Turbo Air TGM-22RVB Installation Manual

Turbo Air Speeds up the Pace of Innovation

Glass Door
Merchandiser
Installation and Operation Manual

Please read this manual completely before attempting to install or operate this equipment

FEATURE CHART

TGM-22RV

ADVERTISINC

PANEL

SHELF

ADJUSTABLE

FOOT

BOTTOM

GRILL

DOOR

ASSEMBLY

BALLAST

FLUORESCENT

LAMP

HINGE*TOP

FLUORESCENT

LAMP (32W)

HANDLE

HINGE*UNDER

CONDENSER

EVAPORATOR

FAN MOTOR

CONDENSER
FAN BLADE

EVAPORATOR
FAN BLADE

EVAPORATOR

DRAIN CAP

DRAIN HOSE

SUCTION PIPE
COVER

COMPRESSOR

DRAIN PAN

CONDENSER
FAN MOTOR

EDISTNORF

www.turboairinc.com

HOW TO INSTALL

In good ventilation.

• Place the refrigerator in
good ventilation for a good
operation.

Install the refrigerator at

indoor not to get wet from
the rain.

• This unit is designed for
indoor usage only.

Place the refrigerator on

hard and level floor.

• Unlevel floor may cause the
refrigerator to make noise.

Avoid places that are

exposed to smoke.

• The discoloring can occur to
the refrigerator.

Put away heat source from

the refrigerator.

• High ambient temperature
will make cooling efficiency
lower.

Place the refrigerator in an

area with low moisture.

• Splashing water or a high
moisture area may cause
short circuit and make
rusting easier.

Install the refrigerator on

the places with 41~95°F.

• The stored materials could
be frozen or broken at the
degree below 41°F and
cooling efficiency could be
lower at the degree over
95°F.

Install
at the degree
of 41~95°F

Set the front of the

refrigerator a little bit
higher than back-side by
using adjustable feet to
drain the water away
easily.

Set the front
side higher than
back side.

2

Ajust the temperature in

the refrigerator.

• Temperature control is
located on top right side.
Set knob to normal position.

COOL

OFF

NORMAL

COLD

INSTALLATION OF CASTER AND CASTER BRAKE

1) Screw the caster (in rear side) and the caster brakes (in front side) by using caster wrench.

2) Use the caster shims to level the cabinet, if necessary, by inserting them to stems of the casters.

ROTATION

CASTER SHIM(4EA)

CASTER(2EA)

CASTER (WITH BRAKE)(2EA)

Model : TGM-22RV

3