Turbo Air TACM-48 Installation Manual

OWNER & OPERATOR
INSTRUCTION MANUAL

For service contact:

German Knife Inc.

1-800-500-3519

www.turboairinc.com

Model No. TACM-24

TACM-36

TASM-24
TASM-36

TACM-48

IMPORTANT SAFETY NOTICE

THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT WHO SHOULD
PERFORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL.
POST IN A PROMINENT LOCATION: THE INSTRUCTIONS ARE TO BE FOLLOWED IN THE EVENT WHEN SMELL
OF GAS IS DETECTED. THIS INFORMATION CAN BE OBTAINED FROM THE LOCAL GAS SUPPLIER.

IMPORTANT

In the event a gas odor is detected, shut down units at main shuto valve and contact the local gas company or gas supplier for service.

FOR YOUR SAFETY

Do not store or use gasoline or other ammable vapors or liquids in the vicinity of this or other appliance.

WARNING

Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury, or death. Read the installation,
operating and maintenance instructions thoroughly before installing or servicing this equipment.

www.turboairinc.com

TABLE OF CONTENTS

PAGE

INSTALLATION

OPERATING INSTRUCTIONS

MAINTENANCE

WARRANTY

3-4

5-6

7

8

German Knife, Inc.

4184 E. Conant St., Long Beach, CA 90808

Phone: [phone]

Fax: [phone]

www.turboairinc.com

SHIPPING DAMAGE CLAIM PROCEDURE

The equipment is inspected & crated carefully by skilled personnel before leaving factory. The transportation company
assumes full responsibility for safe delivery upon acceptance of this equipment if shipment arrives damaged;

1. VISIBLE LOSS OR DAMAGE: Note on freight bill or express delivery and signed by person making delivery.

2. FILE CLAIM FOR DAMAGES IMMEDIATELY: regardless of extent of damages.

3. CONCEALED LOSS OR DAMAGES: If damages are noticed after unpacking, notify Transportation Company
immediately and file “Concealed Damage” claim with them. This should be done within fifteen (15) days from date
delivery is made to you. Return container for inspection.

2

INSTALLATION

A

UNPACKING:

1. Remove appliance from container.

2. Remove all protective packaging material.

3. Retain container and packaging material until the appliance is operated and found
in good condition.

4. Check appliance for any shipping damage. If appliance shows any external or internal
damages, promptly inform dealer/distributor where you bought your appliance.

NOTE: Installation and repair should be done by a qualified service person. Qualified service person

should read these instructions and should be familiar with the operation and functions of the equipment.

GENERAL SAFETY INSTRUCTIONS:

ccidents are always tragic especially because so many of them could have been prevented with
little care and judgment. There are some basic good practices; we hope you will follow for safe
use of the equipment as well as your well-being.

IMPORTANT SAFETY INFORMATION:

● Always maintain proper clearances from combustible materials.

● Ventilation air supply must be maintained at all times when the equipment is operating.

● Never connect equipment to an unregulated gas supply.

● Gas supply connections should be checked utilizing soap solution. Never use a flame

for gas leak checks.

● Service and repair should be done by a qualified service person. Do not service while

hot or operating.

3