box and go
towards the throttle bodies as shown in Figure B.
Juice Box Pro
harness
5. Unplug the stock wiring harness from the throttle bodies as shown in Figure C.
One connector is a white 4-pin and the other is a clear 6-pin.
unplug
unplug
ITBR001-257 www.twobros.com 2009-2010 Yamaha FZ6R - 3

Figure DFigure E
ground wire
6. Attach the connectors from the Juice Box Pro to the stock wiring harness as
shown in Figure D.
7. Attach the ground wire from the Juice Box Pro to the negative side of the battery
as shown in Figure E.
8. Bolt the fuel tank back into place.
9. Reinstall the seat.
ITBR001-257 www.twobros.com 2009-2010 Yamaha FZ6R - 4